搜索资源列表
IIR低通数字滤波器设计
- 用冲激响应不变法和双线性变换法分别以Butterworth滤波器、切比雪夫Ⅰ型滤波器、切比雪夫Ⅱ型滤波器为原型设计IIR低通数字滤波器。
FIR.巴特沃斯滤波器C语言实现
- 巴特沃斯滤波器C语言实现，低通滤波器。IIR,Butterworth filter C language
IIR.rar
- IIR滤波器的实现，这是一个低通滤波器,在visualC++6.0上的软件上实现 ,The realization of IIR filter, this is a low-pass filter, in visualC++6.0 on the realization of software
IIR
- IIR数字低通滤波器，已在DSP试验箱上实现，希望能对大家有帮助-IIR digital low-pass filter has been implemented on the DSP Chambers, hoping to be helpful to everyone
FIR_pinlv[1]
- FIR滤波器， 设计一个线性相位有限冲激响应低通滤波器，使其满足如下指标：通带边界为2kHz，阻带边界为2.5kHz，通带波纹 =0.005，阻带波纹 =0.005，抽样率为10kHz。采用多尔夫-切比雪夫窗进行设计，进行频谱分析。-FIR filter, design a linear phase FIR low-pass filter to meet the following indicators: passband border to 2kHz, stopband border to 2
IIR
- IIR 数字滤波器设计：模拟低通巴特沃思滤波器、模拟低通切比雪夫1型滤波器、模拟低通切比雪夫2型滤波器、模拟椭圆低通滤波器-IIR Digital Filter Design: Analog low-pass Butterworth filter, analog low-pass Chebyshev Type 1 filter, analog low-pass Chebyshev type 2 filter, analog elliptical low-pass filter
FIRshiyan
- 利用双线性变换设计IIR滤波器（只介绍巴特沃斯数字低通滤波器的设计），首先要设计出满足指标要求的模拟滤波器的传递函数 ，然后由 通过双线性变换可得所要设计的IIR滤波器的系统函数 。-IIR filter design using bilinear transform (only introduced the Butterworth digital low-pass filter design), first designed to meet the index requirements of
LPF
- IIR低通滤波器，matlab与verilog程序完全对应-iir low pass filter matlab result fully match the verilog output.
iirh
- 利用IIR滤波器设计一个低通滤波器，能够分析到电力系统中的三次谐波，要求满足如下指标：截止频率150HZ，阻带衰减≥30db-IIR filter design using a low-pass filter, to analyze the power system in the third harmonic, the requirements to meet the following indicators: cut-off frequency 150HZ, stopband attenuat
IIR
- 利用MATLAB开发软件进行编程，实现了数字IIR低通滤波器的功能，程序直接可以运行！-Use MATLAB to develop software for programming, implementation of digital IIR low-pass filter function, the program can run directly!
IIR
- IIR数字低通滤波器的直接设计(最小均方法），讨论系统稳定性并将系统最小相位化-IIR digital filter direct designii
IIR
- 用双线性变换法设计IIR滤波器用,双线性设计法设计低通、带通和高通IIR数字滤波器的计算机程序。-Using bilinear transform IIR filter design
ex5
- FIR 及 IIR低通滤波器的设计以及 正弦信号滤波前后的频谱分析 （不同窗函数截断）-FIR and IIR filter design and low-pass filter before and after sinusoidal signal spectrum analysis (different window function truncated)
IIR
- 用双线性Z变换法设计IIR巴特沃思型数字低通滤波器，能够实现心电信号中随机噪声的去除。-Bilinear Z transform with the design of IIR Butterworth digital low-pass filter, ECG can be achieved in the removal of random noise.
IIRfilterdesign
- IIR滤波器设计 设计一个巴特沃思低通滤波器，其技术指标为：3dB带宽为，阻带截止频率为，阻带衰减大于30dB，采样间隔T=10us。-IIR filter design to design a Butterworth low-pass filter, its technical indicators: 3dB bandwidth, stopband cut-off frequency, stop-band attenuation greater than 30dB, sampling in
iir
- 设计一个低通数字滤波器，满足如下设计指标： 通带截止频率：0.2pi，通带波动：1dB 阻带截止频率：0.3pi，阻带衰减：15dB 要求：分别采用巴特沃斯、切比雪夫Ⅰ型、切比雪夫Ⅱ型和椭圆滤波器原型进行设 计，比较各种设计的阶数、实际阻带衰减，分析实验结果 -Design a low pass digital filters that meet the following design specifications: passband cutoff frequency:
IIR低通滤波器设计资料
- 是在设计过程中需要用到的一些函数，可以帮助设计。(The file is useful to eveone who will design the IIR exquipent,ang I hope It will take good luck for you !Thank you reading!)
IIR一阶低通滤波器
- matlab实现带通滤波，傅里叶变换，得到频域信号，带桶处理(Achieve band pass filter, Fourier transform, get frequency domain signal, with bucket processing.)
IIR低通滤波器
- IIR低通滤波器设计，用于和FIR滤波器对比。(IIR low pass filter design for comparison with FIR filter.)
滤波器设计
- FIR和IIR滤波器，低通，高通，带通，附带注释(FIR and IIR filter, low-pass, high-pass, band-pass, with comments)