搜索资源列表
PIC_I2C_Slave
- PIC I2C slave communication code.
i2c_slave
- code for i2c communication between master and slave in a system using AVR MCU
f4520_m_s_v2
- I2C master and slave program with PIC.
I2C_Par_Slave
- I2C to 8-bit Parallel Bus Slave Design
SMBus_Slave_Driver_for_ST7_I2C_Peripherals-an1713
- SMBus Slave Driver for ST7 I2C Peripherals app. for ST7 MCU
I2CSLAVE
- 已经验证过的I2C，slave的IP，core，从一开源网站下载的，代码写的非常好，节省了FPGA的资源，比起以往的slave的CORE，这个CORE减少了寄存器的使用。-Has been verified I2C, slave of the IP, core, from an open source website, the code is written in a very good save FPGA resources than the previous slave of CORE, t
I2C_SLAVE
- I2C slave端。可支持1带多。本人已经过调试，确认是可用的。-I2C slave side. Can support more than one band. I have been debugging, sure there is available.
i2c_slave
- I2C 从设备通讯程序，用于I2C 硬件设计-I2C slave communication program, used to for I2C HW design
i2c_peri_demo_revC1
- I2C 从设备通讯应用示范程序，用于I2C设计验证-I2C slave communication application demo program, used to for I2C design verification
i2c_master_and_slave
- I2c slave and master Communication This Communication between 3 micro via i2c. 1 master 16f677. 1 slave receiver 16f619. 1 slave transmitter 16f819. The slave procedure are implemented in the micro.
I2C-test
- This source code provides some function in Codevision AVR to drive I2C serial communication. It consists of two parts one for master and other for slave.
I2C_SLAVE
- 网上找的一些I2C从设备代码都没用起来，于是自己写了一个。能实现读取和写入任意一个字节的功能。功能上目前已经够用，连续读取和写入多个字节的就没有加了。-Online to find some I2C slave device code did not use them, so he wrote a. Can read and write function of the first one byte. Function has been adequate, there is no sequenti
i2c_slave
- i2c files for the slave reciever
tmp75
- Temperature i2c slave
i2c
- i2c code in Verilog , with master and slave it will help user for his work and interface design using i2c
I2C
- I2C slave simulation model with file introduction
i2c_gpsl30
- 按照一般字符驱动处理的 I2C驱动程序，没有使用i2c体系结构。实现了 从模式读，和主模式写的功能。-IIC device driver that slave receive model and master TX model。
i2c_master_slave_pic
- This I2C library contains the following functionalities: - master/slave communication - timeout in case of bus failure - self recovery after timeout - possibility to write one of 32 bytes slave registers In the archive you can find the hardwar
i2c_slave_model
- I2C从控制器verilog代码，主要用于混合信号ASIC的寄存器配置接口(I2C slave module in verilog)
sketch_dec26abcd
- send address to i2c slave