搜索资源列表
usb_wr_firmware
- CY7C68013固件 FPGA把数据通过usb写入pc slave 模式 使用 EP6 -USB:FPGA write data to PC by USB change from cypress example slave mode and use EP6 bulkloop.c firmware based on the firmware frameworks. Building this example requires the full vers
CY7C68013AD
- 本文件是一个我买的开发板的原理图，型号是:CY7C68013,用ALTIUM或PROTELL DXP打开。-This document is a development board I bought the schematic diagram, model is: CY7C68013, with Altium or opens PROTELL DXP.
cy7c68013_nrf2401_transmit
- USB2.0控制器CY7C68013控制无线收发芯片nRF2401进行无线发射的51单片机程序-USB2.0 Controller CY7C68013 control nRF2401 wireless transceiver chip for wireless fired 51 SCM procedures
cy7c68013_nrf2401_receive
- USB2.0控制器CY7C68013控制无线收发芯片nRF2401进行无线接收的51单片机程序-USB2.0 controller CY7C68013 control nRF2401 wireless transceiver chip for wireless reception of 51 single-chip program
cy7c63743
- CY7C68013单片机通信测试:数据从控制面板传入EP1IN端点，然后送入IOA端口，然后程序读取IOA端口，送入EP1IN端点，在控制面板显示。-CY7C68013 Singlechip communications test: data from the control panel EP1IN incoming endpoint, and then into the IOA port, and then the procedure to read IOA port, into EP1IN
FX2LP-firmware
- cy7c68013 同步Slave fifo传输 固件。 经测试，速度可以达到每秒40MB以上。 网上很多代码均为异步，速度最多只能到10多MB。注意：因为和FPGA配套，时钟是外部提供，若有不明，可以联系我。-cy7c68013 slave fifo sync transfer firmware. Speed up to 40MB/s.