搜索资源列表
led
- 基于EasyARM615开发板的用ucos的LED循环点亮程序。-EasyARM615 development board based on the use of LED cycle light ucos procedures.
LED
- P2_0口控制第一位LED灯循环点亮。用到了延时函数。-P2_0 I control cycle of the first lit LED lights. Use the delay function.
led
- 在和众达平台上，基于XV4FPGA开发外围驱动，使得led管循环点亮。-And Jones in the platform, based on the development XV4FPGA external drive, making led tube light cycle.
LED
- 如何使用LED循环点亮-How to use the LED lights cycle
02
- 利用单片机输出循环点亮LED灯D7~D0-Single Chip LED light output cycle using light D7 ~ D0
LED.Control
- 发光二极管控制 利用LP-2900实验仪Altera模块上的PLD器件，以“流水灯”形式点亮A区的L1～L12共12个发光二极管，即使这12个发光二极管周期性地按照1秒的间隔从左向右依次循环点亮。要求用VHDL语言实现。仿真出控制12位发光二极管依次循环点亮的波形。-LED Control
LED-light
- 设MC51单片机的P1口连着八个LED灯，用C语言编程实现使八个灯被循环点亮，并且亮的时间为500ms!（即跑马灯程序，设晶振频率为11.0592MHz）-Set MC51 MCU P1 mouth connecting eight LED lamp, with the C programming language realization that eight light is light and bright cycle time for 500ms! (namely scrolling pr
LED_on_off
- 改程序详细介绍了如何使用TMS320F2812通过GPIO对LED灯进行控制，可以说实现LED亮灭，循环点亮，循环流水灯。-The program introduces how to use TMS320F2812 through GPIO control of LED lights, can say realize kill bright light, LED lamp, circulation water cycle.
led
- 该程序为led跑马灯程序，实现gm8180开发板上4个led循环点亮。-The program is led Marquee procedures to achieve gm8180 development board 4 led light cycle.
t1
- led灯，实现循环点亮led灯，实现霓虹灯的状态显示-led lights, led lights light to achieve circulating, to achieve the state of neon display
led
- led数码管动态扫描控制，循环点亮，可在keil环境下编译-Dynamic scan control led digital tube, cycle light, in keil compiler environment
LED
- 循环点亮P1口对应的8个LED灯，造成循环流水点亮的效果-Cycle corresponds to the P1 port is lit 8 LED lights, the effect of light caused by recirculating
led
- 动态的霓虹灯 在同一时间内8个LED循环点亮并闪烁，使用一个8×8点阵LED显示“生命在于运动”，-led
led
- 本实验完成发光二极管的循环点亮实验，由于输入晶振为20M，分频得到count1信号，故每间隔约1S彩灯循环移位一次。 也可以外接32768hz的晶振经4060分频后的1HZclk输入，自己可以尝试改变实验，加以练习。-In this experiment completed the cycle of light-emitting diode light experiments, as a result of the importation of crystal for the 20M, sub-
led
- 学习PIC16F87xA的初级程序,LED点亮+4LED循环点亮-Base learn for PIC16F87xA,Light LED and 4 LED around light
led-deng
- 51单片机循环点亮8个led小灯，使其不断变化的闪烁-51MCU cycle lights 8 led a small lamp
led
- 用VHDL编程点亮发光二极管，并实现二极管循环点亮的功能 -Light emitting diode, light diode loop using VHDL programming
liushuideng
- 流水灯实验，实现开始灯全亮，然后依次点亮，此后循环点亮led灯。-Light water experiments, the realization began to full bright light, followed by light, then cycle light led lights.
led
- 这是一个基于FPGA的数码管点亮程序，从0到F循环点亮。-This is a based on FPGA digital tube light program, from 0 to F light cycle.
four-LED
- 4个LED灯跑马灯方式循环点亮 方式：先1个灯点亮，再2个灯点亮，3个灯点亮，4个全亮。-Marquee way cycle of four LED lights lit the way: first, a lamp is lit, then two lamp lights, three lights lit four full brightness.