搜索资源列表
IR_Remote_Control_winamp
- 单片机端接受红外遥控并通过串口发送至电脑端程序，电脑端程序获得数据后控制Winamp的上一首、下一首、音量大小等。串口使用4800波特率，8字节，一位停止位，无校验，单片机使用12Mhz晶振，VB6.0，win7 32bit下测试通过。-Receiving infrared remote control MCU side and sent to the PC via the serial port procedures, computer terminal procedure for obtai
chuankoujieshou1602
- 利用c语言实现单片机的串口通信，并在1602液晶上显示的功能-Use c language to achieve single-chip serial communication, and in 1602 the functions displayed on the LCD
pulse-jiance-cheng-xu
- 本程序利用MSP430单片机的定时/比较功能检测输入脉冲的频率，并给出相应的I/O口输出量-This procedure using MSP430 single chip timer/comparison function detecting the frequency of the input pulse, and gives the corresponding I/O port output
pingxian
- 单片机读取三通道传感器的值，并通过串口以全双工的方式发送到上位机。代码经过测量。-Microcontroller reads the three-channel sensor values, and through the serial port in full-duplex mode is sent to the host computer. Code is measured.
5.watchdog
- C8051F320单片机看门狗程序，当接P0.0口的按键按下超过约524ms时，看门狗就会复位，并点亮全部的led灯（上电复位后led1已点亮）。-C8051F320 microcontroller watchdog program, when connected to P0.0 mouth more than about 524ms when the button is pressed, the watchdog will be reset, and all lit led lights (p
ADC1
- c8051f320单片机ADC程序，该实验通过AD转化，并把转化结果通过串口发送到pc机显示。-c8051f320 microcontroller ADC program, the experiment through the AD conversion, the conversion result and sent through the serial port to pc machine display.
wenducaijijiemian
- 用Visual C++6.0编写的串口通信程序。这个通信界面可以灵活设置串口的参数，按照特定的通信协议，单片机把通信数据上传到上位机，并在上位机处理，用图形显示出来，从而实现上位机和下位机的通信。这一系统已经在“基于51单片机的温度采集系统”稳定可靠使用。-Using Visual C++6.0 prepared by the serial communication program. The communication interface can be flexibly set the ser
temp
- C8051F120单片机利用片内温度传感器测量室内温度并显示在广州大彩串口屏上-C8051F120 single-chip-chip temperature sensor to measure the room temperature and displayed in Guangzhou color serial screen
little-car-send
- 小车采用STC12C5A16S2（主单片机）可以实现测量前方障碍物的距离，并实时发送给从单片机STC89C52，之后从单片机通过串口发送给电脑，此文件为发射端程序 -Car used STC12C5A16S2 (main MCU) can measure the distance between the front of the obstacle, and real-time to the slave microcontroller STC89C52, then sent from the mi
littlecar-receive
- 小车采用STC12C5A16S2（主单片机）可以实现测量前方障碍物的距离，并实时发送给从单片机STC89C52，之后从单片机通过串口发送给电脑，此文件为接收端程序-Car used STC12C5A16S2 (main MCU) can measure the distance between the front of the obstacle, and real-time to the slave microcontroller STC89C52, then sent from the mic
RS232-parity
- 串口校验程序 接收串口数据 并校验 应用于51单片机-RS232 parity
ch451
- ch451芯片的驱动程序，并附有一个详细的例子，ch451的一个键盘扫描显示芯片，最多支持64个键盘，但只占用4个单片机口-ch451 driver chip, together with a detailed example, ch451 of a keyboard scan display chip, supports up to 64 keyboards, but it only takes four microcontroller port
PID-temperature-control-based-on-51
- 用51单片机实现电阻炉的水温控制系统，将温度稳定到设定的温度，并每隔五秒将实时温度值通过串口发送给电脑（外围器件为光+可控硅）-MCU with 51 resistance furnace temperature control system, the temperature was stabilized to the set temperature and real temperature value every five seconds will send to the computer t
814xappprogramV1.0
- 文件说明 1. 该函数包仅用于GM814x的操作，包含了对该芯片的配置寄存器读写、数据收发、软件shutdown、 软件wakeup操作，以及对接收数据的分析处理。 2. 该函数包中部分变量名和宏定义需与外部主程序一致，具体请参见源文件。 3. 该函数包中调用的三个函数ClrCS（)，SetCS()，SPITransmit(unsigned char c)需要 用户根据所用的单片机系统编写相应源代码，并注意函数名的统一。 4. 该函数包中串口号变量N由0～3分别表示串
VB_C52_StpMotor
- 通过串口实现VB程序和单片机的通讯，并实时控制步进电机的转速和方向。-VB program through the serial port and single-chip communication, and real-time control of the stepper motor speed and direction.
key
- 该程序实现独立按键去控制 LED灯 的亮灭，并讲叙了对按键的处理方法。 独立按键相应的IO口平时为高电平，一旦按键按下，单片机便检测到低电平。-The program implements the independent button to control the LED lights off, and spoke of the right key approach. Independent buttons corresponding IO port usually is high, once
51Simulation-IC-after-the-bus
- 最近用到测量光线的模块BH1750FVI时需要用到IIC总线操作, 用51的IO口, 模拟出了总线时序, 并能正确操纵需要用IIC总线访问地一系列模块. 给出一个范例程序, 它能在我的51单片机机系统上工作得很好. -Recently used to measure light module BH1750FVI when needed IIC bus operation, with 51 IO ports, analog out of the bus timing, and can correc
bluetooth_uart_1_0_4
- 这是一款通过手机蓝牙，进行蓝牙串口通信的软件，可以传输串口数据给单片机系统、全站仪等使用 RS232 接口的设备。软件功能：1、搜索蓝牙设备，并显示蓝牙设备的名称和 MAC 地址；2、接收与发送数据；3、可设置 Hex 显示、Hex 发送、发送新行。-This is a Bluetooth mobile phone, for Bluetooth serial communication software that can transmit serial data to the microcont
23.PCF8591-AD
- stc12c5a60s2 单片机实现fcf 8591 AD 转换并送入计算机串口的程序通过串口助手即可读取！-stc12c5a60s2 MCU fcf 8591 AD converted and sent to the computer through the serial port of the program assistant to read!
RS232
- 利用51单片机中断方式接收PC机上通过串口调试程序发送的英文字符并应答相同的字符-Use SCM interrupt receive the PC through serial debugger send English characters and answer the same character