搜索资源列表
xapp460
- xilinx hdmi tx rx verilog code datasheet
3.5GHz--channel-measurements
- 在3.49-3.51GHZ频段内的典型中国城市环境下，地面信号衰落仍服从经典的指数对数分布。在中度误差（σx =10.291）下，路损指数在3.1-3.7之间。半径2公里的小区内，RMS时延在3-4微秒之间；典型的办公室环境中，存在直达径时RMS时延小于0.1微秒。在城市环境中，多径现象很明显，主要由高层建筑物引起，并以簇的方式存在。在城市中低速移动条件下（接收机移动速度小于100 Km/h）某一强径的生存时间通常超过10分钟，但相对到达时间会发生滑动。单一小区内的传播环境具有一定相关性，如果存
qpsk-tx-rx
- qpsk transmitter a receiver, in design to simulink with AWGN,noise.
dqpsk-tx-rx
- DQPSK, design of an transmitter and and receiver with AWGN, noise.
ESART-RX-TX
- ESART 发送接收测试，芯片为PIC16F690-ESART sending and receiving test chip PIC16F690
TDA7210V_RC_RxBoard_v1.1
- TDA7210 RX and TX design package, with RX and TX PCB gerber file and source code for the RX PCB
comport-new
- this is rs232 reading data from gsm with rx tx
jesd204b
- 高速Serdes接口协议规范，包括电器层，传输层，数据链路层。传输层包括组帧方式，加扰，字节替换等内容，数据链路层包括Tx和Rx设备的握手通信协议-Speed Serdes interface protocol specifications, including electrical layer, transport layer, data link layer. Transport layer including group frame mode, scrambli
16F628A-TX-RX
- rs 232 with pic source code
DisplayPort_RX_and_TX_Desgin_Example_AN_r1
- displayport tx rx design 1920x1080
SinhVienIT.Net--IDMP6.21PBuildP11PFullP
- Here s the result. After few seconds of displaying the Powered by FreeRTOS message, the demo will now display the status of all tasks. If there s no error occurred, it will show PASS and the jitter in the processing of timer interrupt (timertest.c).
TOUCH-IC-GRM810NS_0B
- 格瑞达触摸芯片GRM810NS_0B： − 最多可支持10个触摸按键； − 采用公司自主TX/RX协议，支持组合键； − 支持单键或者连续键 − NSOP16封装 广泛应用于电磁炉、油烟机、热水器、电水壶、面包机、压力锅、电子门锁等小家电-Ge Ruida touch chip GRM810NS_0B: - Supports up to 10 touch keys - Using the company s independe
TOUCH-IC-GRM810S_14
- 格瑞达触摸芯片GRM810S_14： − 最多可支持14个触摸按键； − 采用公司自主TX/RX，支持组合键； − 支持单键或者连续键 − SOP20封装 广泛应用于电磁炉、油烟机、热水器、电水壶、面包机、压力锅、触摸开关、电子门锁、触摸遥控器等小家电-Ge Ruida touch chip GRM810S_14: - Supports up to 14 touch keys - Using the company
serial-guilherme
- PIC 16F877A UART SERIAL RS232 COM COMANDO TX E RX
include1
- Circuit connections of this project are very simple. Bluetooth module’s Rx and Tx pins are directly connected to the Tx and Rx pins of Microcontroller. Three 5 volt relays are used as a switch for turning On and Off the home appliances running on AC
Realterm_2.0.0.70_Signed_Wrapper_setup
- arduino terminal rx tx send recive