搜索资源列表
ATT7028
- 三相电能量计量芯片ATT7028的驱动程序。C51源程序，Keil C51编译环境，已验证通过。-three-phase electric energy metering chip ATT7028 the driver. C51 source, Keil C51 compiler environment has verified through.
3wave
- 本程序主要用于三相电的仿真中,程序通过不同时间的中断控制,实现了类似三相电的波形,但是方波,外围电路通过波形处理,可实现三相电的波形发生器.
csl-82791-ffy.rar
- 一款完整的三相电能表源代码，使用ATT7026A作为计量芯片，包括红外和485通信，已形成产品。,A three-phase energy meter complete source code, use the chips ATT7026A as a measurement, including the infrared and 485 communications, has developed products.
dsp
- 三相电各参数分析及计算，检查是否符合国标。并有DSP相关的EMIF及MCBSP等部分代码。-Analysis and calculation of parameters of three-phase power, check for compliance with the national standard. And DSP related EMIF and MCBSP, part of the code.
msp430F437DEMO
- 基于TI430芯片的三相电表demo程序-TI430 chips based on the three-phase meters demo program
dianliubaohu
- 对三相电流进行检测，通过单片机程序，显示三相电流的不平衡保护。-Three-phase current detection, through the SCM process, showing three-phase current imbalance protection.
Phase
- proteus仿真的三相电的相序检测，对于学习peoteus有很大的帮助。-proteus simulation of three-phase electrical phase sequence detection
sanxiang
- 通过时三相三线有功电能表计算原理和接线方式的分析, 详细计算了接线回路不同故阵时求取真实电贡的补算系数, 并阐述了电童的补算方法。-The passage of three-phase three-wire active energy meter calculation principle and the connection mode of analysis, detailed calculations of the wiring circuit different when it is to
6
- 三相电压的整流到逆变，基本模型，可以参照设计，进行其他改造完善来适合自己程序的需要-Three-phase voltage of the rectifier to the inverter, the basic model, can refer to the design, improve the other transformation procedures to suit their needs
PowerMete
- ST 电能计量芯片 驱动程序, 此芯片可以用与单相电表和三相电表，可以给出有功，无功，视在，电压，电流等-STPM01 Driver
xiaogonglv
- 小功率电源的matlab仿真程序，实现三相电的转换-Low-power power supply matlab simulation program, to achieve three-phase power conversion
Three_phase_electrical_parameters_of_the_rapid_and
- 三相电参数的快速、高精度的检测算法,利用对称分量法、傅里叶变换-Three-phase electrical parameters of the rapid and high accuracy measuring algorithm, using symmetric component, Fourier transform
AT89S5db
- 基于AT89S52单片机的三相电度表研究.pdf
6801349
- 三相电相序判断和缺相判断 采用定时器中断-Three-phase power phase sequence and phase to determine the timer interrupt used to determine
dianya
- 电测仪表，三相交流电压表完整程序,我公司在热销的仪表-Electrical measuring instruments, three-phase AC voltage meter complete program, I-selling instrument in
sanxiangzhengliu
- 三相整流，将三相电整流为直流。 电力电子中一种重要的模块。 本方法是采用简单脉冲信号触发-三相整流，将三相电整流为直流
Multifunmeter
- 一款采用NEC方案做的三相电能表方案源代码-NEC program using a three-phase energy meter to do the program source code
Power-energy-measurement
- 测量三相电参数后使用C8051f单片机六路AD采样，实时计算三相电参数，以及电网频率-After the three-phase electrical parameters measured using the six-way AD sampling C8051f microcontroller, real-time three-phase electrical parameters calculated, and the grid frequency
pv_3xiang_pqcontrol
- 三相电逆变器及并网发电方法的控制模型仿真-Three-phase power inverter and the grid method of the control model simulation
STC15W401AS实现无刷无感电调控制程序和电路
- 本程序试验使用STC15W401AS-35I-SOP16<RMB1.6>来驱动航模用的无传感器无刷三相直流马达. 本程序参考自网上的代码(作者: 瑞生), 改良而来. 电路图见文件 "BLDC-V10-实验电路.pdf". 控制信号由P3.2输入正脉冲信号, 间隔5~20ms, 脉冲宽度1.000~1.610ms. 1.160ms开始启动, 1.610ms为最高速度, 分辨率为2us. 本程序仅仅是简单控制, 软件没有处理 过0延时3