搜索资源列表
dsp14
- 14个DSP的实验测试程序，汇编语言实现，类型分别为：滤波器，正弦波发生器，步进电机，直流电机，交通灯，语音录放，指令实验，存储器，串行口，定时器，显示屏，硬件中断，同步串口，exam-c。-Fourteen DSP testing programs,implemented by assemble language,types:filter,sine wave generator,Stepping motors,direct current motors,traffic light,voice
DspResource
- 有14个DSP的实验测试程序，可以与大家分享。类型分别为：滤波器，正弦波发生器，步进电机，直流电机，交通灯，语音录放，指令实验，存储器，串行口，定时器，显示屏，硬件中断，同步串口，exam-c-14 DSP experimental test procedure can share with you. Type of : filter, sine wave generator, stepper motors, DC motors, traffic signals, voice recording
dspSourceExample
- dsp实验测试程序,包括指令实验、存储器、串口、同步串口、步进电机、硬件中断、定时器、交通灯、直流电机、滤波器、正弦波发生器、语音录放、EXAM_C、显示屏-dsp experiment testing procedures, including instructions experiment, memory, serial port, synchronous serial port, stepping motor, hardware interrupt, Timer, traffic ligh
w03
- 用变压器+整流桥+滤波器+稳压器构成5v的直流电源，以此作为D/A转换器（DAC0832）的基准电压，用AT89C51+8155+键盘+LED的单片机小系统控制进入DAC0832的数字量达到数控的目的 -transformer rectifier bridge filter Regulators constitute 5v DC power supply, as D / A converters (DAC0832) voltage, AT89C51 8155 with the keyboard
lot-of-good-DSP-experimental-program
- 经典的DSP试验程序集合！ 01指令实验 02存储器 03串行口 04同步串口 05步进电机 06硬件中断 07定时器 08交通灯 09直流电机 10滤波器 11正弦波发生器 12语音录放 13显示屏
current_measurement
- 这是一个实现了无刷直流电机闭环控制电流环检测的程序，一起还有滤波器的使用。性能良好。为个人原创-This is a realization of the closed-loop control of brushless DC motor current loop detection procedure, also with the use of filters. Good performance. Be original
dsp_for_test
- 大量的dsp测试程序,有步进电机,直流电机,指令试验,中断测试程序,滤波器试验程序等等,稍微改动就可以用到自己的项目中去-A lot of dsp test procedures, and stepper motors, DC motors, command pilot, interruption test procedures, filter testing procedures and so on, a little change can be used for their own proj
DSP
- 指令实验、存储器、串行口、同步串口、步进电机、硬件中断、定时器、交通灯、直流电机、滤波器-Experimental instructions, memory, serial port, synchronous serial, stepper motor, hardware interrupt, timer, traffic lights, DC motor, filter
DSP_test_All
- DSP《滤波器，正弦波发生器，语音录放，指令实验，存储器，串行口，同步电机，步进电机，硬件中断，定时器，交通灯，直流电机，显示屏》-DSP（Filter, sine wave generator, voice recorders, instruction experiments, memory, serial port, synchronous motor, stepper motor, hardware interrupts, timers, traffic lights, DC machin
dipingonglvfangdaqilunwen
- 本设计主要由带阻滤波器电路、低频功率放大器（包括电压放大器和功率输出放大器）、精密整流电路、A/D转换电路、直流稳压电路、V/F转换电路、显示电路等组成。-The design mainly consists of a band stop filter circuit, low-frequency power amplifier (including the voltage amplifier and power amplifier output), precision rectifier ci
DSP-experiment
- 关于使用dsp进行编程，交通灯、直流电机、滤波器、正弦波发生器、语音录放等几个功能的编程-Dsp programming on the use, traffic lights, motor, filter, sine wave generator, voice recorders, and several other features of programming
ADC
- 使用MSP430G2231 LANUCHPAD的PWM输出、低通滤波器和比较器制作一个A/D转换器。 要求： 不得使用MSP430 自带的A/D转换器； A/D转换结果的变化趋势通过开发板的红灯和绿灯表示，红灯亮表示采集信号减小，绿灯亮表示采集信号增大；A/D转换结果可通过查看变量观察，也可其他方式。 分辨力：0.01V，量程：0~2V（直流信号，电位器分压产生）；-Use MSP430G2231 PWM output low-pass filter and comparator
cheb_s
- 用以滤除直流工频干扰的四阶切比雪夫高通滤波器传递函数。-four stage Chebyshev high-pass filter transfer function which is Used to filter out the DC frequency interference.
AD9854_Template
- 本系统是基于零中频正交解调原理的简易频率特性测试仪，用于检测被测网络的幅频特性和相频特性。该系统主要包括DDS集成模块，RLC串联谐振电路，乘法器电路，低通滤波器，同相放大器和测量显示模块，其中RLC串联谐振电路作为被测网络。本系统以DDS 集成模块为核心，将其产生的正交扫频信号通过被测网络后，经乘法器得到高频信号；这两个信号经过低通滤波、同相放大后得到符合要求的I、Q直流分量；最后通过单片机进行ADC 采样、数据处理和液晶显示，得到被测网络的幅频特性和相频特性。本系统在算法上的创新之处
The-End
- 基于STM32F103RB（正点）所做的幅频特性显示器。采用AD9851产生1VPP信号，经过滤波器，再通过AD637变为直流信号，最后将信号显示在液晶屏上。-STM32F103RB based on amplitude-frequency characteristics (punctuality) made displays. 1VPP signal generated using the AD9851, through the filter, then through AD637 into
AC25&50Hz&直流滤波器程序
- 25HZ/50HZ/DC的滤波器算法程序(25HZ/50HZ/DC filter algorithm program)