搜索资源列表
FIR_band_pass-and-iir-low-pass
- 这个是对于fir带通滤波器以及iir低通滤波器的一个仿真。程序代码通俗易懂，意义很大。-This is a band-pass filter and the fir iir low-pass filter with a simulation. Program code easy to understand, very meaningful.
FIR5
- FPGA基于FIR的滤波，EP2C8芯片 40Mhz的采样频率，50KHz的截止频率的低通滤波，自己调试可用-FPGA-based FIR filter, EP2C8 chip 40Mhz sampling frequency, 50KHz cutoff frequency of the low pass filter, own debugging available
FIRPDDS
- 32阶fir数字滤波器+DDS，附有实验报告说明-32 steps fir digital filter+ DDS, with experimental report describes
lab11_fir
- 设计采样频率为24kHz、截止频率是6kHz的37阶FIR低通滤波器-Design sampling frequency of 24kHz, 6kHz cutoff frequency is 37-order FIR low-pass filter
matrix
- This code is used to find the matrix converter result fir improving the active and reactive power
DSPII_USTC_01
- 传统的宽带信号中抑制正弦干扰的方法是采用陷波器(notch filter),为此需要精确知道干扰正弦的频率.然而当干扰正弦频率是缓慢变化时,且选频率特性要求十分尖锐时,则最好采用自适应噪声抵消的方法.下图是用一个二阶FIR的LMS自适应滤波器消除正弦干扰的一个方案。该代码实现了以下功能： 1) 借助MATLAB画出了滤波器的误差性能曲面和误差性能曲面的等值曲线； 2） 给出了最陡下降法以及LMS算法的计算公式； 3） 用MATLAB产生了方差为0.05, 均值为0白噪音S(n)，并
FIRDF_design
- FIR带通、带阻滤波器设计，需要输入截止频率以及容许偏差。-FIR band pass and band stop filter design
firls
- matlab fir LPF least square error with zeroa weighted
fircheb
- matlab fir chebshev LPF
firamp
- matlab linear phase FIR four type amplitude
wwzl
- 实时录音去噪,来自足球场上的呜呜组啦噪声，有GUI，可以自己选择噪声类型，使用FIR滤波器滤波-real-time denoising
fir_filter
- 用c#编写了一套FIR窗口滤波器，其中数据段的提取来自于matlab的混合编程-Written in c# a FIR filter window, including data extracted from the mixture of matlab programming
DFT_FIR_Beamform
- DFT和FIR宽带波束形成源程序 可以自行设置参数 如载频强度 入射角度 信噪比等-DFT and FIR broadband beamforming source code can set the parameters such as the intensity of the incident angle of the carrier frequency signal to noise ratio, etc.
shiyan5
- 应用布莱克曼窗实现FIR滤波器，并绘制相应波形图案-Application Blackman window FIR filter, and draw the corresponding waveform pattern
fir4btp
- 4tap FIR filter in verilog code
dspFIR
- 数字信号处理的滤波器设计，有限长冲击响应FIR滤波器,-Digital signal processing filter design, finite impulse response (FIR) filter,
fft
- 利用快速傅里叶变换FFT的ip核和fir的ip核制作的自适应滤波器-use fft ip and fir ip to make a Adaptive Filter
Dig_Filter
- Filter can be FIR or IIR. - Filter type can be lowpass, highpass, bandpass, or bandstop. - Direct methods or optimization ones can be used during the design procedure. In order to learn how you can use this toolbox, please copy all the codes
filter
- 产生输入FSK信号的程序 FIR滤波器设计程序 IIR滤波器设计程序 FIR滤波器实现程序（用滤波器系数对输入信号进行滤波） IIR滤波器实现程序（用滤波器系数对输入信号进行滤波）-FSK input signal generating program FIR filter design procedures IIR filter design procedures FIR filter (with the filter coefficient for filtering the
firfpga
- 16阶fir数字滤波器工程文件,经过验证通过，可以参考-fir digital filter