搜索资源列表
proteus7.1-motor-step-OK
- proteus7.1仿真通过，效果非常好，注释说明很详细。一看就懂。-proteus7.1 simu pass,very good results,Note that a very detailed Understand at a glance
AMIS30512-D
- 马达控制，moto的专用芯片，比用CPU要好，简洁-Introduction The AMIS− 30512 is a micro− stepping stepper motor driver for bipolar stepper motors. The chip is connected through I/O pins and a SPI interface with an external microcontroller. It has an onW
BJKZ
- 使用NI-6008控制步进电机（方向，步进数可调）-Using the NI-6008 control stepper motor (direction, step a few adjustable)
Bujin-c-cPP
- 步进电动机 实现708步正转和340步反转-708-step stepper motor for 340 steps forward and reverse
bjdj
- 两相5、6线步进电机，分为四拍和八拍，这里介绍输出八拍方式：A-AC-C-CB-B-BD-D-DA //四拍：A-C-B-D，因此在八拍的基础上减去中间的就可以了，不过步距角要大一倍-Two-phase stepper motor 5,6 lines, divided into four beats and eight shot, and here eight shot output mode: A-AC-C-CB-B-BD-D-DA// four beats: ACBD, so eight
scanning-keypad
- motor stepper full step
BJDJ
- 单片机通过NUL2003驱动步进电机程序. 步进电机: 5伏,500MA/STEP,四限四拍.-MCU through NUL2003 drive stepper motor program. Stepper motor: 5 V, 500MA/STEP, four limit four beats.
NONAME4
- 红外遥控步进电机 能实现加减速 连续正反转 单步正反转 暂停功能-Infrared remote control stepper motor to achieve a continuous forward and reverse single step deceleration suspend function inversion
ghhghgjjhjhj
- 步进电机是将电脉冲信号转变为角位移或线位移的开环控制元件。在非超载的情况下，电机的转速、停止的位置只取决于脉冲信号的频率和脉冲数，而不受负载变化的影响，即给电机加一个脉冲信号，电机则转过一个步距角-Stepper motor is the electric pulse signal into angular displacement or linear displacement of the open-loop control components. In the case of non-ove
yibudianji
- 异步电机的双四步启动过程，用的是c语言，比较简单，适合初学者-Induction motor dual four-step boot process, using c language, relatively simple, suitable for beginners
Step_Motor
- 步进电机步距角为7.5度 K1开启暂停； K2整步； K3半步； K4 1/4步； K5 方向； K6加速； K7减速； -Stepper motor step angle of 7.5 degrees on K1 suspended K2 whole step K3 half step K4 1/4 step K5 direction K6 acceleration K7 deceleration
ac1_example
- AC1 - Six-Step VSI Induction 3HP Motor Drive Demonstration of the AC1 Six-Step VSI Induction Motor Drive during speed regulation.
power_brushlessDCmotor
- Brushless DC Motor Fed by Six-Step Inverter This demonstration illustrates the use of a Six-Step Switch-on mode for a trapezoidal PMSM motor rated 1kW, 3000 rpm and speed regulated.
SPCE061A
- 凌阳61单片机部分功能模块源代码，包括PWM，ADC，LCD，步进电机四步例程等。-Sunplus chip part of the 61 functional modules source code, including PWM, ADC, LCD, stepper motor four-step routines and so on.
StepMotor0
- meg88通过L297L298控制四相步进电机，实现精确转过角度，不失步的升速，测试升速频率可达4KHz-meg88 by L297L298 four-phase stepper motor control, accurate turn angle, without losing step increases the speed, frequency of testing increases the speed of up to 4KHz
eletrical-machine
- 基于DSP的电机包括串口，中断，步进的调试测试程序，调试通过。-DSP-based motor, including serial ports, interrupt, step test program debugging, debugging through.
s
- 内容：三相步进电动机驱动程序 说明：步进脉冲从p3.2管脚输入（低电平有效），转动方向由p3.7管脚控制， 工作运行方式：三相六拍运行方式即 A-AB-B-BC-C-CA-A 输出：A、B、C三相输出分别对应P1.7、P1.6、P1.5 (各相输出为低电平) 片：STC89C52 时钟：11.0592MHZ-Content: Three-phase stepper motor driver Descr iption: Step pulse input from the p3.2
step_motor_360
- uln2003驱动下的步进电机控制，步进角5.6度，程序可转180度-uln2003 driven by the stepper motor control, step angle of 5.6 degrees, the program can turn 180 degrees
bujin
- 驱动4相五线步进电机的8分步,用于调速、正反转、基本的方法。-Drive 4-phase five-wire stepper motor step 8, for speed, rotating, and basic methods.
power_brushlessDCmotor
- A three-phase motor rated 1 kW, 500 Vdc, 3000 rpm is fed by a six step voltage inverter. The inverter is a MOSFET bridge of the SimPowerSystems™ library. A speed regulator is used to control the DC bus voltage. The inverter gates signals are pro