搜索资源列表
MC9S12DG128_PWM
- FREESCALE 16位单片机片MC9S12DG128的PWM输出程序,可设定PWM波的频率和占空比由产品验证,完全可用-SCM MC9S12DG128 PWM output procedures, configurable PWM pulse frequency and duty cycle from product certification, fully available
source.rar
- 用S51单片机控制驱动芯片L298程序(C语言) 有六个端口,输入端口分别为P1.0,P1.1,P1.2,P1.3,P1.4,P1.5. 六个输出端口分别为P0.0,P0.1,P0.2,P0.3,P2.4,P2.5. 其中P0.0,P0.2,P2.5输出高低电平.P0.1,P0.3,P2.4输出PWM脉冲信号. 程序要求 只要P1.0-P1.5中任一个为"1",则P0.0,P0.2输出高电平 当P1.2或P1.3为"1",P0.1,P0.3输出占空比相同的PWM信号,With S5
sci_rcv
- 利用PIC16F877A单片机,通过串口控制PWM占空比实现PWM输出程序-PIC16F877A MCU via the serial port to control the PWM duty cycle of PWM output program
PWM-51timer
- 用定时器实现的PWM程序,可设置占空比.-Using the PWM timer realize these procedures is to set the duty cycle.
IAR_PWM
- 基于ARM7的PWM调试程序，一个是PWM控制占空比，一个是PWMADC-ARM7-based PWM debugger, one is PWM duty cycle control, one is PWMADC
LPC2124_PWM
- LPC2124输出可调占空比PWM波 PROTEUS仿真-LPC2124 duty cycle of PWM wave output adjustable PROTEUS simulation
PWM
- 根据LPC935单片机的PWM输出来控制MOSFET,获得不同占空比-According LPC935 microcontroller PWM output to control the MOSFET, by different duty cycle
LPC2138_PWM
- 使用LPC213X系列单片机产生PWM方波~通道、频率、占空比可调~不同频率均在定时时间上进行了校准~我使用的是11.0592M晶振，Hz单位，范围可达10-5-Use LPC213X MCU PWM square wave- generated channel, frequency, variable duty cycle- different frequencies were calibrated on a regular time- I am using 11.0592M crystal,
PWM
- ARMLPC2103 PWM源代码，可以改变占空比-ARMLPC2103 PWM source code, you can change the duty cycle
STM32-TIM1-PWM
- 通过对 TIM1 定时器进行控制，使之各通道输出插入死区的互补PWM 输出， 各通道输出频率均为17.57KHz。 其中，通道1 输出的占空比为50 ，通道2 输出的占空比为25 ，通道3 输 出的占空比为12.5 。各通道互补输出为反相输出。 TIM1 定时器的通道1 到3 的输出分别对应PA.08、PA.09、PA.10 引脚，而通 道1 到3 的互补输出分别对应PB.13、PB.14 和PB.15 引脚，将这些引脚分别接 入示波器正接线，GND 引脚接示波器负接线，
PWM
- 实现ARM板子输出PWM波，双通道的，占空比可控制-Achieve ARM board PWM output, dual channel, the duty cycle can be controlled
PWM_arm_ads
- ARM处理器的ADS开发环境下，按键改变PWM占空比，使用邮箱。-ARM processor of the ADS development environment, keys to change the PWM duty cycle, use the mailbox.
The-TIM1-The-PWM-shows
- STM32编译源码。对TIM1定时器进行控制，通道1输出的占空比为25 -The STM32 compile the source. TIM1 timer control, the channel 1 output 25 duty cycle
ARM9_PWM
- 本源码是基于ARM9 S3C2440的PWM信号，利用S3C2440产生可变占空比的信号。此信号可驱动电机以达到变速效果-This source is a PWM signal based on ARM9 S3C2440, S3C2440 produce a variable duty cycle signal. This signal can drive motor in order to achieve variable speed effects
TimerA
- 这是由msp430f169的定时器A写的产生方波的程序，频率为1K，p1.2口的输出占空比为0.75，p1.3口的输出占空比为0.25。-This is a program written by msp430f169 Timer A square wave, the frequency of 1K, the p1.2 mouth of the output duty cycle 0.75 p1.3 output of the duty cycle of 0.25.
PWM11
- 该函数是为了实现通用定时器2产生PWM脉冲的，脉冲的占空比可调-The function is generated in order to achieve universal timer PWM pulse, the duty cycle of the pulse can be adjusted
PWM_Ver1.0
- 使用msp430f149系列单片机，利用定时器和IO翻转模拟，产生4路PWM波，使用旋转编码器控制频率和占空比，利用片上Flash实现掉电配置保存，使用数码管显示。-Use the msp430f149 series microcontroller timer and IO flip analog, generate 4 PWM wave, rotary encoder is used to control the frequency and duty cycle, the use of pow
timer
- 定时器产生PWM波，频率可以随意设定，占空比可调。-PWM timer generated wave, the frequency can be arbitrarily set, adjustable duty cycle.
7.-Buzzer-Inreface-with-50p-duty-cycle
- ARM 7 interfacing program for buzzer interface with 50 duty cycle-ARM 7 interfacing program for buzzer interface with 50 duty cycle
Pwm_generater
- 可调PWM输出，周期固定占空比变，周期变化低电平固定-Adjustable PWM output cycle fixed duty cycle change cycle low level fixed