搜索资源列表
arm_fft
- 基于ARM汇编优化过的FFT算法，采用AAN FFT算法，性能最高的FFT算法-ARM assembler optimized based on FFT algorithm, using AAN FFT algorithm
PID
- 数字PID调节器算法,执行时间最短最精炼-digital pid
fankuijicunqi
- 本代码源自简单的反馈寄存器算法，可实现四位反馈移位的运算，通过简单的修改，可以得到多位！-This code is derived from the simple feedback register algorithm can achieve the four feedback shift the operation, through simple modifications, you can get a number!
vibrate_pwm_project
- 该代码工程是正弦式传感器的测频程序，是在MSP430上使用的。该扫频算法具有较好的参考价值。推荐下载，学习-failed to translate
IDG300
- IDG300源程序，主要实现姿态实现算法和温度补偿及校准-Gyroscope algorithm
3D
- 在arm9实现的图形学3D实验算法，代码稍加修改即可应用于其他处理器-Arm9 3D graphics in the experimental realization of the algorithm, the code slightly modified to apply to other processors
Mega32L
- “HG• PSAP4”伺服放大器，采用8位微处理器和12位AD为核心器件的电子比例式伺服电路，结合先进的软件控制算法，将执行机构当前位置的反馈信号与4～20mA电流输入信号进行动态比较，据此操控执行机构动作，使其最终位置输出值满足与输入信号一致的要求。“HG• PSAP4” 伺服放大器采用先进的SMT工艺技术，具有结构紧凑、控制精度高、响应速度快、可靠性高等特点，适用于德国PS系列和绝大部分国产电动执行机构。-" HG • PSAP4" serv
LOGMAP
- 为了在数字芯片上实现TURBO码译码时，降低硬件实现代价，提高运算速度，针对LOGMAP算法，研究了turbo码的译码过程中接收信号、路径度量值，对数似然比的量化方法，并分析了量化方法对译码性能的影响。-In order to achieve in the digital TURBO decoding chip, the lower hardware costs, improve processing speed, for LOGMAP algorithm to study the proces
MP3-software
- 基于ARM SOC的多媒体音频算法软件优化及系统设计-In this thesis，the research and development ofa real-time high performance high precision MP3 software decoder for SOC with ARM7TDMI as core processor is presented．黜decoder c∞widely used in handheld devices such∞pocket
ARMVOICE
- 本文提出了一种基于ARM处理 器的孤立词语音识别系统的设计方案, 包括系统硬件设计、软件设计和算法实现,-This paper presents a ARM processor-based isolated word speech recognition system design, including hardware design, software design and algorithms,
source
- 利用kalman算法计算运动物体的姿态角-Algorithm using kalman attitude angles of moving objects
willessblood
- 用C8051 + 无线做的无线护士站资料（SI100）,血压测量算法，曲线拟合-To do with the C8051+ wireless data wireless nurses station (SI100), blood pressure measurement method, curve fitting
stm32P2DPSK
- 基于stm32微处理器，通过12个IO口接收FPGA发来的2DPSK数字信号，经过一定的算法，解调出2DPSK信号，得到原始的基带信号。-Microprocessor-based stm32 through IO port 12 to receive the 2DPSK FPGA digital signal sent through a certain algorithm, the signal demodulation 2DPSK get the original baseband sign
CRC
- 这是在Keil中编写的C程序，实现了通信协议中的CRC32与CRC16校验，采用驱动表法，算法精炼，程序简洁。-This is written in the C program in Keil, the communications protocol to achieve the CRC32 and CRC16 checksum, using table-driven method, algorithm refined, simple procedures.
mpt612
- mpt612，NXP公司出来的最新的关于太阳能采集的芯片，里面集成了专用算法-mpt612, NXP' s out of the latest solar energy collected on the chip, which integrates a dedicated algorithm
caibu
- 基于armlinux下的电机直线插补，圆弧插补算法。-Under the motor based on armlinux linear interpolation, circular interpolation algorithm.
PID
- RP5小车运行方式——PID算法介绍，直行、转弯。-RP5 car operation mode- PID algorithm is introduced, straight, turn.
mohu
- 模糊pid算法，基于单片机的控制系统可以使用，调节幅度小时可以稳定，较大时不易稳定-Fuzzy pid algorithm, based on single-chip control system can be used to regulate the rate of hours can be stable, easy to stabilize large
DFT
- DFT算法很简单实用的小程序 包括功率计算，阻抗计算，容抗计算-Electrical calculation tool used: including the power calculation, impedance calculations, capacitance calculation, calculate the inductance by inductive and so demand
crc
- 多种CRC算法，包含8位，16位等算法。-A variety of CRC algorithms, including 8-bit, 16-bit algorithm。