搜索资源列表
I2CPro
- 此源码利用单片机模拟实现IIC总线通信,可以连接基于I2C的硬件调试 -use of this source SCM simulation IIC bus communication, based on the I2C can be connected to the hardware debugging
IICMaster(400hz)
- 12Mhz标准51的400KHz IIC总线主器件模拟方式驱动程序。 本驱动程序即可以在没有Small RTOS的情况下使用-12Mhz standards of 400KHz 51 IIC bus owners device simulation mode driver. The driver is not in Small RTOS for the use of
24C01_IIC_wr
- 24C01的IIC 读写的c51程序 为了安全起见,程序中很多NOP是冗余的,能进一步精简,但必须经过验证。 Atmel 24C01 比较特殊,为简约型. 51晶振为11.0592MHz-24C01 the IIC reading decoder procedures for the sake of safety, NOP process is a lot of redundancy that can be further streamlined, it must be test
at24c256
- 通过AT89S52的I/O口模拟IIC接口,读写控制AT24C256,适用于AT24C64、AT24C256、At24C512-AT89S52 through the I / O interface IIC mouth simulation, control AT24C256 Applications read and write, apply to the AT24C64, AT24C256 Applications, At24C512
iic_driver_for_uClinux_+_s3c44b0
- 开发环境为uClinux2.4.x+s3c44b0。此程序以字节方式对IIC器件进行读写。通过硬件测试,可以直接使用。附:IIC测试程序。具体使用说明见其中的readme.txt。-development environment for uClinux2.4.x s3c44b0. This procedure in byte pairs IIC device reading and writing. Through hardware testing can be used directly. R
bu_iic_led
- 该程序是iic程序的测试程序,只需两个led和两个按键,是入门的好程序!-that the procedure was iic procedures testing procedures, led only two buttons and two, is the entry of the program!
program(TCON)
- 一个用于驱动TFT屏的驱动程序,使用IC:1828,program (无EEPROM 无IR,完整说明)IIC只写一个-driving a TFT screen for the driver, the use of IC : 1828. program (no EEPROM non-IR, a complete explanation) just write a IIC
at24c01111
- nec单片机硬件IIC的接口程序(EEP)-nec microcontroller interface hardware IIC (EEP)
iic_lcd_51
- I2c如 IIc 24LC64等器件的51单片机驱动程序,已经通过实际验证,很好用的-I2c such as IIc 24LC64 51 microcontroller device driver, has been through actual test Oh good use
freescaleI2Csourse
- 以MC68HC908SR12为例的IIC总线源程序-MC68HC908SR12 example to the IIC bus source
IICforsopcbuilder
- IIC控制器 for Sopc Builder-IIC controller for Sopc Builder
MCU_I2C
- 51的IIC源码,修改一下就可以用了! 51的IIC源码,修改一下就可以用了!-51 IIC source, changes to be spent! 51 IIC source, changes to be spent!
COM2IIC
- 串口转发IIC程序,用MEGA16实现,调试IIC接口时非常有用。-IIC serial transponder procedures used MEGA16 realized, IIC debugging interface will be very useful.
IIC_51
- 这是一个基于51单片机的IIC通讯程序,用C语言编写的。-This is a microcontroller based on the 51 IIC communication procedures, using the C language.
uart_IRRecv_IIC
- 此代码实现功能为:在philips P89LPC935单片机上实现红外遥(对应红外发送芯片为:HT6222)控解码接收,IIC通信,串口通信(单片机自带串口通信、利用单片机IO脚模拟串口通信)等。开发编译环境为Keil51-achieve this code functions : the philips P89LPC935 MCU distance infrared (IR this chip counterparts : HT6222) control decoder to receive,
ATmege16
- 本代码是AVR单片机的完整IIC通信程序-the code is a complete AVR IIC Communication Program
tps65010
- 嵌入式系统中的,TPS65010 驱动程序, IIC 接口-Embedded Systems, TPS65010 driver, IIC Interface
iic_c51
- 用c语言编写的单片机IIC程序,提供给大家分享。-c language used MCU IIC procedures, to share with you all.
3100_485_232_iic
- 此程序是及iic、rs485、rs232于一身的单片机c语言编写,通过rs与外界通信,rs485与内部设备通信,iic与6320通信,控制声音输出db值。-this procedure is and iic, rs485, rs232 in an MCU c language, rs through communication with the outside world, rs485 and internal communications equipment, and 6,320 iic co
drv_1161
- pcf8563的读写程序,也可移植到其他模拟iic总线的器件上-pcf8563 literacy procedures, but also to other transplant iic Analog Devices on Bus