CDN加速镜像 | 设为首页 | 加入收藏夹
当前位置: 首页 资源下载 源码下载 搜索资源 - control for DC motor

搜索资源列表

  1. Curtain

    0下载:
  2. Curtain Control based on ATMEGA 8 controller. RC5 remove used for open and close of curtain, using dc motor.
  3. 所属分类:Other Embeded program

    • 发布日期:2017-04-24
    • 文件大小:41809
    • 提供者:gopalrao
  1. BLDCBEMF

    0下载:
  2. We propose a position sensorless control scheme for a four-switch, three-phase brushless DC motor drive, based on the zero crossing point detection of phase back-EMF voltages using newly defined error functions (EFs). The commutation instants are
  3. 所属分类:Other systems

    • 发布日期:2017-04-29
    • 文件大小:413347
    • 提供者:ali
  1. speed_control_BLDC

    0下载:
  2. matlab code for Speed Control of Brush-less DC motor
  3. 所属分类:matlab

    • 发布日期:2017-04-29
    • 文件大小:19649
    • 提供者:sswtechnology
  1. pwm

    0下载:
  2. 用于直流无刷电机驱动,输出6路pwm波形 死区时间可控制-For brushless DC motor drive, 6 PWM waveform output dead time control
  3. 所属分类:ARM-PowerPC-ColdFire-MIPS

    • 发布日期:2017-05-13
    • 文件大小:2983023
    • 提供者:周俊辉
  1. PWM

    0下载:
  2. 利用AT89C51单片机实现对2相直流电机的控制,电机控制电路采用H桥来实现,可控制电机实现正转、反转、加速或减速,并用LED进行工作指示-AT89C51 MCU use for two-phase DC motor control, motor control circuit uses an H-bridge to achieve, you can achieve control of the motor forward, reverse, acceleration or decelerati
  3. 所属分类:SCM

    • 发布日期:2017-04-26
    • 文件大小:64941
    • 提供者:duxiaokang
  1. speed_DTC_NoZeroVector140702

    0下载:
  2. 无刷直流电机的能量回馈控制,调制方式为可切换的半桥调制和全桥调制,控制方法为DTC-Energy brushless DC motor feedback control, the modulation scheme for the half-bridge and full-bridge modulation modulation can be switched, the control method for the DTC
  3. 所属分类:matlab

    • 发布日期:2017-04-29
    • 文件大小:22745
    • 提供者:李兵
  1. 61IC_S198

    0下载:
  2. 基于dsp控制的无刷直流电机源代码,可以用于程序设计参考-Dsp-based brushless DC motor control source code can be used for program design reference
  3. 所属分类:ARM-PowerPC-ColdFire-MIPS

    • 发布日期:2017-05-18
    • 文件大小:4791332
    • 提供者:sun
  1. BLDC_tixingwave

    0下载:
  2. 直流无刷电机simulink仿真,可用,供电机控制同学使用,仅供参考-Simulink, the brushless dc motor is available, for the use of motor control students, are for reference only
  3. 所属分类:Embeded-SCM Develop

    • 发布日期:2017-05-01
    • 文件大小:12731
    • 提供者:多多
  1. DC_MOTOR_OL_EVB

    0下载:
  2. a dc motor open loop control program for controlling the motor
  3. 所属分类:DSP program

    • 发布日期:2017-05-01
    • 文件大小:232093
    • 提供者:balamukesh
  1. DSP2812

    0下载:
  2. 本程序为无刷直流电机控制及DSP捕获程序,经测试可靠好用-This procedure for the brushless DC motor control and DSP capture program, the test is reliable and easy to use
  3. 所属分类:DSP program

    • 发布日期:2017-05-07
    • 文件大小:1456696
    • 提供者:张广
  1. STM8-BLDC_CONTROLLER

    1下载:
  2. STM8 BLDC 控制完整实例.基于STM8的库函数编写,对无刷直流电机控制器的开发有很大的帮助。-STM8 BLDC control motors complete instance. The library function based on STM8 writing, for the development of brushless dc motor controller has a lot of help.
  3. 所属分类:SCM

    • 发布日期:2017-04-29
    • 文件大小:349127
    • 提供者:陈辉
  1. ac

    0下载:
  2. This circuit uses the AC7 block of SimPowerSystems™ library. It models a brushless DC motor drive with a braking chopper for a 3HP motor.The permanent magnet synchronous motor (with trapezoidal back-EMF) is fed by a PWM voltage source inverter,
  3. 所属分类:Other systems

