搜索资源列表
t1
- 在N=128时采用次优化迭代算法的PTS法与普通PTS法的PAPR性能比较。仿真参数：QPSK调制，V=4，P=4，取 。从程序的运行时间可知，采用次优化迭代算法，PTS法的复杂性可以大大降低。-In the N = 128 used sub-optimal iterative algorithm method and the general PTS PTS PAPR performance comparison method. Simulation parameters: QPSK modul
QPSK
- BER performance in QPSK modulation
tiaozhi
- 该程序为自编的一个关于模拟莱斯衰落信道的整个过程，包括信号的调制、经过莱斯信道和解调，最后经过计算误比特率得出莱斯信道的性能的好坏。-The program for the self-simulation of a Rician fading channel the entire process, including the signal modulation, channel, after Rice and demodulation, and finally calculated BER Ri
QPSK.simulation
- 高级信道ＱＰＳＫ的设计与仿真，改善了信道性能，对仿真数据可有效汇总，输出理想比现实比较曲线-Advanced Channel Design and Simulation of QPSK, the channel to improve performance, the simulation data can effectively aggregate, more than reality curve of the ideal output
PerformaceofQPSKandDQPSK
- Performance of QPSK and DQPSK in AWGN and Rayleigh Fading Channel. A detailed Report of the work done in the source code is also attached as another file
ProjectReport_PerformanceofQPSKandDQPSK
- Project Report on the performance of QPSK and DQPSK in AWGN and Rayleigh Fading Channel
DS_CDMA
- 这是一个相对完整的直接序列扩频码分多址的通信系统的仿真设计，包括编码，扩频调制，解调和解码等模块，并统括系统性能的仿真，验证了系统设计的可靠性。-This is a relatively complete direct sequence spread spectrum CDMA communications system simulation design, including coding, spread spectrum modulation, demodulation and decodi
STBC_MIMO_code
- 本代码是关于多天线技术空时块编码的通信系统仿真源程序，其中包括QPSK调制，QPSK解调，FFT,IFFT，STBC等模块,并给出误码率计算和性能仿真图。-The code is on the multi-antenna space-time block coding techniques of communication system simulation source code, including QPSK modulation, QPSK demodulation, FFT, IFFT,
QPSK.LLR
- illustrates the improvement in BER performance when using log-likelihood instead of hard decision demodulation in a convolutionally coded communication link-illustrates the improvement in BER performance when using log-likelihood instead of hard d
QPSK
- QPSK,BPSK,PSK simulation for BER performance-QPSK,BPSK,PSK simulation for BER performance
QPSK
- 存在多径的OPSK传输性能仿真。可以绘出不同信噪比下的误码率曲线图-The OPSK multipath transmission performance simulation. Can draw different SNR BER curves
Conv-OFDM-QPSK
- 512FFTOFDM系统仿真，包含卷积码和QPSK调制解调-BER performance simulation of 512 OFDM system, including convolutional code and QPSK
qpsk
- Qpsk的性能仿真，此处用matlab语言编写-Qpsk performance simulation, matlab language used here
QPSK
- 轻武器权限申请程序等外侧段v二大王我我的2的1我-In cognitive radio networks, power control is considered as an important issue to improve the performance of dynamic spectrum sharing. In this paper, in order to maximize the efficiency of the system, the secondary users and
QPSK_AWGN
- 本代码为matlab编写，编程实现信号经过QPSK调制后，再经过AWGN信道下，得到的误码率性能曲线，并且与理论上的误码率进行对比。-The matlab code is written in programming through the QPSK modulation signal, and then through the AWGN channel, the resulting bit error rate performance curve, and with the theoretic
ofdmand-Qpsk-cp-of-ofdm
- 比较OFDM调制系统和常见的QPSK的性能，再者，通过分析不同的循环前缀，对系统性能的影响。-Comparing OFDM modulation system with common QPSK of performance, Furthermore, through the analysis of different cyclic prefix, the impact on system performance.
qpsk
- 一个有关qpsk的调制。系统的性能仿真。-1. system diagram 2. Input baseband waveform and its power spectrum 3. QPSK modulated signal and its power spectrum 4. AWGN channel output and its power spectrum 5. Signal constellations before and after the Rayleigh
QPSK
- OnPerformanceLimitsofDFTSpreadOFDMSystems DFT Spread OFDM has been proposed recently to reduce the Peak to Average Power Ratio (PAPR) of conventional OFDM transmission. Besides PAPR reduction, an important implication of DFT Spreading is that the ind
QPSK误码率分析
- 此程序是用于QPSK误码率分析，在matlab中写入此程序，进而用matlab画出误码率的图形，然后可以分析其性能。(This program is used to analyze QPSK error rate, write the program in MATLAB, and then draw the bit error rate with MATLAB, and then analyze its performance.)
QPSK Rayleigh
- 仿真瑞利信道下 QPSK 调制的误码率性能(BER performance of QPSK modulation under Rayleigh fading channel)