搜索资源列表
MIMOCapacity
- 计算MIMO系统中信道容量的程序，包括中断容量和遍历性容量两种-CITIC MIMO system channel capacity calculation procedures, including the outage capacity and ergodic capacity
OFDMwaterfilling
- 这里是功率分配文献中经常提到的功率分配，功率控制，功率平均，以及最最著名的注水法的演示程序，是功率分配问题研究的入门程序，对以后的研究有很大的帮助，谢谢支持-waterfilling
channelcapacity
- 在MIMO系统中，已知和未知信道状态信息时的信道容量比较-In MIMO systems, known and unknown channel state information when the channel capacity compared
MIMO
- MIMO系统容量仿真程序分为两个。其中 文件夹1为：发射天线数为4，接收天线数逐渐增大时MIMO系统容量的仿真程序。 文件夹2为：接收天线数为4，发射天线数逐渐增大时MIMO系统容量的仿真程序。-MIMO system capacity simulation program is divided into two. One folder 1 as follows: the number of transmitting antennas is 4, gradually increasing
CDMA_uplink_capacity
- CDMA系统上行容量理论大小与仿真证明,可以参看-capacity of uplink in CDMA system with both theory and simulation verification
WCDMA
- 本文首先提出了基于接收信干比的局部和全局算法，在次基础上提出了一种自适应接纳门限算法，其基本出发点是在保证系统中断性能的前提下，尽可能降低系统阻塞概率，充分利用系统容量资源。-This paper proposes received signal to interference ratio based on the local and global algorithms, based on the second admission, an adaptive threshold algorithm
Resources-Allocation
- 在传统的子载波分配过程中，具有优先权的用户将优先选择最好的载波，这将导致载波利用效率下降。 许多改进算法通过牺牲一定的公平性来提升容量并降低复杂度，但是这可能会使用户间无法达到所要求的公平 性。针对这些问题，提出了一种基于公平度门限的载波和功率自适应分配算法。在载波分配过程中，通过公平度 门限来决定载波分配优先级，从而实现容量和公平度的粗略折中。载波分配后利用粒子群（PSO）算法进行功率分配来达到所要求的公平度门限。实验结果表明，该算法在满足所要求公平度门限的同时提升了系统容量。 -
channel_capacity
- 求mimo系统的系统容量matlab代码，中断容量及遍历容量。-capacity of MIMO systems
mimo--capacity
- 该程序适合于强散射环境下，并分析了收发端分别有nr和nt个天线情况下的系统容量。-In this programe a highly scattered enviroment is considered. The Capacity of a MIMO channel with nt transmit antenna and nr recieve antenna is analyzed.
MIMO--capacity
- 比较了不同收发天线下MIMO系统容量并且利用注水算法将MIMO信道容量达到最大-Comparison of different transmit and receive antennas for MIMO system capacity and the use of water-filling algorithm will reach the maximum capacity of the MIMO channel
MIMO
- MIMO系统容量仿真程序,用来仿真不同天线数目情况下增减天线数目对信道容量的影响-MIMO system capacity simulation program used to increase or decrease the number of antenna simulation under different conditions affect the number of antennas on the channel capacity
capacity
- MIMO系统容量仿真的MATLAB程序，注解详细-capacity of MIMO system using MATLAB
error
- 相位加权预编码技术，能够降低误码率,通过宽线性的处理，增大系统容量-pahse weighted technology which can reduce the error performence，increase system capacity though widly linear processing
mimo
- 在不同信噪比下，对几种典型系统（MIMO）进行系统容量的仿真-At different signal-to-noise ratios, several typical systems (MIMO) are simulated for system capacity
qvfhw282
- 多址干扰一直是造成cdma系统容量限制的重要原因,不错的 很好的(Multiple access interference has been the important cause of the cdma system capacity limits, good good)
outdated_part_AF
- 传统两跳多中继协作网络，系统在过时信道状态下，采用AF放大转发协议，误码率和容量的仿真程序(Traditional two-hop multi-relay cooperative network, the system in the outdated channel state, using AF amplification Forwarding protocol, error rate and capacity of the simulation program)
自治型微电网群多元复合储能系统容量配置方法
- 基于微网群的多元复合系统控制方案和方法的应用。(The application scheme and control method of multivariate composite system based on the micro network.)
fig1_Monte_Carlo_3
- 实现物理层安全，通过加入干扰噪声，提高系统容量。(The physical layer security is realized in this paper. By adding interference noise, the system capacity is improved.)
Lingmindu_Bess
- 计算电池储能收益与相关参数的灵敏度，包括单位容量造价、综合利用效率等。(Calculation of the sensitivity of battery energy storage and related parameters)
含风电可信容量评估
- 利用非序贯蒙特卡洛法实现含风电的发电系统可靠性评估(Realize the reliability assessment of wind power generation system.)