搜索资源列表
PWM
- 凌阳的61开发板的两路pwm驱动
6.25-DSP-Pwm-QEP-LED
- DSP2812-PWM-QEP-LED本程序是通过L298P驱动电机，发生两路PWM,通过GPIO口逻辑控制电机转动方向，QEP电路读取电机转速和方向，定时器中断控制LED,非常适合初学者，每一步都写的非常简单，对照着书很容易就看得懂！
PWM驱动舵机机器人
- 基于STM32，通过两路PWM信号，控制机器人左右两轮来完成各种动作。
atmega16.rar
- atmega16 定时器1 两路 pwm交替输出 方法 可用来驱动半桥,atmega16 Timer a two-way alternating pwm output method can be used to drive the half-bridge
MPC82G516-PWM-drive-setpper-motor
- MPC82G516单片机使用内部硬件PWM方式128细分、256细分方式驱动步进电机的程序，电路简单，成本极底，两路PWM就可以控制一只单极性的步进电机了。-MPC82G516 microcontroller using an internal hardware PWM mode 128 segments, 256 sub-way drive stepper motor program, the circuit is simple, cost very end, two PWM can cont
hhhh
- 6路ADC检测、两路PWM输出、1602显示加proteus仿真-6-channel ADC testing, two-way PWM Output, 1602 Canadian proteus simulation shows
DSP-PWM
- DSP电机控制例程，输出两路PWM信号，控制电机正反转。-DSP motor control routine, the output two-way PWM signal to control the motor positive inversion.
TworoadPWMoccurred
- 实 验 名 称: 两路PWM发生器 实 验 功 能: 本单片机PWM信号主要用于舵机控制 PWM信号周期为20ms,正脉冲在0.5ms到2.5ms之间可调-Reality check name: two road PWM generator The real test chip can work: mainly used for steering gear control PWM signal For 20ms PWM signal cycles, pulse at 0.5 ms
PWM
- 用C8051F005单片机产生两路PWM波-output two PWM using C8051F005
PWM
- avrmega16 定时器1两路pwm波输出-avrmega16 Two Timer 1 pwm wave output
pwm
- c8051f330产生两路pwm波，打开定时器1处理。可以做为相关程序的模板-c8051f330 pwm
STC12C5A16S2two-loadPWM
- 用单片机输出两路PWM来控制直流电机的正反转，一般像小马达之类的，都可以，我已经调试成功！-Two PWM output with a microcontroller to control the DC motor rotating, generally as small motors and the like, can I have debugging success!
lianglu-pwm
- 飞思卡尔xs128的两路pwm输出的程序，方便单片机对电机正反转的控制-Freescale xs128 pwm output of two-way process, to facilitate the control of the microcontroller for motor reversing
PWM
- 采用STC89C52单片机的定时器以实现两路PWM波输出，占空比、频率可调-Microcontroller timer used to achieve STC89C52 two PWM wave output, duty cycle, frequency adjustable
stm32两路相位差180度PWM
- stm32高级定时器1产生两路相位差180度PWM，频率、占空比可调。(STM32 produces two phase difference 180 degree PWM)
Double PWM - state1
- 基于ＳＴＭ３２ＺＥＴ６的两路ＰＷＭ脉冲输出(Two way PWM pulse output based on STM32ZET6)
STM8S103F3P6产生两路互补PWM波配置
- 搞了两天，总算使用STM8S103F3P6最小化系统板的TIM1产生两路互补的PWM波，现拿出来分享一下。工程为IAR环境，寄存器配置。(For two days, we used the STM8S103F3P6 to minimize the TIM1 of the system board to produce two complementary PWM waves, and now to share it. The project is IAR environment, register
PWM
- 下位机通过串口将底层的2PWM占空比值发送给上位机，上位机将显示两路PWM的占空比(The lower computer sends the 2PWM duty ratio at the bottom to the upper computer through the serial port, and the upper computer will show the duty ratio of the two PWM.)
PWM
- 一种STM32F103控制的两路PWM输出，两个按键调节输出占空比。(A STM32F103 controlled two PWM output, two keys to adjust the duty cycle.)
STC12C5A60S2-两路PWM调制输出
- STC12C5A60S使用PCA输出两路PWM程序(STC12C5A60S uses PCA to output two PWM programs)