搜索资源列表
M190打印程序
- 本程序为M190微型打印机的程序,采用C语言和汇编混合编写,已经经过调试并在应用中-procedures for the M190 Micro Printer procedures, and use of C language compilation mixed preparation, and after debugging applications
TSC_TIAOMA
- TSC条码打印机在LINUX下的条码打印程序,需要24点阵字库支持.-TSC barcode printers in Linux barcode printing process, which takes 24 Dot Matrix font support.
ARM_EPSON_Driver
- 我写的基于NXP ARM7 的EPSON微型打印机驱动程序，其打印格式可根据自己的需要修改。此程序已成功用于一个比较大的项目。-I write NXP ARM7 based on the micro-EPSON printer driver, its print format according to their needs to be revised. This procedure has been successfully used for a relatively large projec
microprt
- 这是驱动出租车开票打印机的程序，特殊之处是在留有足够余量的情况下，提高了打印密度让一行打印更多的字符
epp
- HP1150/1160等系列的打印机 并口驱动程序 打印机语言是PCL5e
printer
- ARM7嵌入式开发的热敏打印机程序，可以满足广大嵌入式语言爱好者的兴趣。
CAN-BUS_PRINTER-0402
- CAN总线LPC1700打印机程序，周立功-can bus LPC1700 printer
927DirCom
- 9针打印机驱动程序 AVR源代码 包括字车马达 和走纸马达的驱动程序-9-pin printer driver AVR source code including the word car motor and paper feed motor driver
s7-200-program
- 西门子s7-200自由口发送数据程序，例如向打印机之类的设备通过RS232协议发送数据-Siemens s7-200 free port to send data procedures, such as the type of equipment to the printer via the RS232 protocol to send data
Teacup_Firmware-master
- 基于arduino电子平台的3D打印机的控制代码，将程序编译完成之后生成.hex文件烧写到arduino电路板的单片机中，即可控制3D打印机的运动。-Arduino based electronic platform 3D printer control code generated after completion of the program is compiled. Hex file programmed into the arduino microcontroller board, yo
printer
- 热敏打印机源码,基于51单片机，单片机微型打印机程序-Thermal printer source code, based on 51 single-chip microcomputer micro printer program