搜索资源列表
shanshuodeng1
- 单片机闪烁灯简单程序，实现全闪，全亮。用开关控制-Simple procedures for single-chip flashing lights, all-flash, all bright. With switch control
IR1308LCD
- 红外解码LCD显示 红外接收部分使用一体化接受头，当接收到 38KHz的红外调制波时，输出端输出解调信号， 可以直接用单片机IO 口读取其数字信号。 板上配有开关，平时不用时防止干扰和降低功耗， 应将其电源关掉。样例程序中提供 TC9012 芯片的解码程序，使用 12M 晶振，解码稳定， 可以直接移植为工业应用。其他芯片的码值用户根据芯片编码资料自行修改。 -IR decoding LCD display using the integrated parts of the inf
Temperaturecontrolledautmaticfansystem
- 本设计为一种温控风扇系统，具有灵敏的温度感测和显示功能，系统AT89C5 单片机作为控制平台对风扇转速进行控制。可由用户设置高、低温度值，测得温度值在高低温度之间时打开风扇弱风档，当温度升高超过所设定的温度时自动切换到大风档，当温度小于所设定的温度时自动关闭风扇，控制状态随外界温度而定。所设高低温值保存在温度传感器DS18B20内部E2ROM中，掉电后仍然能保存上次设定值，性能稳定,控制准确。-The design as a temperature-controlled fan system,
Switched_Reluctance_Motor_Drive
- Single phase switched reluctance machines (SRMs) have a special place in the emerging high-volume, low-cost and low-performance applications in appliances and also in high-speed low-power motor drives in various industrial applications. Single phase
demo
- 单片机学习电机试验和遥控器配合开关DCdemo-MCU learning motor test and a remote control with switch DCdemo
Direct-Torque-Control-of-Four-Switch-Brushless-DC
- Direct Torque Control of Brushless DC Motor with Nonideal Trapezoidal Back EMF - IEEE PAPER
Source-relay-switch-control
- 51单片机继电器开关控制源码，有注释，编译通过可直接使用。-Source relay switch control 51 single-chip, with annotations, compiled by direct use.
switch
- 16 button with 8led switch control.
1.8W-Buck-Topology-Power-Supply-with-VIPer12AS.ra
- This board is an auxiliary power supply based on the VIPer12AS monolithic device with rather low output power required. It is a buck (step-down) converter with a positive output voltage referenced to the common ground based on the monolithic device V
switch
- 89v51 interfacing with switch
PH1_2012-4-5
- 旋转编码的代码，编码器是ALPS的带开关，此程序直接可以移植到数字功放用于做音量调节。使用的是AVR单片机，同时有FD650做显示；欢迎大家下载。-The rotary encoder of the code, the encoder is the ALPS with switch, this program can be transferred directly to the digital power amplifier used to do to adjust the volume. Us
touch-delay-switch
- 智能触摸延时开关源程序 用STC89C52单片机P0口的高阻态输入功能，扫描接口电平。手指将VCC与I\O接口半连接，产生高电平信号。用单片机高低电平控制继电器以达到间接控制节能灯。用单片机的定时器中断定时一段时间。利用人眼视觉暂留现象显示楼层数-Smart touch delay switch source with STC89C52 microcontroller P0 port high-impedance input function, scan interface level. F
AVR-M8-switch
- 硬件是使用AVR-M8,软件环境WINAVR,功能是使用M8的I/O控制多个继电器，实现电子开关的功能。-Hardware is using the AVR-M8, and The software environment WINAVR, function is more relay I/O control with M8 and realize the function of the electronic switch.
Multiple-key-switch
- 使用AT89C51，8个LED发光二级管和4个按键，按第一个键发光二极管前后4个交替显示3次，然后在8个一起闪烁3次。按 第二个键发光二极管从右向左单个循环显示3次再一起闪烁3次。按第三个键发光二级管从左向右单个循环显示3次再一起闪烁3次。第四个键发光二级管从左向右再从右向左3次以后再一起闪烁3次。-Use AT89C51 8 LED light-emitting diode and four buttons, four alternating before and after pressing
SWITCH-LED
- 外部开关简单控制LED变化，含有PROTUES仿真 用winavr编译的-Simple changes in the external switch control LED containing PROTUES simulation compiled with winavr
sdcf
- 通过2个按键设置可控硅的触发角，达到调整电压的功能，同时按下2个按键有开关功能-Through two buttons set thyristor firing angle, to adjust the voltage function, simultaneously press two buttons with switch function
photoelectric-coupler-switch
- 熟悉光电耦合器开关的特性，并在开发板上进行相关的控制实验。-Familiar with the characteristics of the optocoupler switching and related development board control experiment.
Alarm-Clock-with-Zone-Switch
- 单片机开发闹钟，含开机语滚动+三个时区切换功能-Alarm Clock(Time Zone Switch included)
MCU-control-with-LED-light
- 用STC89C52单片机控制LED灯的开关与否，模板型程序-STC89C52 MCU control with LED light switch or not, the template type program
ssi-ssi
- 采集编码器SSI信号并以SSI信号形式传输，同时还有开关量输出-get ssi signal encoder and transfer it in ssi form, meanwhile with switch signal output