搜索资源列表
MSP430PMG811
- MSP430下CO2传感器MG811的驱动，附带电路图-The drive file of MG811 on the platform of msp430
CO2
- 基于STM32F103RBT6的CO2传感器（MG811）测试程序，可用于测试传感器正常。-Based STM32F103RBT6 CO2 sensor (MG811) test procedures can be used to test the sensor normal.
CO2program
- ATMEGA88单片机下的MG811 CO2传感器采集程序-ATMEGA88 microcontroller MG811 CO2 sensor acquisition program
STC_MG811
- MG811模拟输出二氧化碳传感器模块与AD0809模数转换模块实现二氧化碳的数值采集与显示-MG811 carbon dioxide sensor module with analog output AD0809 analog-digital conversion module for carbon dioxide capture and display values
MG811
- STM32驱动1602程序，基本显示，用于单片机开发-STM32 Driver 1602 program, the basic display for microcontroller development
8051-programme
- 本專題是對於溫度、CO2設備來偵測，溫度、CO2經由熱敏電阻及MG811轉成電壓後，利用A/D 轉換電路將其訊號傳入8051，並顯示溫度、CO2濃度及設定值在LCD上，使其量測的溫度、CO2濃度數值大小能判斷目前狀態是理想，進而對其做加熱、冷卻及排氣的動作。-This topic is for temperature, CO2 equipment to detect temperature, CO2 via a thermistor and MG811 turn into a voltage,
jiaqanandCO2_detect
- 基本430F149的甲醛、CO2检测程序，采用MG811和MQ138两种传感器。-This project will detect the CO2 and jiaquan basis on MCU,this MCU is MSP430F 149.
cc2530
- 部分传感器在cc2530上的代码，包括dht11，gy30，mg811等-Part of the sensor on the cc2530 code
风机触摸屏程序
- 1.使用STM32F1芯片 2.使用MG5611采集大气压强 3.使用MG811采集二氧化碳浓度 4.支持LCD触摸屏触摸(1. use STM32F1 chip 2. use MG5611 to collect atmospheric pressure. 3. use MG811 to collect carbon dioxide concentration. 4. support LCD touch screen touch)