搜索资源列表
软件法实现7段 SVPWM
- 利用TMS320LF240x实现SVPWM算法的程序 下面给出了利用TMS320LF2407实现SVPWM算法的一个应用程序。在该程序中，我们假设有200个电压矢量Uout 平均分布在电角度为2π的范围内，通过改变SVPWM的调制周期T可以改变输出的3相正弦波的频率。 源程序代码-use TMS320LF240x SVPWM algorithm to achieve the following procedure is the use of TMS320LF2407 SVPWM algo
lab014-dcmotor
- 使用DSP2812，的事件管理器（EVB）产生的PWM波，输出在PWM11引脚，去控制直流电机速度。-use DSP2812, the event management (EVB), the PWM wave output pin in PWM11 to DC motor speed control.
Thesquare-wavesignaloccurs
- 本人调试TMS320C54X产生方波信号的调试程序，打开工程即可使用。-I have the square wave signal debugging procedures, in order to use the project to open.
FANGFANGBOforDSP
- 基于DSP的fangbo.asm 利用定时器Timer0在XF脚产生周期1s的的方波 此程序采用100Mhz的时钟频率，产生的方波-DSP-based fangbo.asm use timer Timer0 XF feet produced in a cycle of the square's procedure using 100 Mhz clock frequency of the square wave
0DSP_利用dsp产生任意信号的三角波
- 利用dsp产生任意信号的三角波，正弦波，方波的发生,采用汇编代码编程，在ccs调试软件下调试-Dsp produce any signal using the triangular wave, sine wave, square wave occurs, the use of assembly code programming, debugging software debugging in ccs
F2812_SPWM
- F2812产生SPWM波。（CCS3.3开发环境下）EVA下的通用定时器T1工作于连续增/减计数模式，产生三角载波，载波频率为3000Hz，载波比N=60，因此调制波形正弦波的频率为50Hz。本实验中，调制度为0.8。-F2812 generating SPWM wave. EVA work under the general-purpose timer T1 in a row up/down counting mode, resulting in triangular carrier, the
CFFT
- 在CCS环境下，调用TI的DSPLIB FFT、IFFT函数的例子。 定义了正弦信号和方波信号，可以帮助DSP初学者理解DSPLIB FFT相关函数的调用。-In the CCS environment, calling TI DSPLIB FFT, IFFT function example. Defines a sinusoidal signal and the square wave signal that can help beginners understand DSPLIB FF
PWM
- DSP2407用C写的PWM波发生程序，验证过-DSP2407 use C to write the PWM wave occurred in procedures, verified
special
- 波形发生说明主要是正弦波发生的发生过程，原理，还有DSP为什么没有直接源代码来产生该波形-Waveform is a sine wave occurred in the main occurred during, principle, and why there is no direct DSP source code to generate the waveform
sinewave_c
- 在ccs上使用定时器实现一个数字震荡器的代码.产生的是正弦波波形。-Ccs use in the realization of a digital timer oscillator code. Sinusoidal waveform is generated.
zhengxianbofashengqi
- C环境下的DSP中正弦波发生器功能的实现，程序运行稳定正常，无出错（实验测试程序）。-C environment in the sine wave generator of the DSP function of the realization of stability in the normal program to run without errors (experimental test procedures).
PMSM
- 本文以三相正弦波驱动的永磁同步电机(PMSM)为研究对象，在深入分析其内在电磁约束关系的基础上，给出了不同坐标系下的运动方程，根据其数学模型，确定了电动车用电机在旋转坐标系下的矢量控制方案。控制系统为电流环和速度环的双闭环系统-In this paper, three-phase sine-wave-driven permanent magnet synchronous motor (PMSM) for the study, in-depth analysis of its intrinsic
SpiDac
- TM320F2812与TLV5614 DAC芯片通信并输出正弦波的示例程序，该程序在交大TI实验室自制的评估板上运行通过，使用需配合TI官方的库文件。-TM320F2812 with the TLV5614 DAC chip communication and the output sine wave sample program in the National Chiao Tung University Laboratory TI evaluation board made to run th
dsp
- 设计用DSP产生正弦波，用到了C54X的DSP处理软件，最终能产生正弦波-Sine wave generated by DSP design, the DSP used in the C54X-processing software, and ultimately to produce sinusoidal
pwm(10-4)
- DSPF2812学习程序： 利用GP定时器1的比较器在产生一路PWM波，外设时钟25M,同时用全比较器产生3对PWM波，GP定时器1作全比较单元时基,适于初学者学习-DSPF2812 learning process: the use of GP Timer 1 compare the way in generating PWM wave devices, peripherals clock 25M, at the same time compared with full-generate th
ccs-Sinewavegenerator
- 应用具体的DSP架构，在CCS中实现正弦波发生器，能给初学者带来很大的帮助。-Application specific DSP architecture is implemented in the CCS sine wave generator, can give great help for beginners.
tone
- This example uses the AIC23 codec module of the 6713 DSK Board Support Library to generate a 1KHz sine wave on the audio outputs for 5 seconds.The sine wave data is pre-calculated in an array called sinetable. The codec operates at 48KHz by default.
SPWM
- 在德州公司DSP lf2407上输出spwm正玄波-In Texas, the company' s DSP lf2407 output spwm Shogen wave
pwm
- 在CCS环境下运行，能生成六路PWM波，其中每两路是互补的。-CCS environment, can generate six-channel PWM wave, in which the two are complementary.
sin-gen
- DSP中正弦发生器的设计方法，希望对大家有用-generate sin wave in DSP ,hope to help you