搜索资源列表
Step_Motor_DrivePulse
- 产生一脉冲去到步进马达驱动器，控制步进马达旋转，脉冲频率由VR调节，开发环境：ICC-AVR-Generates a pulse to go to the stepper motor drive and control the stepper motor rotation, the pulse frequency to adjust by VR .development environment: the ICC-AVR
phone-operated-robot
- In the project the robot is controlled by a mobile phone that makes a call to the mobile phone attached to the robot. In the course of a call, if any button is pressed a tone corresponding to the button pressed is heard at the other end called 慏ual T
rfid_checkout_system
- 基于avr芯片的射频识别的的进出检查系统，网络上下的，需要的可以参考参考-Radio frequency identification out of the inspection system base on avr, the network up and down, can refer to reference
FRE
- 代码能实现简单频率仪的功能，是学习AVR的有用程序。-The code can achieve a simple function of the frequency meter ,It is a useful program for learning the AVR.
pinlvji
- 上传的是一个简易频率计程序，用avr单片机，在没有倍频的前提下最大可以测量65k的信号，可以测量脉宽，周期，传上来交流一下。-Upload a simple frequency meter program, avr microcontroller, the multiplier under the premise can be measured 65k signal can be measured pulse width, period, Chuan-up exchange.
For_VB
- AD9854与avr单片机组成的dds模块，上位机以及频率控制源码-AD9854 avr microcontroller dds module, the host computer, and the frequency control source
PWM
- Atmega 16单片机，这里利用T/C1定时器中断来产生PWM波形。在ICC AVR编译环境下，利用tool 菜单中的application builder生成一个简单的PWM波程序。这段程序以PA0作为PWM波的输出端口。利用T/C1定时器比较匹配和溢出产生两次中断来改变PA0的输出电平。具体过程为：计数器TCNT1从初始值开始不断计数，当发生比较匹配时，把PA0置为低电平，计数器继续计数，当发生溢出中断时，计数器回到初始设定值，并把PA0置为高电平。从而在PA0端口获得一稳定持续的PWM波
signal-generator-
- 信号发生器 关键词：ATmega16、LCD12864、ICC AVR、AVR Studio、Proteus、AD5310、UA741、SPI 用ATmega16单片机控制AD5310产生正弦波、方波、锯齿波、三角波信号。通过按键可以切换信号类型、改变信号幅度和频率。 -Signal generator Keywords: ATmega16, LCD12864 ICC AVR, AVR Studio Proteus, AD5310, UA741, SPI, ATmega16
AVROSC7.7K
- 以前就一直有人上传一个AVR加12864的示波器，最近我在网上找到了它的2.0版本，修复了几个错误，测试的波形频率大概是7.7k左右-Before people have been upload an AVR 12864 oscilloscope, I recently found in the online version 2.0, fixes several bugs, test frequency of the waveform is probably around 7.7k
fengping
- avr单片机的n分频程序，用iar开发的，有用惠存-the avr microcontroller n frequency program developed iar useful Huicun
motor
- AVR使用硬件PWM驱动L298N来控制电机，PWM频率为2K-AVR hardware PWM driver L298N to control the motor, PWM frequency for 2K
spwm-(2)
- spwm program avr with codevision for atmega 64. the output is a 3-phase sinusoidal pwm or a dc pwm with regulable frequency and amplitude.
PWM
- AVR单片机的PWM功能，采用快速PWM和相频修正模式PWM实现。内有完整工程文件。-AVR microcontroller PWM function, fast PWM and phase and frequency correct mode PWM. Complete project file.
uARM
- 老外写的在avr上跑的arm模拟器，附内核镜像文件，可以运行linux系统，等效主频大概10khz-Run on avr arm simulator written by foreigners, with a kernel image file, you can run linux system, the equivalent frequency probably 10khz
Frequence-counter
- AVR扫外部频率控制继电器输出不同频率信号-AVR sweep external frequency control relay output signals of different frequencies
LCD12864
- c语言编写的AVR单片机的lcd12864液晶点阵屏幕驱动 Chip type : ATmega8 Program type : Application Clock frequency : 3.686400 MHz Memory model : Small External SRAM size : 0 Data Stack size : 256-c language AVR MCU lcd12864 LCD dot matrix screen driver Chip ty
avryuprotuse
- avr与protuse频率可调的PWM波形输出-avr with protuse adjustable frequency PWM waveform output
AVR_T_C1_frequency-meter
- 基于AVR单片机的频率计的设计，采用定时器和中断实现-AVR microcontroller based frequency meter design, using timers and interrupts to achieve
frequncemetraAVR
- measure Frequency by avr and show on LCD.
AVR51-Waveform-acquisition
- 分别用51和avr做的波形测量工具，可以测量、显示和存储低频率的波形-Respectively 51 and avr do waveform measurement tools to measure, display and store the low-frequency waveforms