搜索资源列表
monichuankou
- 由于普通单片机只有一个串口,由于用户可能会用到多个串口,而对于双串口的单片机价格贵,不如自己动手选择两个IO口,自己模拟串口通讯,以下为模拟串口程序.
shilu_WUXIANMOKUAI.rar
- msp430f12x2+nrf905，双向无线串口通信程序，含模拟spi，串口超时判断,msp430f12x2+ nrf905, wireless two-way serial communication procedures, including simulated spi, serial time-out to determine
mn
- 模拟串口8位数码管显示时钟程序 模拟串口8位数码管显示时钟程序-Serial 8-bit analog digital tube display clock program to simulate serial port 8-bit digital tube display clock program
serialport2
- 用 52 模拟SPI串口接受程序，然后控制无线模块发送出去！饱含nrf2401的初始化！-SPI serial interface with 52 analog acceptance procedure, and then control the wireless module to send out! Full of nrf2401 initialization!
SampleAppSlave
- CC2430的A/D转换测试程序。程序基于IAR软件编写的。通过A/D通道采集模拟量并转化为数字信号，然后通过串口发送到PC，在PC机可以看到采样结果。估计对开发无线传感器网络的相关人士比较重要-the A/D converter test procedure. Procedures prepared based on the IAR software. Through the A/D channel analog acquisition and digital signal
at24c64
- AT24C64串行读写程序 用普通I/O口进行总线模拟-AT24C64 serial reading and writing program with the ordinary I/O port for bus simulation
PIC-MCU-simulated-UART-
- 单片机串口模拟程序，适用于单片机串口不够用情况下，仅供参考-Microcontroller serial simulation program for the microcontroller serial port is not enough under the circumstances, for reference only
MSP430F149_complex
- 基于MSP430F149的综合通讯程序，目的是通过ADC采集传感器的输出，经标定算法最后通过串口232与上位机通信，以及DAC7512的模拟电压控制输出。代码调试通过，包含以上所有功能，适合做430单片机采集程序的框架-MSP430F149-based integrated communications program, the purpose is the acquisition of the sensor output by an ADC, the calibration algorithm
serial-program
- 基于cc2430的串口模拟程序，可以解决串口不够用的问题。-Cc2430-based serial simulation program, we can solve the problems of the serial port is not enough.
SN8P2501-i2c
- SN8P2501编写的模拟i2c和模拟串口通信的ASM程序-SN8P2501 prepared and analog simulation i2c serial communication ASM program
code
- 基于ARDUINO平台将超声波采集的模拟信号转换成数字信息，然后利用串口通讯将数据（8位二进制）传送至PC端，利用相应的程序进行处理即可，本程序经调试已成功使用。-Arduino based development platform, analog data acquisition ultrasonic sensor converts the digital signal, and then sends the data through the serial port to the Pc sec