搜索资源列表
SCHEMATIC
- schematic for 16x16 rgb led board interfacing
tubes_bin
- Controll LED 16pixel 144leds RGB Tubes with DM314 Source Code
SETUP
- Controll LED 16pixel 144leds RGB Tubes with DM314 Source Code
README2
- Controll LED 16pixel 144leds RGB Tubes with DM314 Source Code
RGB_attiny25
- RGB for LED with ATTINY25, BASCOM AVR
LedDriver
- 舞台RGB大功率LED控制程序,已成熟应用于产品上,带温度补偿PID算法,支持DMX行业标准协议,内置多可是调场景,LCD菜单,eeprom变量保存-Stage RGB high power LED control procedure, has grown applied to products, with temperature compensation PID algorithm, support DMX industry standard agreement, built-in much
timing
- Video RGB timing搭配FPGA系統及三色LED控制,可以實現色序法(Field sequential display).-Video RGB timing with FPGA and three-color LED control system can achieve color sequential (Field sequential display).
PWM-RGB-IIC-
- 一键控制三色LED颜色变换,带掉电存储功能 当关机时自动存储关机状态,当下次开机时自动从关时机执行程序 -PWM control keys change color three-color LED with a power failure, power failure memory automatically when the state, the boot time from power-down execution when opening
Project_LED_RGB_PWM
- LED RGB PWM C code for AVR
LED
- Image Overlay Step 允许使用者不破坏数据而在一副图像上覆盖其轮廓,文本和位图。 Image Annotation allows 可以将数据保存为图像文件。软件增加了对64位RGB图像的支持。-Vision
RGB-old
- ATmega16单片机控制全彩LED点光源-ATmega16 led
LED-full-color-controller
- LED全彩控制器程序代码,为接收端,与市面上的24键红外RGB遥控器配对使用,由于使用的佑华AM153单片机只配置了1K ROM,所以功能比市面上的略有不足-LED full-color controller code, the receiving end, the market' s 24-key infrared RGB remote control pair, Uwa, AM153 microcontroller only equipped with a 1K ROM, so the
DMX-Pwm-RGB
- AVR DMX controlled output of RGB LED
RGB---san--ji-se-LED-bianse-chengxu
- 本程序用于控制RGB三基色 LED ,使其按红,绿,蓝,紫,黄,青,白顺序渐变 每种颜色的渐变时间为9.3ms. -This procedure is used to control RGB three-color LED to red, green, blue, purple, yellow, green, white sequence gradient For each color of the gradient time of 9.3ms.
AudioSyncRGBLED_P89LPC9xx
- 使用NXP P89LPC936實作音樂同步的RGB LED燈具, 會隨著音頻高低與節奏而改變顏色, 實作: 1.對音頻做AD轉換 2.以整數FFT分析其頻譜 3.根據頻譜輸出控制RGB LED
ZB
- 用C语言编写的基于PIC单片机的LED RGB渐变程序,适合初学者。-PIC microcontroller-based LED RGB gradient program using the C language, suitable for beginners.
OSRAM-RGB
- 用松翰单片机SN8P2501b写的LED彩灯控制程序-The write LED Lantern with, SCM SN8P2501b, Sonix control program
DMX51-receive
- 基于DMX512协议的接收程序,使用STC12C2052单片机,16M晶振,在没有接收到DMX512信号时,3路LED红绿蓝自行渐变,有15种效果,当接上DMX512信号时自行响应。-DMX512 protocol receiver based program that uses STC12C2052 microcontroller, 16M crystal, DMX512 signal is not received, the three-way LED RGB own gradient, t
LED
- 根据TCS230测得三基色LED的RGB值,然后和设定值比较,通过调整PWM来改变各色led的亮度,最终使所测RGB值和设定值相匹配-According to the measured three-color LED TCS230 RGB value and the set value and by adjusting the PWM led brightness to change color, and finally to set the measured value and the RGB
LED_lamp-RGB
- 用NEC的MCU设计的led调光调色控制方案源代码-With NEC' s MCU design led dimming control program source code color