搜索资源列表
STM32IOtest
- STM32通用的一个硬件测试程序，可以测试IO输入输出；电机PWM驱动，DS18B20读写等。编译环境IAR 6.3 .-STM32 common hardware test procedures, test IO input and output PWM motor drive, DS18B20 read and write. Compiler environment IAR 6.3.
DDS-G2-NEW
- 通过产生pwm波进行滤波完成dds 然后对输出信号测试反馈 稳定输出性能-Filtering by generating pwm wave output signal is then completed dds stable output performance test feedback
spwm(quick)
- 用GCC编写的AVR16的spwm波形（利用快速PWM模式产生），经proteus仿真测试可行-Written in GCC AVR16 SPWM waveform （caused by fast PWM mode）, through the proteus simulation test is feasible
DMX512_LCD
- 使用带21路PWM输出的STK MCU接收DMX512信号，并显示在不带字库LCD显示屏上，看用来测试DXM512信号接收或发送情况。-Use with 21 PWM outputs STK MCU receives DMX512 signal, and displayed on non-character LCD display, look to test DXM512 signal reception or transmission case.
linux_pwm_timer_spi_driver
- am1808 linux pwm,spi,timer的驱动，ko形式，带测试代码-am1808 linux driver for spi,pwm,timer,and test app
PWMtest
- 嵌入式开发，脱离操作系统的试验代码，PWM功能测试-Embedded development, test code from the operating system, PWM function test
DSPCAPTUREtest
- // 该程序用于测试DSP的CAPTURE模块，由TIMER1的比较模块输出一个PWM 波形，此波形输入CAP4引脚，待CAP4捕捉该PWM的10次上升沿后，停止捕捉，并把10次捕捉值存于数组result[10]中-This program is used to test DSP CAPTURE.
STM32F103C8T6_CAN_PWM
- MCU为STM32F103C8T6单片机。这是一个检测用的模块，用到了单片机的PWM输出，控制舵机，Can接收发送数据，及其他IO控制。-MCU for STM32F103C8T6 microcontroller.This is a test module, use the microcontroller PWM output, control steering gear, Can receive send data, and other I/O control.
wvm_pwm
- 软件：linux的PWM蜂鸣器驱动，内核3.4.91 硬件：mini2440 驱动简单易懂，注释完善，测试通过。- Software: linux the PWM buzzer driver, kernel 3.4.91 Hardware: mini2440 Driver straightforward, notes perfect test.
main
- PWM电机驱动简单测试 电机由全速到停止，反复循环 * * 实验目的：测试 PWM 频率是否正确-PWM motor drive motor from full speed to a simple test to stop, repeated cycles* Purpose: Test the PWM frequency is correct
phase_motor
- 3相电机恒速运行的测试层序；通过PWM脉宽调制电机的速度-3-phase motor constant speed test sequence through PWM pulse width modulation motor speed
Smart-car-procedures
- 本文介绍了一种利用AT89S52单片机为控制核心，结合多种传感器实现循迹、避障、红外遥控、控速、灭火功能的智能小车。利用BFD-1000传感器检测赛道实现小车循迹，利用两个红外传感器检测道路上的障碍，控制电动小汽车的自动避障，整个系统具有自动寻迹、避障和红外遥控、控速等测试功能。其中，控制部分采用AT89S52，AT89S52是一款8位单片机，它的易用性和多功能性受到了广大使用者的好评。电机驱动采用常用的PWM方式进行电机的调速控制。整个系统的电路结构较简单，可靠性能高，能满足各种设计的要求。随
mini2440pwm_test
- mini2440的pwm测试程序，程序没有大的变动，我只是把注释详细了，也有我对部分程序的理解-The mini2440 PWM test program, a program has the change, I just put the annotation detailed and also have I to the understanding of the part program
s3c2440_linux_pwm
- 基于mini2440开发板的linux下s3c2440的pwm驱动程序，实际测试验证，程序可正常运行，方便移植到其他开发平台。-Under mini2440 development board based on linux s3c2440 pwm driver, actual test, the program can run normally, easily ported to other development platforms.
STC15x104w-ecap
- 使用单片机STC13F104W进行PWM捕获函数实现；PWM的脉冲周期20ms,高电平介于1-2ms 经过测试可以使用-Using single chip microcomputer STC13F104W PWM capture function PWM pulse cycle 20 ms, high level between 1 to 2 ms After test can be used
CC2530ADTest_PWM
- 在不同的自然照明条件下测试其智能控制性能，在不同的照度条件下会得到不同的PWM波形。占空比分别为25 ，50 ，75 的PWM波（25KHz）。- Test their intelligent control performance under different natural lighting conditions, under different illumination conditions will be different PWM waveform duty cycle were
PIC18F87K22_PWM
- MICROCHIP 单片机PIC18F87K22，内部PWM测试程序，摘自网络,亲自验证有效。-MICROCHIP microcontroller PIC18F87K22, internal PWM test program, the network, personally verified effectively.
atm128_pwm_3_Phase
- PWM for ATmega128. Short and simple test.
dsp
- Pwm输出信号的设计 试设计四路（PWM1,PWM2,PWM3,PWM4）输出，载波频率为8ms，波形关系如图所示（一个周期）： -Design test design four (PWM1, PWM2, PWM3, PWM4) output Pwm output signal carrier frequency of 8ms, waveform relationship shown in Figure (a period):
430ADPWMLCD
- 430实用程序，AD采样测试和PWM波测试即LCD液晶显示程序的有机组合-430 utility, AD sampling tests and PWM wave test that organic combination LCD display program