搜索资源列表
BC_Capacity_igICI
- Zero-forcing (or Null-Steering) precoding is a spatial signal processing by which the multiple antenna transmitter can null multiuser interference signals in wireless communications
Ber-with-matched-filtering
- 用匹配滤波实现误比特率曲线。在发射端使用脉冲成型，在接收端使用匹配滤波所构成的最佳接收机。-optimal receiver structure when pulse shaping is used at the transmitter，The receiver structure is also called as matched filter.
sysgen
- matlab/simulink编程，基于SFF SDR平台的软件无线电发射接收机设计，模块设计，对学习小型软件无线电平台开发有很大帮助。-matlab/simulink programming, software platform based on SFF SDR radio transmitter receiver design, module design, small learning software radio platform helps a lot.
16F88--10-CHANNEL-ENCODER
- 使用16 f877,即使是一个简单的操纵杆发射机操纵PCB设计不同的控制器-The use of 16 F877, even a simple joystick transmitter steering controller design of PCB
MIMO
- MIMO 系统利用功率注水分配算法仿真发射端知道CSI的情况-MIMO system uses water power allocation algorithm simulation transmitter know the situation of CSI
DSB_LC_MODEM
- This simulink model of Double-sideband full carrier/Conventional AM transmitter.-This is simulink model of Double-sideband full carrier/Conventional AM transmitter.
prog6
- Code division multiple access (CDMA) is a channel access method used by various radio communication technologies. CDMA is an example of multiple access, which is where several transmitters can send information simultaneously over a single communicati
zhuantaiISAR
- 本程序用于对三维转台目标进行ISAR成像（发射LFM信号，stretch处理）-This program is used for three-dimensional turntable targets ISAR imaging (LFM signal transmitter, stretch processing)
ZigBeeIEEE
- The implementation was built on Matlab/Simulink using fundamental components in Simulink to demonstrate how reliably complex modulation schemes can be built, cost effectively and efficiently [5]. The design of ZigBee transmitter using MSK mod
fangfang
- 为了最大限度地减少能源采集充电通信系统传输完成时间，各 传输调度方案已被提出。然而，他们并没有考虑这个问题，其中一个发射器可能会失败 之前完成传输。为广播与能量收集解决这个问题，传输调度 切换发射器进行了研究。在广播通信系统中包括两个发射器和两个用户。该 发射器获取能量和独立工作交替进行。传输调度问题转化为 最小化传输的完成时间，在能量的因果关系的约束，数据传输的限制，而 发射器的开关约束。发射器的开关被证明发射机不应该停止传输解决 之前切换到其他发射器
cdma2c
- CDMA Simulation for N Transmitter/Receiver Pairs data bit stream for each sender -CDMA Simulation for N Transmitter/Receiver Pairs data bit stream for each sender
MMSE_detection_2x2
- detection MMSE MIMO using number transmitter 2 and receiver 2
ieee_tx11ac
- IEEE 802.11ac的发送端代码，用matlab生成，包含发送端的所有模块，至RF前端-IEEE 802.11ac transmitter matlab code
my_dssss
- this file simulate Direct Sequence Spread Spectrum Transmitter/Receiver systems With Time-Synchronization
relay
- 认知中继网络包括一个主用户发射机和接收机，一个次用户发射机和接收机，以及一个放大转发中继。次用户发射机和中继从自然界获取能量。次用户共享主用户的频带进行数据传送，中继放大转发主用户发射机和次用户发射机的信号。次用户发射机和中继根据获取的能量和数据传送要求控制发射功率。功率控制建模为在能量因果约束、-Cognitive relay network includes a primary user transmitter and receiver, a secondary user transmitt
OSTBC
- This a matlab code for OSTBC transmitter and receiver-This is a matlab code for OSTBC transmitter and receiver
coding
- 1 transmitter 1 receiver rician channel gui
OFDM_UWB
- 仿真了OFDM_UWB系统，调制方式采用QPSK，参数设置完全符合FCC标准-Simulation of a transmitter implementing the OFDM transmission chain with QPSK modulation on each sub-carrier
alamouti2x2
- Many papers have extended STBC design to frequency-selective channels. In [6], STBC has been proposed for single-carrier transmission, which can achieve maximum space-delay diversity in rich scattering channels. The transmission formats proposed
final
- Due to the increased demand of wireless communication systems because of the features of the system which provides a wide coverage, high throughput and reliable services, the MIMO systems communication has come into existence. Features provided by th