搜索资源列表
usbhostslave
- USB主机和设备的verilog代码，实现了USB1.1协议规范的要求-USB host and equipment Verilog code to achieve the USB 1.1 protocol specification requirements
usb1.1phy
- USB 1.1 PHY的代码，verilog语言 USB 1.1 PHY的代码，verilog语言-USB 1.1 PHY code, verilog language USB 1.1 PHY code, verilog language
usb_verilog.tar
- 文件包含一个usb 专用集成电路设计项目，用的verilog 原码-document contains a usb ASIC design, the original code verilog
实现USB接口功能的VHDL和verilog完整源代码
- 实现USB接口功能的VHDL和verilog完整源代码,Implementation USB interface functions of the VHDL and Verilog source code integrity
USB_kz
- 提供Cy7C68013 USB芯片开发源程序，由verilog编写-Cy7C68013 USB chip to provide the development of source code, prepared by the Verilog
cp_uart_6
- 用CPLD驱动UART转USB芯片CP2102的verilog代码，与PC通信 包括CP2102的配置 驱动等-Using CPLD to drive the USB-UART CP2102 interface. verilog code, then communicate with PC, including the configuration and drivers, etc.
DE2_SDCARD
- DE2 开发板上，NIOS编程。对SD卡以及USB的读写操作的实例。我的代码及工程绝对完整！代码其实是Verilog编写的。-DE2 development board, NIOS programming. On the SD card and USB examples of read and write operations. My absolute integrity of code and works! Verilog code is written.
NIOS_USB_API_demo
- 在nios系统开发中的驱动usb接口芯片的代码,包括verilog代码,与相应的驱动代码-In the nios system development driver usb interface chip of the code, including the verilog code, and the corresponding driver code
VerilogFPGAUSB
- 用Verilog（FPGA）实现USB源代码大家-Using Verilog (FPGA) source code we look to achieve USB
usb1.1
- USB 1.1的verilog代码，已通过fpga 程序源代码内容-Verilog code for USB 1.1, has passed through the contents of the source code fpga
usb_latest.tar
- USB 源码。Verilog实现的USB程序，用ISE打开工程文件即可-USB verilog code。-Verilog implementation USB program, open the project file with the ISE can be
USB-245BMWR20121211
- 关于用verilog语言进行USB芯片FT245BM读写的代码-The verilog language USB chip FT245BM read and write code
the-verilog-code-of-can-usb-i2c
- CAN总线，I2C，USB等的FPGA实现源码-CAN bus, I2C, USB, etc. FPGA implementation source
CH372
- 基于fpga的USB控制器，采用CH376芯片，verilog代码编写，通过仿真-Fpga-based USB controller, using CH376 chip, verilog code prepared by simulation
usb
- 本文包含了USB的verilog程序及测代码-This article contains a USB verilog code and testing procedures
fpga-usb-verilog-test
- 红色飓风开发板中USB测试源码部分，包含说明文档，FPGA的verilog代码，cy68013固件程序，上位机测试程序。实现USB回环测试，可作为usb开发的参考文件-Red hurricane development board of the USB test source code, including documentation, FPGA verilog code, cy68013 firmware program, PC test program. Realization of USB
CCD_drive
- TCD1304 CCD 驱动 AD转 USB2.0传输(This code based on verilog language, worked on EP1C3T144 FPGA chip, developed on Quartus II 12.0 . The ccd's data transformed by USB2.0 after amplified and AD confromed.)
usb
- verilog rtl code for usb controller.
usb_rd_buffer
- FPGA（SPARTAN6）通过USB协议与开发板上的USB芯片进行数据读写测试，在上位机上可以看到USB发来的数据，也可以通过修改VERILOG代码完成数据的接收(FPGA (SPARTAN6) can read and write data through the USB chip on the development board through the USB protocol. The data sent by USB can be seen on the host computer,
CAN总线，I2C，USB等的FPGA实现源码
- 控制器局域网总线协议的Verilog代码(The Verilog code of the CAN bus protocol)