搜索资源列表
PIC蜡烛灯模拟程序
- 利用PIC12F675控制LED的闪烁，模拟蜡烛灯的摇曳状态。压缩文件里面包含有PIC源文件,HEX文件，还有仿真文件。
LED灯闪烁
- LED跑马灯测试时钟
led
- 用一个按钮开关循环控制四个led灯的闪烁方式，输入时钟10MHz，闪烁频率1Hz-Button switch with a four cycle control lights flashing led the way, the input clock 10MHz, blinking frequency of 1Hz
LED
- 详细说明：这是一个TI DSP2812的GPIO的应用: 跑马灯程序,可以让8个Led灯,每隔一秒钟依序轮流闪烁,附录了完整的程序批注-Detailed Descr iption: This is a GPIO of TI DSP2812 Application: Marquee procedure allows 8 Led lights, then take turns at intervals of one second flashes, appendix a complete endors
led
- 源码是控制一排led灯闪烁，源码已经调通。-Source code is to control a row of led lights flashing, source code has been transferred pass.
gpio_flash
- DSP F2812 LED灯闪烁实验FLASH烧写程序-DSP F2812 LED lights flashing experimental procedures FLASH programmer
1.LED
- 用于CC2430芯片ZIGBEE调试用的。简单的LED灯闪烁程序-Use for ZIGBEE CC2430 chip debugging ,Simple LED flashing program
led
- 基于TMS320VC5416的定时器编程，DSP工作在8MHZ主频，定时器分频系数为15，通过DSP通用I/O引脚控制指示灯闪烁，指示灯每秒闪烁1次。-TMS320VC5416 timer based programming, DSP working in 8MHZ frequency, the timer frequency factor of 15, through the general-purpose DSP I/O pin control light is blinking, the
LED-lights-flashing-CC2430
- 基于CC2430开发板的一个实验例程 开发环境为IAR Embedded Workbench 实现功能为：LED灯闪烁-CC2430 development board based on an experimental routine IAR Embedded Workbench development environment for the realization of functions: LED lights flashing
定时器-1-控制LED灯闪烁
- 基于lpc2103通过定时器0中断控制led灯的亮灭
STM8S触摸按键调节LED闪烁速度
- STM8S105 通过触摸按键来控制LED灯闪烁(STM8S105 controls the LED light flashing by touching the button)
实验1 LED灯闪烁
- keil4 基于stc89c52rc芯片的LED灯闪烁(Keil4 LED light flashing)
Ex06_POP28335_PWM_LED
- 在DSP TMS320 F28335型号DSP中，PWM驱动LED灯闪烁。(In the DSP TMS320 F28335 model DSP, the PWM driver LED lights blink.)
1、（通用IO口方式）实现LED灯全亮全灭闪烁
- 通用I/o口控制 led流水灯闪烁 全亮全灭(General I/o port control LED water lamp flashing full bright full kill)
5 闪烁一个LED
- 初学者入门，使用单片机简单的使一个led灯闪烁(Simple to make a LED light flashing)
按键控制LED灯
- 按键实现LED灯亮或者闪烁，按下up键实现led灯亮，再按down，实现led灯闪烁(Button to achieve LED lights flashing or flashing)
雾灯程序
- 基于AT80C51单片机的控制雾灯闪烁频率，亮度等级(Control fog light flicker frequency, brightness grade based on AT80C51 single chip)
F310_frame
- 通过对按键的扫描 实现频率显示和led灯闪烁(Realizing frequency display and led flicker by scanning the key)
com口控制led灯
- com口发送指令来控制led的闪烁情况（库开发）(com mouth led lights control)
LED
- 延时led灯闪烁程序，基于stm32开发板编写的延时1ms灯闪烁(Delay LED light flicker)