搜索资源列表
led
- 利用动态扫描和定时器1在数码管上显示 出从765432开始以1/10秒的速度往下递减 直至765398并保持显示此数，与此同时利 用定时器0以500MS速度进行流水灯从上至 下移动，当数码管上数减到停止时，实验 板上流水灯也停止然后全部开始闪烁，3秒 后（用T0定时）流水灯全部关闭、数码管上 显示出"HELLO"，并保持-Dynamic scan and Timer 1 in the digital pipe shows start from 765 432 to 1
C51
- ME500单片机开发系统演示程序 - 控制PC键盘上三个LED灯 有定义键按下，对应的LED灯亮与灭 描述: PS2键盘发送数据到ME500，ME500接收到数据后 再发送数据到PS2键盘，控制PS2键盘上的3个LED亮与灭 P0口的8个LED还可以显示PS2的其它按键编码 -ME500 microcontroller development system demo- control three LED lights on the PC keyboard is defi
led
- this on and off led code for ARM processor.-this is on and off led code for ARM processor.
jiyuC51danpianjidemimasuo
- 实现密码锁的基本功能，在数码管上显示，并通过LED的亮灭表示开/关锁.-To achieve the basic functions of lock in the digital display, and through the LED' s light off that on/off lock.
LPT2LED
- Learn to turning ON/OFF 8 LED from PC by control LPT1 port using VB6. For further development you may use some analog circuit converting low power to high power via OPTO-COUPLER components.
time
- 基于msp430,使用32768hz晶振，定时器控制LED亮灭，亮一分钟，灭一分钟。-Based on msp430, use 32768hz crystal, LED light off timer control, bright one minute, off for a minute.
PROG
- PicBasicPro Simple Program for led on and off in the 16*2alphanumberic LCD write lcd is on or off.It is too simple. :)
01_lpc2148
- First lpc2148 c code on keil uVision, only turn on/off a single led
control-LED-and-digital-tube-display
- 本程序集成中断、定时器、LED灯、数码管显示，可完成每隔100ms数码管显示的数减小1，同时以500ms的速度进行流水灯，当数码管上的数停止，实验板上流水灯也停止然后全部开始闪烁，3s后流水灯全部关闭、数码管上显示 出"8520",然后保持住-This program integrated interrupt, timer, LED lights, digital display, to be completed by every 100ms digital display reduces th
LED-lamp
- 这个程序是在单片机上实现流水灯的代码。运行此代码可以让单片机上的LED灯轮流亮灭。-This program is to achieve water lights in the microcontroller code. This code can run on a single chip LED lamp light turns off.
LED
- this a simple program to turning on and turning off some LEDs with AVR,
main
- /*** *** *** *** *** *** *** *** *** *** *** *** *** * Platform: PIC1687A Project : 实验3：单个按键控制LED闪灭 Clock F : 外部4M Software: PICC Author : comments: 学习使用单个按键控制LED的闪灭 PIC里面只有B口设置了上拉电阻， 用的时候必须用编程打开它，（OPTION=0X7F） 其他端口都须自已连上拉电阻， 一
LED_Flasher
- This code is used to glow the five LEDs in sequence. In this code LEDs do not go off and ON suddenly, while LEDs go off and ON gradually. When one LED goes off gradually next LED goes ON gradually as well.
led_matrix_dened_on_microcontroller
- LED MATRIX display this project contains source code and pdf file to show to you how to interface LED matrix using PIC microcontorller .. how to show your data on it and moving your data from left to right throw led matrix Moving signs are
clock
- 6位LED数码显示，计时单位为1/100秒。利用功能键进行启/停控制。其功能为：上电后计时器清0，当第一次（或奇数次）按下启/停键时开始计数。第2次（或偶数次）按下该键时停止计时，再一次按启/停键时清零后重新开始计时-6 LED digital display, time unit is 1/100 sec. Using the function keys on/off control. Its functions are: power on the timer to 0, when the f
liushuideng-saomiao
- 利用动态扫描和定时器1在数码管上显示 出从765432开始以1/10秒的速度往下递减 直至765398并保持显示此数，与此同时利 用定时器0以500MS速度进行流水灯从上至 下移动，当数码管上数减到停止时，实验 板上流水灯也停止然后全部开始闪烁，3秒 后（用T0定时）流水灯全部关闭、数码管上 显示出"HELLO"。到此保持住。 设晶振频率为12MHz。-The use of dynamic scanning and Timer 1 in the digital d
arm7_led2-protues
- ARM LPC2138(LPC2148)LED ON AND OFF PROGRAM SIMULATED IN -protues I AM USING THE MDK4 KEIL COMPILER
mole-game-rev1.0
- mole game to be implemented by verilog. LED # on corresponds to mole # to get up. LED # off corresponds to moe # to sit down. Game User press down button to turn off LED #. etc. Enjoy all. -mole game to be implemented by verilog. LED #
mini2440LED01
- mini2440 点亮LED的小程序。可以参考内部的代码，如果要测试运行，需要先安装SDK.-with mini2440 to make a led on and off. wish you it may be usefull.
LHW216EH.pdf
- 功率型光电继电器,具5000耐压隔离电压.负边双向导通.-The LHW216EH consists of an AlGaAs infrared light-emitting diode (LED) input stage optically coupled to a high-voltage output detector circuit. The detector consists of a high-speed photovoltaic diode array and driver c