搜索资源列表
44b0_test
- ARM 44B0测试代码 有各种接口的实例代码-ARM 44B0 test code examples of a variety of interface code
nsp788e
- 为ARM测试程序 已经测试通过 包括启动文件-for the ARM test procedures have been tested including startup files
AnchoredSpringForceMFC
- haptic主控臂的弹簧力效果测试，力的大小和两点之间的距离成正比。-haptic controlling arm of the spring test results, the size and strength between two points is proportional to the distance.
Jtag_yuanli
- 文章主要介绍ARM JTAG调试的基本原理。基本的内容包括了TAP (TEST ACCESS PORT) 和BOUNDARY-SCAN ARCHITECTURE的介绍，在此基础上，结合ARM7TDMI详细介绍了的JTAG调试原理。-article introduces ARM JTAG Debugging the basic principles. The basic content including TAP (TEST PORT ACCESS) and BOUNDARY - SCA N AR
562821839876
- 交流电桥的电路结构中，由电阻、电抗元件或 它们的组合构成四臂，并用检流计、耳机或其它仪器作为检验电桥是否平衡的“示零器”．利用交流电桥的平衡条件进行测量，这就是它的基本原理．-AC bridge circuit structure, resistance, reactance components or combinations of them pose four arm and used galvanometers. headphones or other equipment -- as
mybeep
- 在LPC2200上运行的一个测试小程序,使喇叭响!从中可以学习ARM GPIO的设置-LPC2200 in running a small test procedures Speakers ring for so! ARM can learn from the setup GPIO
winsocktest
- winsock test is used to winsock client test for arm cpu system
test-for-OpenGL-ES-in-WCE
- 采用OpenGL ES1.3版本，通过FPS测硬件平台的硬件加速是否起作用，可以为产品选择平台方案提供根据。 在WCE6.0 Au1300 MIPS平台 、 Frescal51 ARM两平台上测试通过-The use of OpenGL ES1.3 version, hardware platform through the FPS test whether hardware acceleration works, the program can provide the basis f
ce_input
- wince 5.0 下面的手写输入法程序，在wincearm 环境下测试通过-wince 5.0 Chinese handwriting input method as the following procedure, test environment wincearm
TestADC
- 友善之臂的ADC测试代码，是在WinCE6.0下，希望给大家帮助。-ADC arm friendliness test code, is WinCE6.0, I hope to help everyone.
test
- arm下的lcd的测试 程序，对应前面的驱动程序-lcd under the arm of the test procedure, the corresponding driver in front of
2440test
- arm s3c2440一个测试文件,里面包括LCD,EEPROM等-arm s3c2440 a test document, which includes LCD, EEPROM, etc.
EINT
- philips LPC2103 ARM EINT0 EINT3的向量中断试验程序，P0.16为中断EINT0低电平中断，P0.14中断EINT3低电平中断，当不同的中断产生是P0.17和p0.18产生不同的PWM信号。-philips LPC2103 ARM EINT0 EINT3 vector interrupt the test procedure, P0.16 for the low-level disruption EINT0 interruption, P0.14 low EINT3
ARM
- test code for ARM controller lpc2148
OneWire_and_DS1820S_driver_for_AT91SAM7SXXX_proce
- There is One Wire driver. It use UART. This source is for Atmel AT91SAM7Sxxx processors. There is driver for DS18S20 temperature sensor. It use One Wire driver for communication. I test this source in IAR Compiler for ARM 5.40.
main
- 一个关于ARM的测试程序， 一个关于ARM的测试程序，-A test program on the ARM, a test program on the ARM, a test program on the ARM,
sd-test
- ARM SD卡测试程序，可以用于编写ARM的SD接口驱动-ARM SD card test program, can be used for the preparation of the SD interface driver ARM
ADC-Main-C
- gcc for arm stm32Xclm.exe file to replace the original installation directory can be, and then set up the project in the MPLAB compiler module for the PRO. pro test, optimize a lot of. Summary: Memory Space used () ...
addonsu-14.1-arm-signed
- Supersu root cm14.1 test for download
ARM_Hex Converter V2.0.3
- arm hex convert test go