搜索资源列表
Automatic landing system can be remote control led bannerd
- 全自动可遥控旗帜升降系统以AVR单片机为核心，由PWM对电机进行变频调速，高精度光电编码器测速，闭环式电路控制。能够利用按键输入相应的指令控制旗帜的升降，还可以实现在特定位置停留的功能。利用LCD可以显示旗帜的实时高度和相应的控制命令，用LED指示旗帜是否处于半旗状态，具有语音提示报警功能，并可利用无线模块实现遥控功能，准确均匀地实现旗帜的升降-Automatic landing system can be remote-controlled flag to AVR microcontrolle
STM8s_LED
- ST—LINKIII三合一：一个ADC电压采集，并把采集值赋给定时器，实现定时器PWM的变化输出，驱动LED亮度发生变化的程序-ST-LINKIII three-in-one: A voltage ADC acquisition, and acquisition value assigned to the timer, PWM timer to achieve the changes in output, driven LED brightness changes in procedures
pwm
- PWM 3色全彩LED控制，使用7219辅助调试，手动变色，每色7档。-PWM 3-color full-color LED control, the use of 7219 secondary debugging, manual color, each color 7 files.
Linuxexample
- 完成A/D测试代码，LED测试代码及PWM 测试代码-Complete A/D test code, LED PWM test code and test code
example8
- 基于NIOS_嵌入式软核处理器研究，实现宽度可变的PWM波，通过LED显示-Embedded soft core processor based on NIOS_ research, to achieve variable width of PWM wave, through the LED display
PWM
- 关于各种电机的PWM程序： 工程1，采用C语言完成的主要功能有 1：用定时器1中断让LED闪烁； 2：用定时器2的比较单元产生一路PWM； 3：用EVB模块产生6路PWM； 另外四个汇编程序依次分别是： SVPWM（软件法）程序， 交流异步矢量程序， 直流双极性双闭环可逆控制程序， 和采样SPWM程序。 -PWM motor on a variety of programs: Project 1, using C language to complet
T6322A
- 是一款降压型LED恒流驱动IC，SOT23-6封装，，输入电压为5到38V，输出电流最大为1A，效率高达97 ，含有PWM调光功能。主用在12V/24V LED MR16恒流板，LED手电筒板，LED背光驱动等等产品上-A buck type constant current LED driver IC, SOT23-6 package, input voltage of 5 to 38V, output current up to 1A, efficiency up to 97 , with
zsj2buzzer
- 修改S3C2410bios源程序。添加按键控制LED和按键控制蜂鸣器PWM程序-Modify the S3C2410bios source. Add button control PWM control buzzer LED and button
PWM
- MCU的pwm波形输出可以实现led调光的智能驱动-Intelligent drive the MCU the pwm waveform output can be achieved led dimming
pwm
- 设置亮度值的增加和减少键，进行LED的亮度10级控制。-Set the luminance values of the increase and decrease of the key, and the brightness of the LED 10 control.
123556
- LED调光灯 要求：用1个白光高亮LED灯为发光器件、5V电源供电，实现PWM方式的16级调光，采用3个按键进行开关和亮度调节，要求亮度设置存储到芯片。 -The LED dimming lights Requirements: a white bright LED lights for the light-emitting device, 5V power supply, 16 dimming PWM mode, 3 button switch and brightness adjus
weijiyuanli
- 本次课程设计利用软件定时方式采用Intel 8255A可编程外设接口芯片唐都TD-PITC 实验系统上模拟直流电动机闭环调速系统，A/D转换器实现模拟信号到数字信号的转换，设置电机转速的给定值，通过PWM方式可实现电机转速的调节，LED灯显示电机转速的大小状态。-The curriculum design using software timing mode analog closed-loop DC motor speed control system on the Intel 8255A p
PWM
- PWM方式控制发光二极管的亮度 说明： 按钮控制PWM输出，使P4.1的发光二极管（数码管的b段），由亮到灭分为8级控制，一个 按钮增加亮度，另外一个减少亮度,数码管显示亮度等级,P1.0 控制变亮，P1.1控制变暗. - PWM mode control the brightness of the light emitting diode Descr iption: button control PWM output, make P4.1 led (light emittin
TIAOGUANG
- 实现按键控制当单片机PWM实现分100级手动调光 采用恒流源给LED供电，单片机控制恒流源大小。-Achieved with control buttons when the microcontroller PWM to achieve sub-100 manual dimming Using constant current source to the LED power supply, microprocessor control constant current source si
Marta
- PWm, atmega8, 3xled, swiches witch led indicator
LED
- 430g2553控制4路pwm输出：rgbw，配合安卓应用进行led调光，手机界面有色环，控制led颜色-msp430g2553 to output pwm wave
25W-LED-DRIVER
- 25 WATTS LED DRIVER BASED ON PWM IC
TRANSFORMER-FINAL
- TRANSFORMER DESIGN FOR 25 WATTS LED DRIVER USING PWM IC
led
- 灯板串联PCB图纸.用51单片机进行PWM调光控制-Lamp plate series PCB drawing，With 51 MCU PWM dimming control
drone.tar
- source code for led pwm used in drone