搜索资源列表
SPI_arm_drive
- SPI总线驱动，可驱动FLASH和数码管等设备。 LPC基于2138芯片的中间件-SPI Bus Driver, Flash drives and digital control, and other equipment. LPC based on the 2138 chip Middleware
lpc
- This document contains a specification for a new low pin count bus interface, dubbed LPC, that will be added to future Intel chip-sets. The target audience for this document are system and component designers.
lpc2104sim_bus
- ARM lpc 模拟总线-ARM lpc simulation Bus
can-m16-mcp2515
- 调试好的CAN总线的C语言程序及原理图，谢谢！-CAN bus debugging good C language programming and schematic, thank you!
FS_FAT32
- FAT32文件系统 基于LPC2200，前后台环境，可自己修改适配于各种RTOS。 验证环境: 搭载LPC2200的SmartARM2200开发板,使用该板上的SPI总线利用该程序读写SD卡 由于试验的SD卡比较特殊,1簇仅1扇区,所以不排除该程序对于非该情况的出错可能-FAT32 file system based on the LPC2200, the environment around Taiwan, can modify their own adaptation in
Vme_Interface
- 这是本人设计的一个关于VME总线接口的FGPA程序，FPGA一边连接ARM LPC2294，一边连接VME总线，FPGA采用的XILINX公司的SPARTANII系列，程序包包含完整的工程文件-This is my design of a VME bus interface on the FGPA procedures, FPGA side of the connection ARM LPC2294, while connecting VME bus, FPGA using the XILINX
spi
- 飞利浦（lpc）系列armspi系统总线的实现-Philips LPC rules (series) armspi the system bus
LPC2DDR2
- Module Function Descr iption: This module allows a SPI ROM to be used in a LX/CS5536 system. Details are below: 1.Provide a memory window to the SPI EPROM at FFF80000h-FFFFFFFFh (512KB). 2.Provide an interface to the SPI bus to allow the
LPC_Host
- LPC总线，主机模块代码，VHDL语言描述-LPC bus, the host code, VHDL language descr iption
CAN-MCP2515
- CAN总线 MCP2515芯片 SPI接口 只需五线即可实现通信 -MCP2515 chip SPI interface, CAN bus, only five lines to achieve communication
gpio
- linux 下（w83627）super io 的驱动原码。主要是有如何通过lpc总线访问w83627的寄存器-this is w83627 driver code in linux. it will show how to acess to w83627 register on LPC bus.
IAP
- LPC2000系列ARM芯片IAP例程，包括I2C、SD卡、CAN总线、XMODEM升级方式和演示程序-LPC2000 family of ARM chip IAP routines, including I2C, SD card, CAN bus, that XMODEM upgrade and demo program
LPCSPEC
- LPC总线规范，2002年8月1.1版，VHDL、固件编程必看-LPC bus specification, version 1.1 in August 2002, VHDL, firmware programming must see
LPC-program-CPLD
- 使用quartus开发。该程序通过VHDL语言实现了LPC时序。控制了2个LED数码管，通过读取LPC总线的上BIOS的数据，实现了计算机排故的POST卡功能。-Use quartus development. The program through the VHDL language to achieve a LPC timing. Control of the two LED digital tube, by reading the BIOS on the LPC bus data to a
lpc_top
- FPGA实现LPC总线读的动能，Verilog语言-FPGA implementation of the kinetic energy of the LPC bus read, Verilog language
opal-lpc
- PowerNV LPC bus handling.
opal-xscom
- PowerNV LPC bus handling for Linux v2.13.6.
opal-xscom
- PowerNV LPC bus handling for Linux v2.13.6.
opal-lpc
- PowerNV LPC bus handling.
lpc
- INTEL的LPC总线-INTEL s LPC bus............................................................................