搜索资源列表
increase_of_voltage_stability_and_power_limit_usi
- increaseof voltage stability and power limit using svc
SR_thesis
- On-line voltage stability assessment of power system
Wide-Area-Stability-and-Voltage-Control
- Wide-Area Stability and Voltage Control
Evaluating-Advanced-VAR-Compensators-for
- Evaluating Advanced VAR Compensators for Improving Power System Voltage Stability
svc
- svc，静态电压补偿器，属于一个典型的电压稳定程序，pscad模型-it is svc,uesd for the compentation of voltage,it is a starded model of stability of voltage.
pundulum1
- 单级倒立摆的稳定控制，实际上是一单输入多输出系统的稳定控制。此时系统输入是电机控制电压u，输出是倒立摆竖直方向角度 和旋臂位置 。对方程(2.5)进行变形即得 与u 之间的输入输出方程,很明显,它是一个不稳定的二阶系统-Single inverted pendulum stability control, is actually a single-input multiple-output system stability control. At this point the system is
181336261208
- 可变增益放大器是模拟单元电路之一,起着变化增益、调整信号动态范围、稳定信号功率的作用。文章综述了CMOS集成可变增益放大器的研究情况 给出了可变增益放大器的定义、应用、分类和主要指标,描述了多种开环和闭环放大器的结构,分析了相应的增益控制方法及其优缺点 说明了在CMOS工艺下实现放大器增益按指数变化的几种途径。最后,介绍了用于无线数字通信,具有宽带、高线性、低电源电压等高性能可变增益放大器的设计实例。-Variable gain amplifier circuit of the analog u
BASIC-CONTROL-OF-UNIFIED-
- UPFC中间直流电容上电压控制的重要性 论文在传统 PID控制的基础上 设计模糊自适应 PID控制策略 控制方案能有效地提高直流电容上电压的稳定性 改善功率波形 取得了类似扩大电容容量后的效果 -UPFC DC capacitor voltage control among the importance of paper in the traditional PID control based on fuzzy adaptive PID control strategy designed con
Inverter-
- ：电流滞环控制具有易于实现、快速的动态响应和无条 件稳定等优点，但该控制方法使逆变器的开关频率不固定， 造成逆变器输出滤波器设计困难，因此很少有文献提及此种 滤波器的设计方法。该文研究了一种基于电流滞环控制的半 桥双降压式逆变器输出滤波器的设计方法。该方法从短路特 性和稳压精度两方面阐述了如何最优选取滤波电感，从谐振 频率和无功补偿两方面阐述了如何最优选取滤波电容-Hysteresis current control method has the characters
Static-Voltage-Stability--Enhancement
- power point for Static Voltage Stability Enhancement, it highly useful for the stability check. -power point for Static Voltage Stability Enhancement, it highly useful for the stability check.
Tuned-statcom-for-voltage-control-a-reactive-powe
- In this paper Static Synchronous Compensator (STATCOM) is used for voltage stability and the compensation of reactive power. The STATCOM contains an Insulated Gate Bipolar Transistor (IGBT) based voltage source converter for voltage control a
05721647
- The Static Bifurcation Analysis Of STATCOM On Power System Voltage Stability
LC
- 本系统是以FPGA（EP2C8Q240C8）为控制核心，由压控振荡器、PLL倍频器、高频功率放大器、遥控器及LCD显示模块组成的压控LC振荡器。能实现输出正弦波频率在15MHZ~35MHZ步进可调，其最小步进为5002HZ，频率稳定度为10-5。当输出信号的频率为30MHZ、峰峰值稳定在1V左右时，在+12V单电源工作的情况下，功率放大器能实现在50Ω纯阻性和50Ω+20pf容性负载上输出功率大于20mw。LCD显示模块能实时显示输出信号的峰峰值和频率，精度由于10 。-This system
Case-studies
- 风电场建模的案例分析。资料中详细分析了风电场建模的方法，并着重考虑了短路电流、LVRT、稳定性分析等内容。- Using an actual wind farm configuration, this paper compares the effects of modeling detail on power flow calculations such as those used to determine reactive power requirements, voltag
Voltage-Stability-Toolbox-for-Power-System
- IEEE TRANSACTIONS ON EDUCATION, VOL. 49, NO. 4, NOVEMBER 2006 Saffet Ayasun, Member, IEEE, Chika O. Nwankpa, Senior Member, IEEE, and Harry G. Kwatny, Life Fellow, IEEE Education and Research on Voltage Stability Toolbox
zhixiankongzai
- 测试直线电机的空载电压，将220sqrt（2）v峰值电压输入，通过星形连接，转为220v相电压，进入直线电机，验证其稳定性-The no-load voltage test of linear motor, 220sqrt (2) V peak voltage input, through the star connection, to enter the 220V phase voltage, linear motor, verify its stability!!
transient-stability-psasp7.1
- PSASP7.1暂态稳定电压功能描述,具体功能描述-PSASP7.1 transient voltage stability function descr iption, descr iption of the specific function
STATCOMfuzzy
- This paper deals with the design and implementation of a multilevel voltage source converter based static synchronous compensator (STATCOM) employing an effective modulation control technique simulated in a MATLAB Simulink environment. The ma