搜索资源列表
LED9212
- LED灯控制程序，用78F9212单片机，C语言，PWM控制，可调光
用STC12C5410控制4通道DMX接收代码
- 使用STC12C5410控制4通道DMX接收代码，调光级别为256，晶振为16M 。使用STC内的4路硬PWM输出调光。接收稳定。使入门者快速上手
PWM-tiaoguang
- 利用定时器产生PWM，LED灯由亮到灭，由灭到亮逐步变化，也就是调光现象-Use of timers generate PWM, LED lights from bright to off, off to light by a gradual change, which is dimming phenomenon
30-PWMtiaoguang
- 基于c51编制的，用于实现PWM调光功能.-Prepared based on c51, used to implement PWM dimming function.
PWMcPP.pdf
- 单片机PWM调光程序单片机PWM调光程序-Microcontroller PWM dimmingMicrocontroller PWM dimming
EX4
- 单片机PWM调光实验程序代码，简单易懂，适合新手教学-Microcontroller PWM dimming experimental procedure code, easy to understand for novice teaching
lux-pwm-CC2530
- cc2530程序基于IAR开发环境，用于输出PWM控制LED灯，以及包含有调光策略-cc2530 program development environment based on iar, for output pwm controlled LED lights
v-pwm
- 瑞萨的R7F0C80212做的电位器电压控制PWM的软件,可以应用在调光LED灯上-R7F0C80212 VOLUME LED
PWM
- 通过PWM（脉宽调制）调节LED的亮度 定义 LED到P1.0端口 改变led循环中的延时量实现调光-Through the PWM (pulse width modulation) adjust the brightness of LED definition LED to P1.0 port change amount of delay in the LED loop to achieve dimming
51-PWMledctrl
- pwm调光，使用stc89c51 8位单片机软件实现PWM功能，与外置led相连，调节led光亮度-pwm dimming, use stc89c51 8-bit microcontroller software PWM function, connected with external led, led brightness adjustment
LED-pwm-
- LED触摸调光台灯，本设计采用的为stc公司生产的stc12c2052ad单片机，晶振无要求，合适即可，由于触发问题，此次设计采用定时器0生成PWM信号，按键响应延时可自行修改，初学者的课程设计，需要的可以看看，正在努力学习中，不足之处还望指正~-LED touch dimmer lamp, this design uses for the company s stc12c2052ad stc microcontroller, crystal-free requirements, appropr
PWMLED
- 上传一个LED的PWM调光的单片机源代码，方便理解，便于应用等-Upload a PWM dimming LED the microcontroller source code, easy to understand, easy application and so on
15
- C51完整源码。PWM调光程序，无错误，可直接烧入芯片使用-C51 complete source code. PWM dimming procedures, error-free, can be directly burned into the chip uses
20121109_LEDrunningtime_v1
- 车用LED调光计时程序，根据时长计算LED模组的温升及发热情况PWM调整LED的亮度，并累计LED模组的使用寿命(The car LED light timing program, according to the length of the LED module temperature rise and heating condition PWM to adjust the brightness of the LED, and accumulated LED module's service
然并卵的灯
- 功能 1、单键开关LED 2、在LED开启状态下旋转编码器可以调节pwm以控制LED亮度 3、在LED开启状态下双击达到最大亮度(实际就是程序事先设定好的) 4、在LED开启状态下长按进入延时关断，延时65s，最后10s指示灯闪烁 5、在延时关断状态下单击取消延时关断 6、关断或者掉电后会记忆最后亮度(掉电记忆) 注： 1、短按操作：按键按下，按下时间<1s，属于一次短按操作 2、长按操作：按键按下，按下时间>1s，属于一次长按操作(The function of
三色LED程序PCA
- 利用STC15单片机的PCA功能实现PWM的调节，从而控制三色LED的调光功能。(The PCA function of STC15 microcontroller is used to realize the adjustment of PWM, so as to control the dimming function of the three color LED.)
Arduino套件例程
- Hello World！、LED 闪烁、模拟值、广告灯、交通灯、按键控制、抢答器、蜂鸣器、PWM调光、光控声音、感热灯、8乘8点阵、倾斜开关、火焰报警、数码管、四位数码管、74hc595、(Hello World! LED flash, analog value, advertising light, traffic lights, keystroke control, responder, buzzer, PWM dimming, light control sound, heat lamp,
ex6_7 基于PWM的LED调光控制
- msp430的调节pwm实验，经试验，完全可以直接使用(MSP430's PWM experiment, which is tested, can be used directly.)
实验3：LED流水灯
- LED流水灯PWM PWM调光程序,可以实现led灯渐变的效果用于STC89C52 上测试通过。(LEDLED water lamp PWM PWM dimming program, can achieve LED lamp gradual effect, for STC89C52 test pass.)
PWM
- 通过stm32单片机定时器产生PWM波，实现LED灯的调光(The PWM wave is generated by the timer of STM32 MCU, and the dimming of LED lamp is realized.)