搜索资源列表
gngauss
- 高斯白噪声的算法源代码，用于通信系统的matlab编程-Gaussian white noise algorithm source code for communications systems Matlab programming
2ASK
- 不用matlab里面的函数，自己写出来的2ASK的仿真程序，加入了白噪声，经过滤波后的波形有些变形，可能是滤波器的原因。仅供参考。-inside Matlab not a function of their 2ASK written by the simulation program, joined the white noise, filtered waveforms after some deformation, the filter may be reasons. For referenc
4PSK
- 实现4psk调制的源程序，以及对应的在白噪声信道下的系统性能-achieve 4psk modulation source, as well as corresponding white noise in the channel system performance
16QAM
- 实现16QAM的算法程序，包含在白噪声信道条件下的性能实现程序-achieve 16QAM algorithm procedures contained in the white noise channel conditions of the performance of procedures
05041062qpsk-fading
- 带瑞丽衰落信道高斯白噪声的QPSK调制解调信道，可以得到功率谱波形和星座图-with Ruili fading channel Gaussian white noise QPSK demodulator access that can be power spectrum waveform and constellation
blockturbocodes
- 产生（７，４，３）＊（７，４，３）的分组turbo码，并模拟在高斯白噪声条件下的传输的过程．-20 (7,4,3) * (7,4,3), a turbo codes, simulation and Gaussian white noise in the transmission conditions of the process.
64QAM_PTCM
- 64QAM_PTCM在高斯白噪声下的性能分析-64QAM_PTCM Gaussian white noise in the Performance Analysis
awgnresearch
- 加性高斯白噪声信道的最佳接收机性能研究 这个是要钱下的!
e29
- 利用最小方差方法估计复正弦加白噪声得平稳信号的功率谱
数字视频图像传输系统实现中几个问题的研究
- MATLAB程序的仿真比较。随后，针对QPsK，详细讨论了其基本原理和具体的实现算法，并进行了仿真验证，然后选用HSP502巧数字上变频芯片和HSP50214B数字下变频芯片，设计了数字调制、解调器的实现方案。最后，作为对整个数字视频图像传输系统的宏观认识，利用M户JLAB中的实时建模仿真Simullnk库对典型的视频图像传输系统一数字视频广播系统(D vB)，进行了建模、仿真和初步的分析，结果表明:在高斯白噪声的传输环境下，系统采取的一系列抗干扰措施，包括内、外码级联的信道纠错编码和先进的调制
zhikuo
- 该程序是在matlab环境下对加性高斯白噪声信道的无线通信中的直接序列扩频系统进行仿真。-The program is in the matlab environment of additive white Gaussian noise channel in the wireless communications system for direct sequence spread spectrum simulation.
IS95WGN
- 使用IS-95 FIR滤波器从白噪声中滤得低通噪声,使用matlab2007b编写-Using the IS-95 FIR filter obtained from the white noise in the low-pass noise filter
gauss_noise
- 在C环境下，实现高斯白噪声序列的产生，使用瑞利分布-get gauss_noise
Communication-System-Simulation
- 通信系统仿真实现QAM星座图，插值后Q、I信号波形图，加入高斯白噪声Q、I信号波形，经过匹配滤波后的波形，误码率曲线-Communication Systems Simulation QAM constellations, interpolated Q, I signal waveforms by adding Gaussian white noise Q, I waveform, after matched filtering of the waveform, the error rate c
RS
- 这个C++程序建立了高斯白噪声信道模型下的RS码的编码及译码算法，并且给出了其比特误码率性能。-This program has realized the RS code,the coding and decoding mode (and furthermore has simulated the ber performance of decoding )
bpsk
- 一个关于BPSK误码率仿真的程序，其中包括信号产生，加入高斯白噪声，和误码率计算！-A BPSK BER simulation program, including signal is generated by adding Gaussian white noise, and bit error rate calculation!
The-simulation-of-OFDM-system
- 用matlab对OFDM系统进行仿真，并添加高斯白噪声，得到一条BER曲线-Using matlab for OFDM system simulation, and add white Gaussian noise, to obtain a BER curve
tongxin
- 利用MATLAB对通信系统进行了仿真，该仿真包括了实现汉明编码，FDMA调制以及信号通过高斯白噪声信道传输的通信系统以及相关误码率的计算等。-Communication systems using MATLAB simulation, simulation, including the implementation of the Hamming code, FDMA modulation and signal through the Gaussian white noise channel co
128QAM
- 随机产生二进制序列，进行128QAM调制，画出星座图，通过加性高斯白噪声的信道，再画星座图，并计算误比特率。-128QAM modulate with MATLAB
qpsk
- 加性高斯白噪声环境下QPSK调制解调系统的性能分析，包括box-buller产生AWGN以及QPSK调制与解调，误码率计算-Performance additive white Gaussian noise environment QPSK modulation and demodulation system analysis, including box-buller produce AWGN and QPSK modulation and demodulation, bit error ra