搜索资源列表
asm
- 包括开关量输入输出,模拟量的输入输出,显示电路,实现对小键盘的管理,及对6个LED显示块的控制,编制程序实现用数码管显示AD转换值,采样周期为0.5秒,最终系统联调 -Including the amount of input and output switching, analog input and output, display circuit, the management of small keyboard and LED display on the six blocks of
pwm
- LED 灯渐明渐亮控制,基于AT8PS53单片机。-LED lights up slowly becoming light control, based on AT8PS53 microcontroller.
PWM_LED_brightness
- PWM 控制 LED 灯渐亮渐灭程序,利用定时器控制产生占空比可变的 PWM波 按K1,PWM值增加,则占空比减小,LED 灯渐暗。 按K2,PWM值减小,则占空比增加,LED 灯渐亮。 当PWM值增加到最大值或减小到最小值时,蜂鸣器将报警 资源:p0口,8路指示灯。p1.4,p1.5亮度控制按键(端口按键)p3.7小喇叭报警 -PWM control of LED lights getting brighter gradually eliminate programs, usin
DS1820
- DS18B20单总线数字式温度传感器实验,实验连线时QD连P1.0,串并转换实验孔 DIN P3.0, CLK P3.1,LED两位显示,-DS18B20 single-bus digital temperature sensor experiment, experiment QD connection with P1.0, string and convert experimental hole DIN P3.0, CLK P3.1, LED 2 display,
Keyboard(asm)
- 嵌入式系统键盘及LED驱动实验-汇编语言实现,用ADS1.2编辑,嵌入式芯片是ARM3-Keyboard and LED-driven embedded systems test- assembly language implementation, with ADS1.2 editor, embedded chips are ARM300
PA-017232r1
- PIC16C73B MCU RS485 communication with PC,complete terminal LED display
MAIN
- LED走字屏的主板程序。驱动板以及电路板下次传-this is a led asm
IO2ACPL
- 主要功能为通过单片机IO口检测交流过零信号,本程序测量50hz和60hz交流过零信号并通过LED指示-Main function of microcontroller IO port through the exchange of zero-crossing detection signal, this procedure measured 50hz and 60hz AC zero-crossing signals and instructions through the LED
ASM
- PWM方式控制直流电机和PWM方式控制LED亮度实验,用89S52单片机控制。-DC Motor Control PWM mode and PWM mode LED brightness control experiment with 89S52 MCU.
SZ01.ASM
- 利用80C51单片机及数码管显示器设计一个简单电子时钟,由于用LED数码管显示数据,在夜晚或黑暗的场合里也可以使用,具有一定的实用性。-Using 80C51 microcontroller and digital control design of a simple electronic clock display, as with the LED digital display data, at night or dark places where you can use, has a ce
SZ02.ASM
- 利用80C51单片机及数码管显示器设计一个简单电子时钟,由于用LED数码管显示数据,在夜晚或黑暗的场合里也可以使用,具有一定的实用性,通过软件扩展了时钟功能,使之成为带定时闹铃的时钟。 -Using 80C51 microcontroller and digital control design of a simple electronic clock display, as with the LED digital tube display data, at night or dark p
SZ03.ASM
- 利用80C51单片机及数码管显示器设计一个简单电子时钟,由于用LED数码管显示数据,在夜晚或黑暗的场合里也可以使用,具有一定的实用性,通过软件扩展了时钟功能,使之成为带定时闹铃的时钟和倒计时的时钟。-Using 80C51 microcontroller and digital control design of a simple electronic clock display, as with the LED digital display data, at night or dark pl
wenduji
- DS18B20温度计? * 采用4位LED共阳显示器显示测温值,显示精度0.1度,测温范围-55度至+125度 * 用AT89C2051单片机,12MHZ晶振, 内含hex文件-DS18B20 thermometer?* Using four LED display temperature values were Yang, display accuracy of 0.1 degrees, temperature range-55 degrees to+125 degrees*
LCD
- 电子号码锁及led显示 基于8051单片机-Electronic locks and led number display based on 8051
final.asm
- a)实现时钟功能,可以在两个七段数码管上显示秒钟时间或者分钟时间,用一个开关控制两者的切换。 b)实现闹钟功能,时间到播放一段音乐,并在发光二极管上播放走马灯图案,在双色点阵发光二极管上滚动显示自己的学号。能控制滚动显示的速度以及音乐播放的速度,且用一个开关控制闹钟的开关。-a) achieve clock function, can be in two seven-segment digital tube display seconds or minutes, with a switch
Probe01
- SuperProbe - 17 Function! The Superprobe project was designed to see how much could be done with a PIC chip and just a few parts. The image at the right shows the capacitance measuring mode. This device is designed around a PIC16F870, a 4 d
LED
- This is ASM source code (LED Diode lights) for pic16F84A.
wn
- 21位数码管显示万年历at89s52+ds1302+ds18b20-21 LED display calendar at89s52+ ds1302+ ds18b20
164
- 基于164实现串并转换,结合LED七段数码管实现一位计时器-164 series-based implementation and conversion, with seven segment LED digital timer to achieve a
Pro_Button
- Proteus 8051单片机 按钮控制数码管实验-Proteus 8051 MCU button control LED experiment