搜索资源列表
led
- 51教学程序之led灯闪烁，答滴答滴嗒嘀嗒-51 teaching program of led lights flashing, A tick tock tick
experiment-of-LED-flashing
- 在Keil4.0环境下，用c语言编程实现LED灯闪烁实验-In Keil4.0 environment, using c language programming LED flashes experiment
led
- 51单片机led灯闪烁,keil界面操作，单片机入门-51 microcontroller LED lights flashing, Keil interface operation, SCM entry
one-led
- stm32 单个LED灯闪烁，可任意修改程序-stm32 one LED
zigbee-cc2530-led---and-hex
- cc2530 led灯闪烁，完全测试可用，建好工程设置好，编译出hex-cc2530 led lights flashing, complete test is available, and set up the project set up, compile hex
wangfan-LED
- 这是一款适用于51单片机的LED灯闪烁程序（往返跑马灯）-This is a suitable 51 single LED flashing program (roundtrip marquees)
led
- 基于arm的led部分程序,实现led灯闪烁 等功能-arm s led
led
- led灯闪烁他可以很快的使用中断系统时钟，来控制LED灯的山灭，此功能还能够控制数码管的显示数字-led lampe blink
gpio
- 基于DSP2812，使用GPIO的引脚来控制LED灯闪烁。即控制XF引脚高低电平不断变化。(Based on the DSP2812, the GPIO pin is used to control the LED flashes. The XF pin is constantly changing between high and low levels.)
LED_blinking
- LED灯闪烁程序 提供修改和测试软件接口(LED blinking: --USER --SYSTEM --OBJECTS)
实验4：系统时钟
- 自定义RCC系统时钟，通过改变其倍频与分频实现延时时间变化，实现LED灯闪烁效果。(Customize the RCC system clock, by changing its multiplier and frequency to achieve delay time changes, to achieve LED light flashing effect.)
LED_PC13
- 控制PC13口的LED灯闪烁,可以用来测试STM32模板是否能使用。(The LED light that is controled by the PC13 port flashes)
LED发光管
- 430LED流水灯应用程序，实现8个led灯流水闪烁。(430LED water lamp application, to realize 8 led light running water flashing.)
LEDshanshuo
- LED灯闪烁的15c程序 开发板历程 测试程序(LED lights flashing 15C program Test program)
5-野火M3-流水灯
- 基本的stm32入门程序，控制led灯的闪烁与熄灭(Basic STM32 entry procedures, control LED lights flashing and extinguished)
LED
- LED灯闪烁，51单片机开发板控制，实现IO口基本功能(LED lights flashing, 51 microcontroller development board control, to achieve the basic functions of IO port.)
LED
- 使stm32单片机的LED灯按递增方式交替闪烁(STM32 microcontroller LED lights flashing alternately in increments)
1 LED闪烁实验
- LED闪烁实验，单片机控制 LED灯开关，实现闪烁的功能(LED flashing experiment, SCM control LED light switch, realize flashing function)
LED
- 随机点亮单片机两个不同位置的LED灯，并且切换位置闪烁，间隔约一秒(Light up singlechip LED lamp)
led
- 利用计数器设计延时函数，通过四个led灯的闪烁，可以直观观察延时时长，fpga器件cyclone iv LCMXO2-1200HC-4TG144CR1,在demo板上作简路图(Using the counter to design the delay function, through the flashing of four LED lights, we can observe the delay time directly, FPGA device cyclone IV LCMXO2-12