    • 发布日期:2017-05-04
    • 文件大小:20118
    • 提供者:Gwynble1dd
  1. windmotor

    0下载:
  2. 本设计介绍的是直流无刷电机的正弦波控制方式,以及基于英飞凌 XC866单片机的三相带霍尔传感器直流无刷风机 180 度控制方案。三相带霍尔传感器直流无刷风机 180 度控制系统主要由以下几大部分构成:整流电路、逆变电路、控制电路、驱动电路、开关电源、直流无刷风机及扇叶负载。-Is the design of the brushless DC brush motor sine wave control mode, and based on three-phase Infineon xc866 mi
  3. 所属分类:SCM

    • 发布日期:2017-05-16
    • 文件大小:3617440
    • 提供者:王孟
  1. three_half_wave_ctrl_bridge_machine

    1下载:
  2. 该程序为三相半控整流桥控制电机转动,三相交流电经晶闸管组成的半控整流电路,通过电感滤波,驱动直流电机转动,可观察电机转速。-The program for the three-phase half-controlled rectifier bridge control motor rotation, three-phase AC by thyristor half-controlled rectifier, filtering through the inductor to drive DC m
  3. 所属分类:matlab

    • 发布日期:2017-05-04
    • 文件大小:20440
    • 提供者:liwei
  1. sensor-closeloop

    1下载:
  2. 直流无刷电机的控制程序,关键技术在于PWM调制、电流换向,编码器反馈速度闭环控制。基于TMS320F28335芯片开发。开发环境为CCS- Brushless DC motor control procedures, the key technology is PWM modulation, the current reversing, the encoder feedback speed closed-loop control. Based on TMS320F28335 chip dev
  3. 所属分类:DSP program

    • 发布日期:2017-05-06
    • 文件大小:528999
    • 提供者:tan
  1. invertedPendulum

    0下载:
  2. 本设计所做的是一个单级的倒立摆,所以只要求一根摆杆就可以。小车靠直流电机的驱动来运动,进行左右移动,摆杆上有角速度传感器,可以测量出摆杆的当前角度,将角度反馈给主控芯片,主控芯片得到偏角信息之后,给驱动电路做出指令,让小车往偏角方向加速,这样,就能保持小车上的摆杆保持竖立平衡使用cortex-m3作为控制芯片。-The design is made by a single-stage inverted pendulum, it requires only one rocker can be. C
  3. 所属分类:SCM

    • 发布日期:2017-05-14
    • 文件大小:3150862
    • 提供者:盛勇
  1. five_leg(one-motor)

    1下载:
  2. 5管脚三相交直交异步电机控制模型,可用于容错控制,节省晶闸管。-5-pin three-phase DC-AC induction motor control model can be used for fault-tolerant control, saving thyristor.
  3. 所属分类:ARM-PowerPC-ColdFire-MIPS

    • 发布日期:2017-05-04
    • 文件大小:28590
    • 提供者:YANGHUANWEN
  1. avr444

    0下载:
  2. Robust sensorless commutation control. External speed reference. Overcurrent detection/protection. Basic speed controller included. Full source code in C. Source code can be adapted to a new motor by changing parameters. Several I/O pins
  3. 所属分类:其他

    • 发布日期:2017-12-27
    • 文件大小:82944
    • 提供者:maria123456
  1. 小型直流电机PID控制

    0下载:
  2. 小型直流电机PID控制,简单易懂,适合初学者。(Small DC motor PID control, easy to understand, suitable for beginners.)
  3. 所属分类:嵌入式/单片机编程

    • 发布日期:2017-12-21
    • 文件大小:26624
    • 提供者:kobely
  1. MiniBalanceV3.5【大功率版】平衡小车源码

    2下载:
  2. 本系统为两轮自平衡小车系统,由STM32单片机控制模块,陀螺仪姿态检测模块,电机驱动模块,电源供电模块等组成。陀螺仪MPU-6050模块负责采集平衡小车的角度信号以及角速度信号,并传给单片机;STM32单片机控制模块处理姿态角数据后,通过PID算法调节电机驱动电压,以控制两轮小车达到平衡;电机驱动模块负责接收单片机输出的控制信号,驱动两个直流电机的转速和方向,编码器将电机的速度和方向反馈给单片机控制器;电源模块负责各个模块的供电。通过系统的硬件软件设计、测试,证明了两轮自平衡小车能在±5 °范围
  3. 所属分类:嵌入式/单片机编程

    • 发布日期:2017-12-17
    • 文件大小:3494912
    • 提供者:李雨君
« 1 2 ... 8 9 10 11 12 1314 15 »
搜珍网 www.dssz.com