搜索资源列表
adc-stm32f407
- adc initialize stm32f407 ARM-adc initialize stm32f407 ARM
uart-stm32f407
- uart initialize for stm32f407
timer5-stm32f407
- timer5 initialize for stm32f407
adcadac-stm32f407
- adc an dac for stm32f407
ADC
- STM32F4的ADC程序,可直接编译下载-The ADC program of STM32F407
IRRemoteControl_Test
- 在keile5下编译的程序,利用STM32F407最小系统做了一个通过红外遥控控制继电器通断,从而实现无线控制台灯的开关(继电器接上台灯)-Under the keile5 compilation procedures, using STM32F407 minimum system made a through infrared remote control relay on and off, so as to realize the switch of wireless control des
DHT11_Test
- 在keile5下编译,采用STM32F407作为最小系统编写的一个关于温湿度传感器的驱动编写,可以正确的读取温、湿度到LCD屏幕上。-In compilation, under keile5 STM32F407 as minimum system written in a drive to write about temperature and humidity, temperature and humidity can be read correctly on the LCD screen.
STM32F407---printf-----keil5
- 该源码公示了怎样使用STM32F407的串口进行收发数据,在keil5编译环境中进行编译。需要将STM32F407的串口1与USB串口相连,即可以实现电脑桌面串口调试助手的调试。-The source of the public how to use STM32F407 serial port to send and receive data, compiled in keil5 compilation environment. We need STM32F407 serial port 1 i
MPU6000(SPI)
- 通过SPI实现MPU6000与STM32F407之间的数据采集与显示-Realization of data acquisition and display between STM32F407 and MPU6000 by SPI
subbcript
- STM32F407 例程 触摸屏 touch screen-STM32F407 routine touch screen touch screen
Sam18UCOSIIITest
- STM32f407 移植UCOSIII,确保正确,使用MDK512编译-STM32f407 u79FB u690DUCOSIII uFF0C u786E u4FDD u6B63 u786E uFF0C u4F7F u7528MDK512 u7F16 u8BD1
实验1 跑马灯实验
- 在stm32f407中利用库函数方法编程写的跑马灯实验例程。(Written using marquee experiment routines programming library function method in stm32f407.)
V0.2
- 可以通过串口1发送指令控制4个IO口,以实现小车8个方向的行驶,带差速转弯功能(You can control 4 IO ports by sending 1 commands through the serial port, so that the car can drive in 8 directions, with differential turn function.)
USB-IIC
- 使用labview对其进行上位机编程,使STM32F407能够与IIC进行通信的通用程序(Using LabVIEW to program the host computer and enable STM32F407 to communicate with IIC.)
USB-CAN
- 使用labview对其进行上位机编程,使STM32F407能够与CAN进行通信的通用程序(Using LabVIEW to program the host computer and enable STM32F407 to communicate with CAN.)