搜索资源列表
BatteryService
- BatteryService monitors the charging status, and charge level of the device battery.
BatteryService
- BatteryService monitors the charging status, and charge level of the device battery
wuxianchongdianqi
- 本设计是基于手机锂电池来研究无线电能传输的，在传输方式上采用电磁感应式进行电能传输。无线充电系统分为能量发射部分、能量传输部分、能量接收部分，可在一定范围内对智能手机、无线台灯供电。该无线充电器具有感应供电和智能断电等功能，充电状态通过LCD显示提示，可适用于各种不同充电电压和容量的电子产品。-The design is based on a radio phone lithium battery that can be transmitted to study in the transmiss
BatteryService
- BatteryService monitors the charging status, and charge level of the device battery
sn8p2711b
- 松翰单片机2711B用于移动电源充电，程序包括电池的预充电，恒流充电，恒压充电，放电状态的大电流保护，电池低电压保护。无负载自动关机。跑马灯指示灯电量指示程序。-Sonix microcontroller 2711B for mobile power charging, the program includes pre-charge the battery, constant current charging, constant voltage charging, high-current pr
qiansuanxudianchi
- 铅酸蓄电池的三阶动力模型。可以完成充电和放点过程。跑起来有问题的请检查你的解法是不是采用默认的ode45或者步长太大。-The three order dynamic model of lead acid battery. Can complete charge and discharge point process. Running problems please check your solution is not using the default ode45 or step size t
EV_Charge_Diode_20120516
- 电池充电模型的搭建，可以对电池进行充电同时故障时可对负载供电-Built battery charging models, you can charge the battery power to the load while failure can
power_battery
- 电池与一个动态的50A负荷相连，当SOC低于0.4时，启动同步电机转动，给电池充电；当大于0.8时，停止同步电机转动。-The battery is connected to a constant load of 50 Amps. The DC machine is connected in parallel with the load and operates at no load torque. When the State-Of-Charge (SOC) of the battery go
SOC-kalman
- state of charge of battery with ekf
mybattery
- model of battery and estimate sate of charge with ekf
I4_V102
- PIC16F1872做的一款给电池充电的充电器，里面包括了电池的充电曲线计算，C语言-PIC16F1872 do a charger to charge the battery, which includes a battery charging curve, C language
KiBaM
- 蓄电池模型计算，主要实现在KiBaM模型中，在不同的充放电电流下，可用能与束缚能之间的变化。-Battery model calculation, which is realized by the KiBaM model, the change of the energy and the binding energy between the battery and the different charge and discharge current.
dianchijunhengdianlu
- 项目简介 （200字左右） 面对当前严峻的能源危机、环境污染等问题，开发研究电动汽车已成为汽车行业的主流方向，而目前高效稳定的动力电池是电动汽车研究领域的核心问题。因此，本项目研究电动汽车电池管理系统（BMS）的关键技术，探究准确估测电池的荷电状态（SOC）以及锂电池的外围均衡电路的设计方法。本项目将对具体工作模式下的SOC算法进行进一步的研究和归纳，以及进一步的实验认证；本项目还将对电池的过充和过放现象进行具体研究，设计实现电池过充过放状态下切断主电流回路的硬件电路。 -Project
parallel_battery_SC_boost_converter
- 这个例子示出了充放电时的超级电容器的模式。该电路示出了与电池超级电容器的一个简单的杂交。超级电容器被连接到降压/升压转换器和电池连接到升压转换器。电池的功率由一个速率限制器块，因此瞬态功率由超级电容器供给到DC总线限制。-This example shows the supercapacitor model during charge and discharge. The circuit illustrates a simple hybridization of a supercapacit
DSC-CN3767
- 适用于12V铅酸电池，调高充电效率-Lead-acid battery solar charge control chip
SOC
- 安时积分方法估算电动汽车锂电池剩余电量的模型-Integral approach to estimate the remaining charge of the lithium battery electric car model ampere
S3F84K4_BatteryCharger
- 电池充电器参考设计基于锂离子电池，这广泛应用于便携式电子 今天的设备。它还可以收取其他电池如 SLA，镍镉，镍氢电池的变化不大 软件。 电池充电器参考设计使用三星新开发单片机 S3F84K4，是理想的 在广泛的电子应用中使用要求简单的定时器/计数器，PWM，ADC。12 位 PWM 和 10 位模拟到数字转换器中制作最适宜的充电算法可能重要的环节。 特殊功能包括生成在复位电路，减少了使用外部的内部 RC 振荡器 组件。-The battery charger refe
1_Firing_Pulse_Generation
- A MPPT, or maximum power point tracker is an electronic DC to DC converter that optimizes the match between the solar array (PV panels), and the battery bank or utility grid. To put it simply, they convert a higher voltage DC output solar panels (and
BatteryMonitor
- 读取系统电池信息厂商、型号，电量百分比，电量总电量，电压，充放电率，电流，充电状态-Read information system battery manufacturer, model, power percentage, total electricity power, voltage, charge and discharge rate, the current, the charging status
alamgirfiles
- The fuzzy logic control based battery management system has been designed for effective power utilization. The proposed control to operate the battery charging and discharging mode during non-linear power generation. The battery will charge whenever