搜索资源列表
SPWM_STC89C52
- 电子设计竞赛二等奖，SPWM信号发生器微控制器STC89C52的源代码，包括仪器前面板的管理（4*4键盘扫描和12864液晶显示），以及模拟SPI接口向FPGA发送控制字。-Electronic Design Competition Award, SPWM signal generator, microcontroller STC89C52 source code, including the management of the instrument front panel (4* 4 keyb
FPGA-contronl
- 单片价c8051与FPGA的SPI接口通信，近端机与光口通信控制-Price c8051 and the FPGA-chip SPI interface communication, the proximal port communication control unit and light
SG_AT89S52
- 2006年电子竞赛二等奖，多波形函数、信号发生器的主控制器——AT89S52源代码，汇编语言编写，主要实现仪器前面板的管理（包括2*3键盘扫描和1602液晶显示模块驱动），以及模拟SPI接口向FPGA发送控制字。-Electronic Contest Award in 2006, more than wave functions, the main controller signal generator- AT89S52 source code, written in assembly lang
FPGA_FIDOandSPI
- 在FPGA中建立一个FIFO可用宇内部传输测试使用，也可以用于两个单片机之间的数据传输，同时还上传了基于DSP的SPI设置的FPGA源码-Create a FIFO in the FPGA internal transmission test using the available buildings, can also be used for data transfer between two microcontrollers, but also upload a set of DSP-bas
adis16350_all
- This document outlines how to use the Analog Device ADIS16350 High Precision Tri-Axis Inertial Sensor Evaluation Board with the LabVIEW FPGA implementation of the SPI (Serial Peripheral Interface) digital communication protocol. This example reads an
learn10_zhonghe
- 这是一个基于MSP430LaunchPad的用CCS5.1编译的用于设定频率、幅度、相位差通过12864显示，通过SPI协议将数据发送给FPGA的工程文件。-This is a MSP430LaunchPad use CCS5.1 compiled is used to set the frequency, amplitude, phase through 12864 shows that the SPI protocol to send data to the FPGA project fil
STM32_CAN_USART_TLC2543_FPGA
- STM32F103处理器程序，基于3.4固件库编写，本程序不包含固件库，所有功能均为单独的c文件，模块化的封装，方便调用。 功能包含USART、SPI（包含TLC2543和DA的操作）、CAN、通过地址总线与数据总线读写FPGA等多个功能模块，可以作为类似功能设计的重要参考。-STM32F103 processor program, based on the 3.4 firmware library preparation, the program does not contain firm
Atmega128_FPGA_SPI
- Atmega128实现的包含串口通信、SPI接口的ADDA读写、与FPGA通信等功能的工程源码，GCC编译。-Atmega128 achieve serial communication, SPI interface ADDA read and write, and FPGA communication functions of engineering source GCC compiler.
spi-fpga-interface
- 基于stm32f107处理器的板子的spi驱动程序-Based stm32f107 processor board spi driver
51spi
- 51单片机与FPGA之间的SPI通信，简单有效，亲测。非常实用。-SPI communication between the MCU and FPGA 51
SPI
- SPI通信程序，实现430的单片机和FPGA的串口通信一大难题-SPI communication procedures, microcontroller and FPGA 430 serial communication is a major problem
spi-for-fpga-and-stm32
- ＦＰＧＡ于ＳＴＭ３２握手ＳＰＩ通信，ＤＡＣ数据的传输，双向的数据传输-FPGA Handshake SPI communication to STM32
spi_eeprom
- FPGA程序 实现SPI EEPROM读写-FPGA SPI EEPROM read and write procedures to achieve
IAR20151014
- MCU配合FPGA控制并驱动96路电机，其中MCU与FPGA采用SPI通信，本文件是MCU部分程序-MCU with FPGA control and drive motor 96, which MCU with FPGA using SPI communication, this document is part of the program MCU
SPI_STM32_FPGA
- STM32F1与FPGA通过SPI进行通信，我上传的是32部分的程序，已经通过串口测试成功。此程序可拓展为和单片机，DSP通过SPI进行通信-STM32F1 and FPGA communication through the SPI, I uploaded the 32 part of the procedure has been successfully tested through the serial port. This program can be extended to and s
spi
- 基于FPGA的SPI通信协议，主机的Verilog代码(SPI - based SPI Communication Protocol)
STM32与FPGA通信程序
- STM32F1与FPGA的SPI通信程序(SPI communication program between STM32F1 and FPGA)
程序-正弦信号发生器(FPGA+STM32版)
- 以FPGA为核心，实现正弦波、调制波AM、FM、ASK和PSK等功能，通过SPI协议与STM32通信，实现输出波形的选择、频率的设置和基带信号的设定等。(With FPGA as the core, the functions of sine wave, modulation wave AM.FM. ASK and PSK are realized. The output waveform selection, frequency setting and baseband signal sett