搜索资源列表
MIPS-xmodem
- MIPS架构Xmodem和Ymodem源码程序，和tftp齐名常用网络通讯协议-MIPS architecture Xmodem and Ymodem source procedures, and tftp par common network communication protocol
UFatSystem
- 本程序是用DSP控制RTL8019AS以实现网络通讯 因能力有限，存在一些问题，望大家指教-this procedure is used to control DSP RTL8019AS to achieve network communications by limited capacity, there are some problems, hope you enlighten
STM32_ENC28J60
- stm32 和ENC28J60 编写的网络通讯程序，已经调试成功-stm32 ENC28J60
Can_AD
- 基于arm7的can总线模拟采集及总线通讯程序，方便实现can网络的运行-ARM7-based simulation of the can bus acquisition and bus communication procedures to facilitate the realization of the network can run
WSN-chuan
- 应用英国jennic公司生产的无线传感器网络芯片JN5139进行串口通讯程序的设计！-British jennic company production of application of wireless sensor network chip JN5139 for serial interface communication program design!
stm32_obd
- 基于ST单片机STM32F10X的OBD程序,是基于底层驱动的源程序，与上位机采用串口通讯，把诊断指令发到CAN网络并返回结果给上位机-Is based on the underlying driver source OBD procedures ST microcontroller STM32F10X based, serial communication with the host computer, diagnostic commands sent to the CAN network a