搜索资源列表
produce-katanami-of-200mS
- 基于51单片机的编程，产生200ms方波，利用示波器可以观察到方波的产生，如果接LED灯，可以看到灯的亮息变化-Based on 51 single-chip programming, resulting in 200ms square wave, the oscilloscope can be observed using a square wave generation, if then LED lights, you can see the bright lights change int
ad9833
- 单片机控制AD9833，实现方波、三角波、正弦波等-MCU control the AD9833 to get zhengxianbo etc
xinhaofashengqi
- 通过单片机控制输出的脉冲，实现输出正弦波、方波、三角波和锯齿波-Output pulse by SCM to achieve the output sine wave, square wave, triangle wave and sawtooth
hanshufashengqi
- 基于51单片机的函数发生器,可以产生10~10K的三角波,正弦波,方波三种波形,实现用键控调节频率.-Based on the 51 SCM function generator can generate 10 ~ 10 K triangle wave, sine wave, square wave three waveform, realize with keying regulation frequency.
wave
- 单片机 产生三种波形 正弦波 三角波 方波 按键可以切换-Microcontroller generates three sine wave square wave triangle button to switch
signal-generator
- 单片机 正弦波三角波 方波程序 以用示波器观看 效果很好-SCM sine wave square wave triangle program to see good results with an oscilloscope
DAC0832
- DAC0832，将数字信号转为模拟信号，本程序通过DAC0832可用按键控制单片机产生正弦波，方波，三角波，锯齿波-DAC0832, the digital signals to analog signals, the key control procedures used by DAC0832 chip generated sine wave, square wave, triangle wave, sawtooth
0832_84
- 基于单片机的函数信号发生器，c语言编程，可产生幅度，频率可变的正弦波，方波，三角波，锯齿波-Microcontroller-based function generator, c programming language, can produce amplitude, variable frequency sine wave, square wave, triangle wave, sawtooth
PWM_xinhaofashengqi
- 基于飞思卡尔单片机，使用PWM模块输出1khz的方波-Based on Freescale' s microcontroller, using the PWM module output square wave 1khz
fenpin
- 利用单片机的计数器来制作简易分频计，因为P1^0用来模拟外界波形输入，它提供周期为100ms的方波。与T1管脚相连后，T1可对其进行周期计数。 程序中的变量TL1决定着分频系数，其值乘以2即为分频系数。 改变其值可以得到相应的分频输出波形（方波）。 P1^1为输出管脚，将其连接示波器可以看到分频后的波形。-To make use of simple single-chip counter frequency meter, because P1 ^ 0 input waveforms
89c5-2
- 用at89c2051单片机产生15HZ~~~50KHZ的方波，并且实现频率和脉宽的独立调制。-Microcontroller with at89c2051 produce 15HZ ~ ~ ~ 50KHZ square wave, and independent of frequency and pulse width modulation.
Text1
- 用单片机产生频率，占空比可调的方波，这是C语言的原代码。-Produced with single-chip frequency, variable duty cycle square wave, which is the C language source code.
chansheng1msfangbo
- 产生1m方波,VC编程。单片机C52实现。-failed to translate
chengxu
- 单片机 采样 峰峰值 频率测量 可以测量方波正弦波 三角波的频率-Chip sampling frequency measurement can be measured peak to peak sine wave square wave triangle wave frequency
20HzOut
- 用凌阳61单片机，20K方波输出的程序-20k PWM by SPACE61
1
- 在80C51单片机中，已知时钟频率为6MHz，请编程使P1. 0和P1. 1分别输出周期为2S和0. 5S的方波-In the 80C51 microcontroller, the clock frequency is known to 6MHz, please programmed to P1.0 and P1.1 outputs, respectively, for the 2S and 0.5S cycle square wave
fangbo
- 用C语言实现的，在C51单片机上发生方波的程序-With the C language, and in C51 single square wave occurred on the program
fangbo
- keil一个定时器产生带有死区的方波。使用stc52单片机。-keil timer generates a square wave with a dead zone. Use stc52 microcontroller.
51_test-frequency
- 首先要把51hei单片机开发板上的ne555的方波输出信号J7的第一脚用杜邦线,引入P3.2口,数码管即可显示ne555震荡电路当前的频率值,旋动PR1电位器可发现数字有变化. 原理：1秒钟内计数外部脉冲个数，如计数1000次，则表示频率为1000Hz -First, we should 51hei microcontroller development board ne555 square wave output signal with the first pin of J7 DuPo
dds
- 51单片机实现简易函数信号发生器功能（正弦波、方波、三角波）-51MCU，sin ，pluse，and so on