搜索资源列表
Idl-training-materials
- IDL学习入门： 标准数据输入输出和文件读写 快速的直接图形法与图像处理 界面构建与事件传递 自由灵活的对象图形法 envi的功能扩展与二次开发 IDL程序发布部署与汇编 -IDL learning an introduction: Standard data input/output and documents, reading, speaking and writing The direct graphic method with rapid image
COPERATIVE-COMMUNICATIONS
- The channel is modeled by adding the Gaussian noise and Rayleigh Fading. Different combining methods and relaying protocols are studied and compared in this project. We analyzed performance characterizations in terms of The Bit Error Rate and the Thr
YJ-P1203
- 这款是用的是十速单片机PE11E写的用PWM调LED渐渐亮渐渐暗的程序同时驱动继电器-This money is used is the single chip microcomputer PE11E write ten speed of PWM with the light is dark LED gradually program and drive relay
RF-ID-Reader-
- RF-ID感應卡讀卡門禁系統，可紀錄ID卡，符合儲存數據內的，驅動繼電器動作-Proximity card reader access control system, the RF-ID, record ID card, in line with the stored data, the drive relay
Firmware
- This is the program to operate the Xray tube with LCD and Relay as primary switch and TRIAC as secondary switch. Files are associated with peripheral files.
Electrical-control
- 电器控制 用杜邦线把继电器输入端口和P1.1连接起来 按键s1吸合 s2释放继电器 工业上经常用到的。 -The electrical control relay input port and P1.1 connection with the DuPont line keys s1 pull s2 release relay Often used in industry.
liushuidengPfengmingqiPjidianqi
- 单片机与c语言编程设计流水灯，蜂鸣器，继电器，里面有课程+程序代码。-Microcontroller with c language programming, design water lights, buzzer, relay, which of course+ code.
kuangyongyidong
- 本系统以光纤有线网络为骨干，以无线网络为延伸，在井下设立若干无线基站，无线基站之间支持无线链路连接，每台无线基站都具有无线接入和无线转发的功能，组成无线局域网络覆盖井下巷道，使得井下数据在数据终端和各基站之间有秩序的接力转发。这种无线接力转发组网的方式在国内外属前沿技术，在井上已有初步的应用。-The system to fiber optic cable network as the backbone for the extension of wireless networks, severa
bufferPwater-filling
- We consider a OFDM based communication network model with one source, one destination and one relay between them. For the simulation, it is assumed that the destination is out of reach of the source due to distance or obstacles. This means it can onl
one-destination
- all the matlab code of the one destination.An OFDM (orthogonal frequency division multiplexing) scenario is considered where one base station communicates with one mobile station via a single relay station. Power allocation plays an important part in
an144_files
- CodeLockAVR electronic combination lock is realised with Atmel AVR microcontroller AT90S2313. Program in hex code is 2 kB long. User code is consisted of 1 to 4 digits. If the code is entered in the correct sequence, then after 1 second the r
touch-delay-switch
- 智能触摸延时开关源程序 用STC89C52单片机P0口的高阻态输入功能，扫描接口电平。手指将VCC与I\O接口半连接，产生高电平信号。用单片机高低电平控制继电器以达到间接控制节能灯。用单片机的定时器中断定时一段时间。利用人眼视觉暂留现象显示楼层数-Smart touch delay switch source with STC89C52 microcontroller P0 port high-impedance input function, scan interface level. F
ctrlmod
- 串口通信，用串口实现对继电器的控制，用到JMDM-40DIOMR继电器-Serial port communication, with serial realize the relay control，Use JMDM- 40 diomr relay
Lower-computer-program
- 综合程序 此程序包含了开发板板中大部分的功能，配合上位机一起使用 运行前请双击Keillib.exe 排线连接方法：JP8连J12 JP5连JP6 如有继电器和蜂鸣器异常响，请将J2 和J8处短路帽断开 注意：把JP165短路帽 断开 否则会影响 数码管小数点 -The comprehensive program This program contains most of the functionality of th
JDQDriver
- 网络上很多用单片机驱动继电器的图，经过测试不是太复杂，难弄！就是太简单，不稳定。这个图是本人经过测试后的，完全可靠！-Relay drive with microcontroller diagram of the network, after the test is not too complicated, hard to get! Is too unstable. This figure is that I have been tested, and totally reliable!
HomeComControl
- 一个用VBNET编写的继电器控制类，针对RS485标准的1、2、4、8、16口ATmel单片机继电器板均可控制-A written with the vbnet Relay control class, for rs485 1, 2, 4, 8, 16 Atmel MCU relay Board can be controlled
wodematlab
- Distributed Beamforming for Relay Networks Based on Second-Order Statistics of the Channel Statement Information最小发送功率与最大信噪比的代码，结果与论文中相同，总共9个仿真图-Networks Based on Second-Order Statistics of the Channel Statement Information。Minimum transmit power wit
Tung-Pham-PhD
- This thesis mainly concerned with power allocation issues in wireless relay networks where a single or multiple relays assist transmission from a single or multiple sources to a destination.-This thesis is mainly concerned with power allocation i
automatic-mist-system
- 这个是在keil上用C编写的一个程序，是我在学校做的一个创新工程项目，主要功能是实验，检测玻璃跟室内温度，然后通过单片机计算露点温度算出汽车挡风玻璃的起雾温度，进而通过继电器控制汽车空调的开和关。由于程序还不是最完美的，还存在一些不确定因素，例如继电器的控制有延时，露点公式的精确等，其他功能齐全。-This is a program in keil written in C, is an innovative project that I do in school, the main funct
shuangjidianqimonixiyiji
- 用双继电器模拟洗衣机工作原理，对应的继电器接口需用杜邦线连接到uln2003继电器控制端 通过控制2个继电器循环工作状态，模拟洗衣机间歇正反转 一般正转3s，停止2s，然后反转3s，停止2s，循环上述动作-Washing machine works with dual relay analog, the corresponding relay is connected to the interface required DuPont line uln2003 relay contro