搜索资源列表
photonic_crystal
- 采用平面波展开法模拟2维光子晶体的能带结构,FDTD法模拟2维光子晶体能量传输-used plane wave expansion method for simulation of two-dimensional photonic crystal structure of the band, FDTD simulation of two-dimensional photonic crystal energy transmission
20066299562141412
- 光子晶体反射率透射率计算程序 感觉应该对大家有用，Translight-photonic crystal reflectivity transmission rate calculation procedures should you feel useful, Translight
FDTD123456
- 利用fdtd方法来对缺陷结构的光子晶体进行传输模拟-fdtd approach to the use of the defect structure of photonic crystals transmission simulation
3DFDTD
- 利用matlab计算三维光子晶体带隙的fdtd算法-calculated using Matlab 3D photonic bandgap of the algorithm fdtd
mpb-1.4.2
- MIT开发出来的计算光子晶体的软件，非常好-MIT developed the calculation of photonic crystal software, very good
jiexifa
- 本程序是用matlab仿真软件和解析法来计算光子晶体带隙的-this procedure is used Matlab simulation software and analytical method to calculate the photonic bandgap of
jiexifaqiudaixi
- 本程序是用matlab仿真软件和解析法来计算一维光子晶体带隙的另一个程序-this procedure is used Matlab simulation software and analytical method to calculate one-dimensional photonic bandgap of another program
the_band_structure_of_photonic_crystals
- 用matlab所编用传输矩阵法计算光子晶体的能带结构的程序-prepared by using Matlab using the transfer matrix method photonic crystals with the structure of procedures
photonic_crystal_method_of_characteristic_matrix_1
- 用matlab所编的关于用传输矩阵法计算光子晶体的反射率,文件中将程序写在word文档中,并附带有在matlab下画的图,感觉很有用-using Matlab as in the use of the transfer matrix method photonic crystal reflectivity, Lieutenant General procedures documents written in word document, together with the painting un
method_of_characteristic_matrix_2
- 用传输矩阵法计算光子晶体的透射率,文件中将程序写在word文档中,并附带有在matlab下画的图,程序用matlab编写,感觉很有用,-use of the transfer matrix method photonic crystals transmission rate, which will write the procedures for word documents, Matlab together with the painting under the plans, procedur
one_dimensional_photonic_crystal
- 用传输矩阵法计算光子晶体的透射率随入射光入射角的变化的程序,程序由matlab所编,文件解压后能看到程序写在word文档中,并附带图,感觉很有用-use of the transfer matrix method photonic crystals transmission rate versus incidence angle changes in the procedures, procedures as in Matlab, documents unpacked to see the wo
photonic_crystal_period
- 用matlab编写的关于用传输矩阵法计算一维光子晶体的透射率随周期数变化的程序,感觉非常有用-using Matlab prepared on the use of the transfer matrix method one-dimensional photonic crystal with the transmission cycle Change The procedure, a very useful
photonic_band_structure
- 用传输矩阵法计算一维光子晶体的带结构的程序,用matlab所编,文件解压后,程序写在word文档中,并附有在matlab下画的图,本人感觉非常有用-use of the transfer matrix method one-dimensional photonic crystal with the structure of the program, prepared by Matlab. unpacks the files, procedures written in word document
ocmj12232c
- 串口液晶体 0ocm2x8c的驱动 及 文字 图形显示程序-0ocm2x8c Serial LCD driver and text graphics procedures
TM_fdtd
- 计算光子晶体波导的程序，使用matlab语言编写．-calculation of photonic crystal waveguide, the use of Matlab language.
EM7844724C01
- EM78单片机与24Cxx / 85Cxx 串行CMOS EEPROM接口I2C总线读/写的程序 ** （所有时隙均基于2MHZ晶体震荡器频率）-Tips SCM and 24Cxx / 85Cxx CMOS Serial Interface I2C EEPROM Bus read / write procedures ** (all slots are based on two MHZ frequency Crystal Oscillator)
DSP100wen
- DSP问答 100 问 一、时钟和电源 问：DSP 的电源设计和时钟设计应该特别注意哪些方面？外接晶振选用有源的好还是无源 的好？ 答：时钟一般使用晶体，电源可用 TI 的配套电源。外接晶振用无源的好。 问：TMS320LF2407 的A/D 转换精度保证措施。 答：参考电源和模拟电源要求干净。 问：系统调试时发现纹波太大，主要是哪方面的问题？ ....... 非常详细的100个问答-DSP asked a hundred questions an
interfere_pc
- 理论模拟计算干涉法生成二维及三维光子晶体的结构和各个参数的调节对结果的影响-theoretical simulation interference generated 2D and 3D photonic crystal structures and parameters to adjust the results of
Mur_3DFDTD
- fortran程序计算光子晶体，3D FDTD with 1st Mur boundary conditions-fortran calculated photonic crystal, 3D FDTD with 1st Mur boundary conditions
LP01
- 计算光子晶体的lp01模场分布，和截面场分布彩图-calculation of photonic crystal lp01 mode field distribution, and section distribution maps