搜索资源列表
1111
- 智能控制温度，湿度，烟雾检测，报警.可以通过手机短信控制，-Intelligent control of temperature, humidity, smoke detection, alarm can be controlled via SMS,
51_dht11
- 基于89s51的温湿度传感器，传感器的型号是dht11,可以同时测量温度和湿度。-Based on 89 s51 temperature and humidity sensors, sensor model is dht11, can measure temperature and humidity at the same time.
CODE_A
- 基于单片机的温湿度传感器采集，使用DS18B20（温度），DHT11（当湿度传感器使用，采集的温度精度没有DS18B20高），然后使用LCD1602显示-Microcontroller-based temperature and humidity sensors collect, use DS18B20 (temperature), DHT11 (when the humidity sensor, temperature accuracy is not collected DS18B20 hig
AD
- A/D转换器是用来通过一定的电路将模拟量转变为数字量。 模拟量可以是电压、电流等电信号，也可以是压力、温度、湿度、位移、声音等非电信号。但在A/D转换前，输入到A/D转换器的输入信号必须经各种传感器把各种物理量转换成电压信号。-A/D converter is used by certain circuit analog into digital quantity. The analog voltage, current can be other signals, also c
STM32F103_DHT11
- STM32通过IO口模拟与DHT11实现串行通信，由于DHT11本身限制只能读出温度和湿度的整数位！-STM32 serial communication via IO port analog and DHT11, DHT11 itself due to restrictions only read integer bit temperature and humidity!
Stm32
- 基于STM32的温度、湿度的检测系统的设计论文，各方面都有详细介绍和设计-STM32-based temperature and humidity detection system design papers, all aspects in detail and design
STM32-sht10
- STM32处理器利用SHT10传感器采集空气的温度和湿度-To collect the air temperature and humidity using SHT10 based on STM32
wenshidu
- 在MSP430单片机上实现对温度和光强湿度等传感器的控制。-On the MSP430 single chip microcomputer control system for the temperature and light intensity humidity sensor.
DHT11
- 单片机编程传感器dht11，可用于测量温度和湿度。-Microcontroller programming sensor DHT11, can be used for measuring temperature and humidity.
STM32_statr
- 基于stm32的智能家居研究，其中包括温度传感，湿度测量，光强度测量等-Based on the STM32 intelligent household
DHT22-2
- 温度传感器DHT22的检测程序，在1602液晶上显示当前环境温度及湿度，精确度0.1，误差范围为2HR ，0.4C-DHT22 temperature sensor detection program that displays the current ambient temperature and humidity, the accuracy of 0.1, the error range is 2HR , 0.4C in 1602 on LCD
NRF24L01_Control
- 使用NRF24L01作为无线传输模块，控制子模块开关继电器。主机使用12864显示，并有DTH11检测温度和湿度-Use NRF24L01 as a wireless transmission module, the control sub-module switching relays. 12864 show host, and the temperature and humidity detection DTH11
DHT11-wenshidu-sensor-@12M
- DHT11温湿度传感器，将采集到的温度和湿度通过串口输出显示，采集时间间隔应大于2s-DHT11 temperature and humidity sensors, collect the temperature and humidity through the serial output display, acquisition time interval should be more than 2S
1602Pds1302P18B20
- 基于51单片机的万年历程序，采用1602显示，有温度和湿度测量，万年历有星期的显示，可以作为万年历设计参考程序-51 microcontroller based calendar program, using the 1602 display, temperature and humidity measurement, a week calendar display, can be
Light-and-temperature-and-humidity
- 基于51单片机的环境检测系统，测量室内环境的温度，湿度和光照强度。-Environmental testing system based on 51 single chip microcomputer, measuring the temperature of the indoor environment, humidity and light intensity.
temperature-and-humidity-measurement
- 测量室内实时的温度和湿度变化，并在1602显示屏上显示-Measure indoor temperature and humidity changes, real-time and shown on the screen in 1602
temp
- 计量当前环境的温度和湿度。。采用ATMEGA8单片机。-Measuring the temperature and humidity of the current environment.. Adopting ATMEGA8 microcontroller.
CLOCK
- 基于51单片机的12864时钟。可以显示温度，湿度，及闹钟-this is aclock
Collection-Master(20150524)
- stm32f103为主控芯片，si4463接收来自从机节点的温度和湿度数据，W5500网络芯片发送到上位机。-stm32f103 as the main chip, si4463 temperature and humidity data received the slave node, W5500 network chip is sent to the host computer.
yuancheng
- 51单片机控制，可远程操控温度和湿度，实时观察与检测-51 MCU control, remote control of temperature and humidity, real-time observation and testing