搜索资源列表
dpjbjdj
- 基于 AT89C52单片机的步进电机控制系统设计。可以通过键盘输入相关数据 , 并根据需要 , 实时对步进电机工作方式进行设置 , 具有实时性和交互性的特点。-AT89C52 microcontroller based stepper motor control system design. Through the keyboard input data and in accordance with the needs of real-time work on the stepper motor
A_Brushless_DC_Motor_Speed_Control_System_Using_Fu
- 应用模糊逻辑对直流电机转速进行控制-using the fuzzy logic to control the vitess of the motor
PID
- 用于电机控制的PID程序，经过测试，大家在设计中可以参考-PID motor control for the procedure, tested and we can refer to in the design
pwm
- 直流电机驱动芯片采用Ｌ２９８．支流电机驱动就是利用ＰＷＭ脉宽控制Ｌ２９８电流输出大小，从而达到控制电机的目的-Motor Driver IC using L298. Tributaries is the use of motor-driven PWM pulse width control L298 current output size, so as to achieve the purpose of the electrical control-DC motor driver chip L2
sourceprogram
- 篮球计时器，键盘扫描，步进电机的控制，交通灯，及其温度计-Basketball timer, keyboard scanning, stepping motor control, traffic lights, and the thermometer
Fuzzy_PID_Control_of_Stepping_Motor
- 摘要:由于步进电动机调速系统具有非线性等特点,使得利用简单模糊控制与传统PID控制精度不高,因此文中提出利用模 糊PID控制器实现对步进电动机调速系统进行控制的方法,并设计了模糊PID控制器。文中首先建立了步进电动机的数学 模型,并根据数学模型推导了其传递函数 然后介绍了模糊PID控制器结构,以及模糊控制规则的生成方法,并且对该控制 方案进行数字仿真。仿真结果表明:该方法调节精度较高,动态响应快,无超调,有一定的可行性。 -Abstract: As the stepper mot
全自动可遥控旗帜升降系统
- 全自动可遥控旗帜升降系统以AVR单片机为核心，由PWM对电机进行变频调速，高精度光电编码器测速，闭环式电路控制。能够利用按键输入相应的指令控制旗帜的升降，还可以实现在特定位置停留的功能。利用LCD可以显示旗帜的实时高度和相应的控制命令，用LED指示旗帜是否处于半旗状态，具有语音提示报警功能，并可利用无线模块实现遥控功能，准确均匀地实现旗帜的升降。-Fully automatic remote control system to lift the banner of AVR microcontro
pundulum1
- 单级倒立摆的稳定控制，实际上是一单输入多输出系统的稳定控制。此时系统输入是电机控制电压u，输出是倒立摆竖直方向角度 和旋臂位置 。对方程(2.5)进行变形即得 与u 之间的输入输出方程,很明显,它是一个不稳定的二阶系统-Single inverted pendulum stability control, is actually a single-input multiple-output system stability control. At this point the system is
adm325
- 控制小车用pwm方式来控制小车的转速，小车的步进电机需要用直流电机控制，因为单片机产生的电流小-Control pwm to control the car with the car' s speed, the car of the stepper motor DC motor control needed because the current generated by small SCM
motor
- 51系列单片机驱动步进电机控制系统电路及程序-51 series stepper motor drive circuit and program control system
masscalar
- this file contain the scalar control of the induction motor
73462674kaihuan1
- dc motor spped control
step
- 基于89C51单片机的四相六线步进电机控制系统，可以按键实现电机的起停，正反转及三级速度控制，并有led灯指示-89C51 microcontroller based four-phase six-step motor control system that can achieve the motor start and stop buttons, Reversible, and three speed control and have led indicator light
bi huan shen jiang tai
- 无线遥控的速度稳定的直流电机升降机电路原理图及电路板图（DXP2004版）-Wireless remote control DC motor speed stability and lift the circuit board schematic diagram (DXP2004 Edition)
DoubleLoopDCSpeedControlSystemSimulation
- 本文说明了双闭环直流调速系统仿真设计，详细地介绍了基于Matlab的仿真过程。-This article describes the two-loop DC motor control system based design, detailed descr iption of the simulation based on Matlab.
control
- control of ac and dc motor using fussy logic-control of ac and dc motor using fussy logic
Kalman
- The Extended kalman filter (EKF) has been found wide application in the sensorless control of induction motor (IM) because of its good steady and dynamic behaviour,disturbance resistance, and fast convergence. This paper presents a novel speed sensor
PWM
- 关于各种电机的PWM程序： 工程1，采用C语言完成的主要功能有 1：用定时器1中断让LED闪烁； 2：用定时器2的比较单元产生一路PWM； 3：用EVB模块产生6路PWM； 另外四个汇编程序依次分别是： SVPWM（软件法）程序， 交流异步矢量程序， 直流双极性双闭环可逆控制程序， 和采样SPWM程序。 -PWM motor on a variety of programs: Project 1, using C language to complet
A040103C
- Backstepping Control based on Lyapunov Theory for Sensorless Induction Motor with Sliding Mode Observer
ARM
- 设计一个电动机控制器，两台电动机的控制要求为：当按键k1按下后，第1台电动机运转5s后停止，切换到第2台电动机运转，10s后第2台电动机自动停止运转。-Design a motor controller, two motor control requirements: When the button is pressed k1, 1 5s electric motor stops running, switch to 2 motors running, 10s after the first 2