搜索资源列表
UsbBlaster
- 直接应用USB接口，对FPGA/CPLD等芯片的下载。便于用手提电脑的玩家使用。大家可以里面有单片机的源程序和PLD的下载程序。
source_code.rar
- 一些源程序，主要包括CAN总线驱动、sdram VHDL实现、ucos2的移植、SDIO驱动、tcpip的实现、usb控制器代码、基于FPGA的雷达目标模拟器等,Some source code, including CAN bus driver, sdram VHDL implementation, ucos2 transplant, SDIO drivers, tcpip of implementation, usb controller code, based on the FPGA, s
usb_wr_firmware
- CY7C68013固件 FPGA把数据通过usb写入pc slave 模式 使用 EP6 -USB:FPGA write data to PC by USB change from cypress example slave mode and use EP6 bulkloop.c firmware based on the firmware frameworks. Building this example requires the full vers
68013datasheet
- 一个非常不错的描述68013芯片数据手册，希望给大家分享-A very good descr iption of 68013 chip data sheet, hoping to share with you
USB11_ACEX1K
- FPGA文件负责采集传感器数据，然后传给51单片机，51单片机通过usb将信号传递给上位机，，vc文件是上位机软件界面，-FPGA file is responsible for collecting sensor data, and then passed to the 51 single-chip, 51 single-chip signal transmitted to the host computer via usb vc file is a PC software interface
UsbDevDemo
- 用于基于FPGA和USB串口通信后显示采集数据波形的VB程序,用于windows平台上。-Based on FPGA and USB serial communication is used to collect data waveform is displayed VB program for Windows platforms.
MCU
- 单片机开发源码，用于实现FPGA数据向单片机发送数据，转换成USB协议后传输到电脑上-MCU development source for implementing FPGA data to the microcontroller to send data, convert the USB protocol transmitted to the computer
USB键盘接口示例工程及文档
- 本工程文件用于fpga开发板和USB键盘连接通信 可以实现键盘按键响应(This engineering file is used for FPGA development board and USB keyboard connection communication to achieve keyboard key response)