搜索资源列表
2052pwm
- stc单片机PWM演示程序、根据典型应用转译-stc microcontroller PWM demonstration program, according to the typical application translation
two_balance_car
- 自动平衡双轮车程序，采用STC单片机，包括陀螺仪，PWM电机控制、蓝牙遥控等代码-Automatic balancing two wheeled cart program, using STC microcontroller, including the gyroscope, PWM motor control, Bluetooth remote control code
STC_PWM
- 使用STC MCU产生两路PWM正弦半波的程序，经过光耦隔离后可驱动IGBT产生正弦输出。测试芯片用STC12LE5A60S2，运行后使用示波器观察PCA输出。-Use STC MCU make 2 half-Sin PWM PCA-out.Tested with STC12LE5A60S2.
pwm_nb
- 使用STC系列的51、52单片机产生可控的pwm方波。代码仅供参考。-STC Series MCU using 51 and 52 to produce a controlled pwm square wave. Code for reference only.
stc16bitPWM
- stc单片机实现的16位PWM输出，可做灯光或电机调速控制-stc MCU 16-bit PWM output, do lighting or motor speed control
ac
- 采用STC 采集换相点，必通过PWM控制无刷转速。-make stc 12
c_buck_stc
- 采用STC12C5A60S2单片机发生47KHZ的PWM脉冲信号，经过IR2104控制MOS，从而控制整个BUCK电路。单片机内部自带的10位ADC能通过电压电流检测电流实时反馈电流和电压数值，并由此调整输出的PWM的占空比，形成电流电压闭环控制系统。按键能设置输出电流从0.2A到2A，以0.01A递增，输出最大10V，液晶能显示实时输出电流与电压-use STC controller to generate pwm signal ，whic can dribe mos pipe，then co
ADC_PWM
- 0-10V转PWM电路板程，用STC单片机编写，将采集到的ADC值转换为相应的PWM，进而控制电机转速-Conversion 0-10V turn PWM circuit board process, written STC microcontroller, ADC value will be collected for the corresponding PWM, thereby controlling the motor speed
My60S2Demo
- STC12C5A60S2的工程模板 用于stc的51系列单片机C51 - Struction descr iption 1.BSP Board s config header a).IOconfig.h define extern component s IO pin
STC15_TEST
- STC系列单片机库函数与测试例程，包含ADC转换，串口，PWM，定时器，数码管等40多个程序-STC Series MCU library functions and test routines, including more than 40 program ADC conversion, serial port, PWM, timers, digital control, etc.
STC12_PWM
- STC12单片机输出PWM通过按键可调,按键带长短按功能-STC MCU output PWM is tuned by the key
呼吸灯
- STC单片机 用PWM驱动Led灯，模拟人的呼吸频率(STC single-chip drive with Led lamp PWM, to simulate the human respiratory rate)
开关电源
- 单片机输出PWM控制开关电源，触摸屏显示界面(STC 51MCU CONTROL SWITCH POWER)