搜索资源列表
Csc103_Protocol
- 为电力系统开发保护设备装置通讯的源代码 采用串口通讯, ret hat 9下 QT开发-development of the power system to protect communications equipment has the source code using serial communications, ret hat QT development under 9
hy_ml2000
- 这个程序用在电力设备保护上面,是个小电流接地的设备程序,-the procedures used in electrical equipment protection above, is a small current grounding equipment procedures,
HY_xx2000
- 这个程序用在电力设备保护上面,是个数字消谐的设备程序,用在通信上面-the procedures used in electrical equipment protection above is a digital elimination of equipment procedures, Communication with the above
103
- 电力系统103规约源代码 本规约参考了IEC60870-5-103（继电保护设备信息接口配套标准）传输规约（以下简称103规约），针对不同的网络结构，提出了2种链路传输方式，但都采用103规约的应用服务数据单元。根据103规约的要求，新研制的保护、测量、控制设备必须采用该配套标准的兼容范围，不能满足的部分采用通用分类服务完成。因此本协议适用于新研制的产品。-power system 103 of the Statute, the Statute of the source code refe
zkgzcl
- 电力系统变压器后被保护的逻辑说明和保护配置，故障处理程序
henaniec103
- 电力系统的IEC60870-5-103规约的中国化规约.详细规定了电保护和故障信息管理系统用103进行通讯的方式.是了解我国电力系统通讯现状的最好资料.
microcomputer_protection.rar
- 有关电力系统微机保护的很好的PPT，介绍保护原理、硬件系统和软件设计。,Microprocessor-based protection of the power system of good PPT, introduced to protect the principle of the design of hardware systems and software.
fenjiekaiguanyuanli
- 分界控制器保护原理.内部资料.对电力行业做一点小的贡献.-good
Adaptive_noise_cancellation_in_the_power_of_signal
- 自适应噪声对消在微弱电力信号检测中的应用可以检测到很微弱的信号保护电力线进行了MATLAB仿真-Adaptive noise cancellation in the weak electrical signal detection application can detect very weak signals to protect the power lines of the MATLAB simulation
trans_protection_mean
- 电力变压器差动保护 电力变压器差动保护 电力变压器差动保护 -transformer differential protection
qidong
- 电力系统继电保护故障启动程序，matlab编写的程序-Power System Fault launcher, matlab program written
11
- 电力系统低压电动机保护程序源代码 硬件主芯片是NXP的LPC2134-Power system low-voltage motor protection program source code for the main hardware chip from NXP LPC2134
iec_103
- 电力系统103规约源代码，本规约参考了IEC60870-5-103(继电保护设备信息接口配套标准)传输规约。-103 protocol
MATHCADjulibaohu
- 应用于电力系统距离保护中过渡电阻对差动电流保护的影响，通过对电容补偿的整定进而分析结果。-The protection applies to the transition resistance on differential current protection, through the tuning capacitor compensation and then analyze the results the power system.
微机保护源码
- 微机保护源代码，实现35kv及以下的线路保护所有功能。汉化液晶显示等全套程序，基于motolila 68332平台(Microcomputer protection source code, 35kV and below the line protection, all functions. Chinese LCD display and other complete set of procedures, based on motolila 68332 platform)
20109191302744128
- 电力系统二次保护原理，推荐初学者使用，，，，，，，，(Power system two times protection principle, recommended for beginners to use,)
PSCADKECHEN.gf42
- 电力系统方向，主打用于稳定性的判断和电力系统继电保护的方向。(Direction of power system)
继电保护在MATLAB里面的编程
- 利用MATLAB的程序对电力系统继电保护的程序进行编程，可以学习一下(Using MATLAB's program to program the relay protection program of power system, we can learn something about it.)
ps690u规约点表modbus
- 国电南自电力微机自动保护，后台程序监控，通讯编程通讯协议(Communication Programming Communication Protocol)
Power system failure
- 简单电力系统仿真模型，可模拟各类对称及不对称故障情况(Simple power system simulation model can simulate all kinds of symmetrical and asymmetric fault conditions)