搜索资源列表
V2I4_IJERTV2IS4962
- Mitigation Of Voltage Sag And Current Harmonic Elimination Using Reference Signal Generation Method Based On UPQC. This paper proposes a reference signal generation method for the UPQC adopted to compensate both current and voltage quality problems
MMC-HVDCResearch
- 特高压直流及柔性直流输电系统换流站绝缘配合研究，基于MMC拓扑电气方面的研究-Research on Insulation Coordination of Converter Station in UHV DC and FDC System Based on MMC Topology
A-Transient-Harmonic-Current-Protection_Scheme-fo
- Based on the boundary characteristic of a dc transmission line, the response of transient harmonic current in the line-commutated converter HVDC transmission system is analyzed under various fault conditions in this paper. A new transient har
3_Design-and-Implementation
- The dc-ac converter, also known as the inverter, converts dc power to ac power at desired output voltage and frequency. The dc power input to the inverter is obtained an existing power supply network or a rotating alternator through a rectifier or
pmsg
- Advanced DSP Control of 3-Level DC/AC Converter for Variable-Speed PMSG
Three_Phase_ACDCAC_PWMconverter
- 三相PWM交流-直流-交流变换器 (380V-680V-380V)-Three-Phase AC-DC-AC PWM converter
nanogrid
- Control Scheme for a Bidirectional Converter in a Self-Sustaining Low-Voltage DC Nanogrid
05636925
- Control of a Doubly-fed Induction Generator with an Indirect Matrix Converter with Changing DC Voltage
0-30V
- 本文设计了一种基于AT89C51单片机为核心控制器的数控直流稳压电源，该电源主要由辅助电源、显示电路、控制电路、数模转换电路、稳压电路和模数转换电路六部分组成。该系统以AT89C51单片机为控制单元，以数模转换芯片DAC0832输出参考电压，以模数转换芯片TLC1534对釆样值进行转换为数字信号。辅助电源提供各个芯片、数码管和放大器所需工作电压，显示电路用于显示电源输出电压的大小，输出电压值可通过按键对其进行步进控制（±0.1V)，并且在按键长时间按下的时候能连续增加或减小。-In this p
PV_grid
- This example shows an average model of a 100-kW array connected to a 25-kV grid via a DC-DC boost converter and a three-phase three-level VSC
myPMSG2_5
- 自己建立的永磁直驱风力发电系统，采用dq解耦控制，spwm调制，机侧控制直流电压，网侧控制最大功率跟踪和无功。(The permanent magnet direct drive wind power generation system has adopted DQ decoupling control, SPWM modulation, machine side converter control DC voltage , network side control maximum power
GTOBUCK
- MATLAB中文论坛Simulink控制系统板块发表的帖子:移相全桥DC/DC变换器仿真报错。 只需一步,快速开始 扫一扫,访问微社区 MATLAB中文论坛(Altar Simulink physics modeling board posted post: isolated two-way full bridge DCDC Resonant Converter... My simulation has been possible, the transformer has some proble
fangzhen
- 隔离型DC-DC变换器降压仿真模型.使用了全桥结构,并移相控制算法实现,适用于大功率及对电气隔离有要求的电压变换系统. [boost.zip] - boost升压电路 matlab调试成功输出曲(Altar Simulink physics modeling board posted post: isolated two-way full bridge DCDC Resonant Converter... My simulation has been possible, the transfor
buck
- buck变换器 降压DC/DC降压斩波电路simulink仿真模型(Converter, buck, DC/DC buck chopper circuit, Simulink, simulation model)
PWM_Control
- Source code for a PWM control of a DC motor using 2 dsPIC boards. Main board has bluetooth control from an Android device and sends data to power board which does the PWM control (Buck converter)
仿真
- 这是一个Buck变换电路的仿真模型，很好的实现了直流降压功能。(This is a Buck converter circuit simulation model, very good realization of the DC step-down function.)
ABB_DSP
- 通过MODBUS总线控制ABB变频器ACS550.，调节直流电机转速(The ABB frequency converter ACS550. is controlled by MODBUS bus, and the speed of DC motor is adjusted)
500KV双极
- 直流输电比起交流输电更适合进行远距离高压输电，基于PSCAD电磁暂态仿真软件构建了交流系统、换流变圧器、换流器、交-直流滤波器、平波电抗器及直流输电线路等的仿真模型，并以此搭建了500kV高压直流输电系统仿真模型，验证了该模型的准确性。(DC transmission is more suitable for long-distance transmission than AC transmission, the electromagnetic transient simulation soft
Boost_Inverter
- boost inverter (DC-AC converter) is simulated in matlab simulink.
101259364VSG21
- Comparative Stability Analysis of Droop Control Approaches in Voltage-Source-Converter-Based DC Microgrids